2 - ENG
These safety glasses must
conform to ANSI Z87.1 requirements (approved glases
have “Z87” printed or stamped on them). It is the
employer’s responsibility to enforce the use of eye
protection equipment by the tool operator and other
people in the work area. (Fig. A)
(Fig. A)
(Fig. B)
[Not to
exceed 120 psi (8.3 bar).] Do not connect the tool to a
compressor rated at over 175 psi. The tool operating
pressure must never exceed 175 psi even in the event of
regulator failure. (Fig. C)
(Fig. D)
70 psi
4.9 bar
save these instructions
When using any pneumatic tool, all safety precautions, as outlined
below, should be followed to avoid the risk of death or serious injury. Read and
understand all instructions before operating the tool.
The definitions below describe the level of severity for each signal word. Please read the
manual and pay attention to these symbols.
Indicates an imminently hazardous situation which, if not avoided,
result in .
Indicates a potentially hazardous situation which, if not avoided,
result in
Indicates a potentially haz ard ous situation which, if not avoided,
result in
Used without the safety alert symbol indicates a situation which, if not
avoided, result in
