Princeton Tec F Manual

Princeton Tec Lommelygte F

Læs gratis den danske manual til Princeton Tec F (2 sider) i kategorien Lommelygte. Denne vejledning er vurderet som hjælpsom af 41 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 21 anmeldelser. Har du et spørgsmål om Princeton Tec F, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

www.princetontec.com

ENGLISH

Figure 1 – Switch Operation

Opération de commutation Betriebsartenschalter

* Princeton Tec calculates total burn time as the time it takes for the light source to produce a

minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.

* Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte

minimale Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa

der Beleuchtungsstärke des Vollmonds in einer klaren Nacht.

* Princeton Tec définit la durée totale d’éclairage comme le temps nécessaire à la source

lumineuse pour produire un minimum de 0,25lux à 2mètres. 0,25lux équivaut à peu près à la

luminosité d’une pleine lune dans un ciel nocturne dégagé.

15 23

FRED

LED HEADLAMP

Operating and Maintenance

Instructions

Notice d’utilisation et d’entretien

Bedienungsanleitung

Figure 2 – Battery Replacement

Remplacement des piles Einlegen der Batterien

Battery Installation – See Battery Installation Diagram

• 3 AAA

• Alkaline (LR03)

• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment and

recommends recycling batteries. For more information

about battery recycling, please go to:

www.batteryrecycling.com

To install the batteries, use the tool on the headband to

unlatch the door. Open the Fuel case by popping the

door latch over the catch and rotate the door open.

Install three AAA batteries according to the polarity

markings on the inside of the cabinet. Observe proper

battery polarity when installing the batteries. Improper

installation of the batteries will damage the light and

void the warranty.

Rotate the door to the closed position, squeeze the

body between your forefingers and thumb to snap the

door latch over the catch.

WARNING

• Never mix fresh and used batteries.

• Never mix different battery brands or chemistry

types.

• Always remove drained batteries immediately.

• Remove batteries during long periods of storage.

NOTE: Rechargeable NiCad or NiMH batteries may

result in reduced brightness due to lower nominal

voltage.

Switch Operation – See Switch Operation diagram

The Fred has two light sources to choose from, one

red Ultrabright LED or 3 white Ultrabright LEDs. Each

light source has two modes (High and Low).

• To switch between the Red LED and the 3 white

LEDs -Press and hold the button until the light source

changes. Release the button when the appropriate

source is lit. The light will remain on this LED source

(allowing you to cycle though the modes) until you

decide to change it.

• Modes (High and Low) are selected by pressing

and releasing the button within 1.5 seconds of the

previous button press. If more than two seconds has

passed since the previous button press the next

press will turn the light off.

• There are two ways to turn the Fred off. You can

cycle through the modes until you reach off, or if the

light has been on for more than two seconds the next

button press will turn the light off.

• Note about changing batteries for lights with Red or

Green 5mm Ultrabright: To ensure the Ultrabright LEDs

turn on first, remove the old batteries, press and hold

the button down for three seconds to discharge the

capacitor on the circuit. Install the new batteries and

close the battery door. The light will now default to the

Ultrabright turning on first.

**The times listed on the rear of the package assume

you have start with fresh batteries and use only one

mode.

Power Consumption

Refer to the burn time chart for performance data for

different battery types and mode settings.

**Princeton Tec calculates total burn time as the time it

takes for the light source to produce a minimum of 0.25

lux at 2 meters. 0.25 lux is about the equivalent of a full

moon on a clear night.

**The times listed in this chart assume you start with

fresh batteries and use only one mode.

Troubleshooting

If the Fred fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is confirmed.

• Check the light for water contamination on the

circuit board. The light will resume normal

operation once the water is shaken or blown out

and the light is left open until completely dry. If the

light has been contaminated with salt water, flush

the unit with fresh water and dry as described

above.

USA– International 5-Year Warranty

WARRANTY – Princeton Tec warrants this product to

be free from defects in workmanship and materials

under normal use for 5 years from the date of purchase

This warranty covers all of the component parts of the

product except batteries. This warranty does not cover

deterioration due to normal wear or damage due to

misuse, alteration, negligence, accidents, or

unauthorized repair. Princeton Tec will repair or replace

parts which are defective in workmanship or materials.

Your authorized Princeton Tec Dealer and Princeton

Tec are the only facilities authorized to repair the

product. After (3) unsuccessful attempts (within the

warranty period) to repair the product, you have the

right to elect replacement of the product or a refund of

the purchase price less allowance for use of the

product. NO INCIDENTAL OR CONSEQUENTIAL

DAMAGES ARE INCLUDED IN THIS WARRANTY.

(Some states do not allow the exclusion or limitation of

incidental or consequential damages, so the above

limitations or exclusions may not apply to you.) This

warranty gives you specific legal rights, and you may

also have other rights which vary from state to state.

Princeton Tec reserves the right to change product

specifications without notice.

Return Policy

If your light fails to operate, follow these simple steps:

1) Check batteries. Replace if necessary.

2) Contact Princeton Tec customer service at

800-257-9080 to request an RMA number to send your

light in for repair or replacement. No warranty repairs

will be accepted without an RMA number.

3) Return the light without batteries to: Princeton Tec,

5198 Rt. 130, Bordentown, NJ 08505. Postage due

and freight collect items will not be accepted.

Princeton Tec

PO Box 8057,

Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

www.princetontec.com

Use tool on headstrap to open battery compartment

Utilisez l'outil attaché à la sangle de la frontale pour

ouvrir le compartiment des piles.

Verwenden Sie zum Öffnen des Batteriefachs das

am Kopfband befestigte Werkzeug.

press 1x = Low

press 2x = High

DISTANCE (Meters)

HIGH

74H

LOW

145H

3 Ultrabright

LEDs

press 1x = Low

press 2x = High

DISTANCE (Meters)

1810

MED

100H

LOW

180H

1 RED

Ultrabright LED

to switch between light

sources, press and hold

button (1-2 seconds)

Produkt Specifikationer

Mærke:	Princeton Tec
Kategori:	Lommelygte
Model:	F
Antal effektniveauer:	2
Vægt:	78 g
Produktfarve:	Sort
Lampe type:	LED
Batteriteknologi:	Alkaline
Vandfast:	Ingen
Batterilevetid (maks.):	180 t
Batteritype:	AAA
Antal understøttede batterier:	3
Pæreeffekt:	- W
Antal lamper:	4 Lampe( r)
Lommelygte type:	Hovedbånd lommelygte
Lysstråle afstand (maks.):	35 m
Lysstrøm:	45 lm