Pioneer GM-DX871 Manual

Pioneer Modtager GM-DX871

Læs gratis den danske manual til Pioneer GM-DX871 (34 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Pioneer GM-DX871, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/34

PIONEER CORPORATION

28-8, Honkomagome 2-chome, Bunkyo-ku,

Tokyo 113-0021, JAPAN

PIONEER ELECTRONICS (USA) INC.

P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.

TEL: (800) 421-1404

PIONEER EUROPE NV

Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/Belgique

TEL: (0) 3/570.05.11

PIONEER ELECTRONICS ASIACENTRE PTE. LTD.

2 Jalan Kilang Barat, #07-01, Singapore 159346

TEL: 65-6378-7888

PIONEER ELECTRONICS AUSTRALIA PTY. LTD.

5 Arco Lane, Heatherton, Victoria, 3202 Australia

TEL: (03) 9586-6300

PIONEER ELECTRONICS DE MÉXICO S.A. DE C.V.

Blvd.Manuel Ávila Camacho 138, 10 piso

Col.Lomas de Chapultepec, México, D.F. 11000

TEL: 52-55-9178-4270

FAX: 52-55-5202-3714

先公鋒股份有限司

台北區市內湖瑞光路407 8號樓

電話：886-(0)2-2657-3588

先公鋒電限子（）香港有司

香港九龍長沙灣道909 5號樓

電話：852-2848-6488

Before you start

English

Français

CLASS D MONO AMPLIFIER

AMPLIFICATEUR MONO DE CLASSE D

GM-D8701

GM-DX871

GM-D9701

GM-DX971

Owner’s Manual

Mode d’emploi

Thank you

WARNING CAUTION

Information to User

Note

—

After-sales service for

Pioneer products

USA & CANADA

If you experience problems

Visit our website

http://www.pioneerelectronics.com

http://www.pioneerelectronics.ca



The Safety of Your Ears is in

Your Hands

ESTABLISH A SAFE LEVEL:



BE SURE TO OBSERVE THE FOLLOWING

GUIDELINES:



About This Product

Before connecting/

installing the amplier



Wash hands after

handling.



<KNGZ20J> <5707000012762V> UC

Tous droits de reproduction et de traduction

réservés.

Before you start

What’s what

GM-D8701 and GM-DX871

Front side

21 3 4

Rear side

GM-D9701 and GM-DX971

Front side

21 3 4

Rear side

To adjust the switch, use a flathead screwdri-

ver if needed.

1POWER/PROTECT indicator

The power indicator lights up to indicate

power ON.

!If something is not normal, the indicator

turns red.

2GAIN (gain) control

If the output remains low, even when the car

stereo volume is turned up, turn the con-

trols to a lower level. If distortion occurs

when the car stereo volume is turned up,

turn these controls to a higher level.

!For use with an RCA equipped car stereo

(standard output of 500 mV), set to the

NORMAL position. For use with an RCA

equipped Pioneer car stereo, with maxi-

mum output of 4 V or more, adjust level

to match that of the car stereo output.

!For use with an RCA equipped car stereo

with output of 4 V, set to the position.H

!If you hear too much noise when using

the speaker input terminals, turn the

gain control to higher level.

3LPF (low-pass filter) cut off frequency

control

You can select a cut off frequency from

40 Hz to 240 Hz.

4BASS BOOST REMOTE (bass boost level

remote control) jack

By connecting the Bass boost level remote

control to the jack on the main unit, you will

be able to select a bass boost level from

0 dB to 18 dB.

For instruction of connecting the bass boost

remote control to the amplifier, see the Con-

nection diagram.

Setting gain properly

!Protective function included to prevent

malfunction of the unit and/or speakers

due to excessive output, improper use or

improper connection.

!When outputting high volume sound etc.,

this function cuts off the output for a few

seconds as a normal function, but output

is restored when the volume of the head

unit is turned down.

Setting the unit

!A cut in sound output may indicate impro-

per setting of the gain control. To ensure

continuous sound output with the head

unit at a high volume, set amplifier gain

control to a level appropriate for the preout

maximum output level of the head unit, so

that volume can remain unchanged and to

control excess output.

!Despite correct volume and gain settings,

the unit sound still cuts out periodically. In

such cases, please contact the nearest

authorized Pioneer Service Station.

Gain control of this unit

Preout level: 2 V (Standard: 500 mV)

Preout level: 4 V

Above illustration shows gain set-NORMAL

ting.

Relationship between amplifier gain

and head unit output power

If amplifier gain is raised improperly, this will

simply increase distortion, with little increase

in power.

Signal waveform when outputting at

high volume using amplifier gain

control

If the signal waveform is distorted due to high

output, even if the amplifier gain is raised, the

output power will change only slightly.

Setting the unit

Connection diagram

1Battery wire (sold separately)

!The maximum length of the wire be-

tween the fuse and the positive term-+

inal of the battery is 30 cm (12 in.).

!For the wire size, refer to Connecting the

power terminal. The battery wire, the

ground wire and the optional direct

ground wire must be same size. After

making all other connections at the am-

plifier, connect the battery wire terminal

of the amplifier to the positive term-+

inal of the battery.

2Fuse 100 A (GM-D8701 and GM-DX871) / 150 A

(GM-D9701 and GM-DX971) (sold separately)

Each amplifier must be separately fused at

100 A (GM-D8701 and GM-DX871) / 150 A (GM-

D9701 and GM-DX971).

3Positive terminal+

4Negative ( ) terminal*

5Battery (sold separately)

6Ground wire, Terminal (sold separately)

The ground wires must be same size as the

battery wire.

Connect to metal body or chassis.

7Car stereo with RCA output jacks (sold sepa-

rately)

8External output

9Connecting wire with RCA pin plugs (sold se-

parately)

aAmplifier with RCA input jacks (sold sepa-

rately)

bBass boost level remote control

cBass boost level remote control wire (5 m

(16 ft. 5 in.))

dRCA input jack

eRCA output jack

fSystem remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

gSpeaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire.

hFuse 40 A × 2 (GM-D8701 and GM-DX871) /

40 A × 3 (GM-D9701 and GM-DX971)

iFront side

jRear side

Before connecting the

amplifier

WARNING

!Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

!Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

CAUTION

!Never shorten any wires, the protection circuit

may malfunction.

Connecting the units



*



CAUTION

!Always keep the volume low enough to hear

outside sounds.

!Extended use of the car stereo while the en-

gine is at rest or idling may exhaust the bat-

tery.

!This product is evaluated in moderate and tro-

pical climate condition under the Audio, video

and similar electronic apparatus - Safety re-

quirements, IEC 60065.

!The graphical symbol placed on the

product means direct current.

!Connect either of three subwoofers to the am-

plifier; 1: a subwoofer with a 300 W (GM-D8701

and GM-DX871) / 500 W (GM-D9701 and GM-

DX971) or larger nominal input and an impe-

dance 4 W, 2: a subwoofer with a 500 W (GM-

D8701 and GM-DX871) / 800 W (GM-D9701

and GM-DX971) or larger nominal input and

an impedance 2 or 3: a subwoofer with aW

800 W (GM-D8701 and GM-DX871) / 1 200 W

(GM-D9701 and GM-DX971) or larger nominal

input and an impedance 1 W.

About the protection function

This product has protection function. When this

product detects something abnormal, the follow-

ing functions will operate to protect the product

and speaker output.

!The indicator will turn redPOWER/PROTECT

and the amplifier will shut down in the situa-

tions outlined below.

—If the temperature inside the amplifier gets

too high.

—If a DC voltage is applied to the speaker

output terminal.

!The indicator will turn redPOWER/PROTECT

and the output will be muted in the situations

outlined below.

—If the speaker output terminal and speaker

wire are short-circuited.

Important (Serial number)

The serial number is located on the bottom of

this unit. For your own security and convenience,

be sure to record this number on the enclosed

warranty card.

If the nominal input and impedance are out of

the above ranges, the subwoofer may catch

fire, emit smoke or become damaged.

Produkt Specifikationer

Mærke:	Pioneer
Kategori:	Modtager
Model:	GM-DX871

Har du brug for hjælp?

Hvis du har brug for hjælp til Pioneer GM-DX871 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager Pioneer Manualer

Pioneer SX-303RDS Manual

10 Oktober 2024

Pioneer DEH-1550B Manual

14 September 2024

Pioneer VSX-535 Manual

2 September 2024

Pioneer DMH-C2550NEX Manual

24 August 2024

Pioneer AVH-P5050DVD Manual

24 August 2024

Pioneer A-10EB Manual

21 August 2024

Pioneer AVH-P7850DVD Manual

20 August 2024

Pioneer DMH-342EX Manual

19 August 2024

Pioneer DEH-3050UB Manual

18 August 2024

Pioneer DEH-3850MP Manual

16 August 2024

Modtager Manualer

Nyeste Modtager Manualer

Planet Audio PSX36 Manual

17 Juni 2025

Planet Audio PL2500.1M Manual

17 Juni 2025

MB Quart NA2-400.2RC Manual

17 Juni 2025

MB Quart NA2-400.1 Manual

17 Juni 2025

DS18 GEN-X G8400.4D Manual

17 Juni 2025

Hifonics Zeus Expansion ZXR750/1E Manual

17 Juni 2025

Futaba R7206 SB Manual

16 Juni 2025

DS18 FRP-3.5K Manual

16 Juni 2025

DS18 SMD-300.4AB Manual

16 Juni 2025

DS18 SMD-3000.1D Manual

16 Juni 2025