Princeton Tec Helix Manual

Princeton Tec Lommelygte Helix

Læs gratis den danske manual til Princeton Tec Helix (2 sider) i kategorien Lommelygte. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Princeton Tec Helix, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

FOR CALIFORNIA RESIDENTS:

WARNING: This product contains

Bisphenol A (BpA) a chemical known

to the State of California to cause birth

defects or other reproductive harm.

Switch Operation – See Figure 1

Helix Backcountry Rechargeable has two

main light sources to choose from,

one white Maxbright LED or two color

Ultrabright LEDs. Each light source is

dimmable.

Swipe to the right to activate white

light. Swipe to the left to activate color

light. One swipe engages dimmable

high power mode; two swipes engage

medium power and three swipes

engage ﬂash mode. With high power

mode engaged, dimming is achieved by

holding ﬁngertip on sensor. After two

seconds in any mode, left or right swipe

turns lantern off.

Lantern Globe Removal and Installation

Figure 3, Figure 4: Lantern globe is

removable to convert Helix Backcountry

Rechargeable into a spotlight or for globe

cleaning. To begin globe removal, turn

lantern over and press down on two of the

globe attachment clasps. Once clasps are

released globe can be removed.

To install globe, engage tab into slot

on body and snap down all three

clasps at once.

Lantern Globe - Compressing and Opening

Figure 5: 1a- 2b To compress lantern,

push globe toward lantern body. Hook

one side of top clasp into lantern body

and then roll top of lantern to lock globe

into compressed position.

1a-2b To open, roll one side of top clasp

off catch, then allow globe to extend into

open position.

Troubleshooting

If the Helix Backcountry Rechargeable

fails to light:

• Check charge state of battery by

plugging into power source and

observing battery charge level LEDs

under lantern globe.

• Check the light for water

contamination on the circuit board.

The light will resume normal

operation once the water is shaken

or blown out and the light is left until

completely dry. If the light has been

contaminated with salt water, ﬂush

the unit with fresh water and dry as

described above.

USA– International 5-Year Warranty

WARRANTY – Princeton Tec warrants

this product to be free from defects

in workmanship and materials under

normal use 5 years. This warranty

covers all of the component parts of the

product except rechargeable battery,

which is covered for 90 days. This

warranty does not cover deterioration

due to normal wear or damage due

to misuse, alteration, negligence,

accidents, or unauthorized repair.

Princeton Tec will repair or replace parts

which are defective in workmanship or

materials.

After (3) unsuccessful attempts

(within the warranty period) to repair

the product, you have the right to

elect replacement of the product or

a refund of the purchase price less

allowance for use of the product. NO

INCIDENTAL OR CONSEQUENTIAL

DAMAGES ARE INCLUDED IN THIS

WARRANTY. (Some states do not allow

the exclusion or limitation of incidental

or consequential damages, so the

above limitations or exclusions may

not apply to you.) This warranty gives

you speciﬁc legal rights, and you may

also have other rights which vary from

state to state.

Princeton Tec reserves the right to

change product speciﬁcations without

notice.

Return Policy

If your light fails to operate, follow

these simple steps:

1. Check batteries. Replace if

necessary.

2. To send your light in for repair

or replacement, ﬁrst contact

Princeton Tec customer service at

1-800-257-9080 to request an

RMA number. Please have your

light model, date of purchase and a

brief description of the fault your are

experiencing. No warranty repairs

will be accepted without an RMA

number.

3. Return the light to:

Princeton Tec, PO Box 8057

Trenton NJ 08650. Postage due

and freight collect items will not be

accepted.

4. Upon receipt your light will be

processed in about two weeks.

Please allow additional time for

return transportation from NJ.

Princeton Tec

PO Box 8057, Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

www.princetontec.com

ENGLISH

Battery Charging -

See Figure 2

Supplied with Lantern:

• Lithium-Ion rechargeable battery,

micro-USB charging cable.

Princeton Tec cares about the

environment and recommends

recycling batteries. For more information

about battery recycling, please go to:

www.batteryrecycling.com

To charge battery pack, open USB door

and plug in micro USB cord; connect

other end of cable to USB power source

such as charger or computer.

Princeton Tec suggests using a charger

with output of 5V, 1A. This charger

will fully charge the battery pack in

3 to 4 hours. Slower charging will be

achieved with a charger rated for lower

amperage. Some computer USB ports

may not have sufﬁcient output to

charge this or any USB rechargeable

product. Under normal usage, the

supplied lithium ion battery pack will

last for approximately 1,000 charge /

discharge cycles.

Green battery charge level LEDs under

globe indicate battery state. Charge

level is indicated by 1, 2 or 3 LEDs,

representing roughly 33%, 66% and

100% charge states. If the charge

level LEDs begin ﬂashing during

charging, please brieﬂy disconnect the

micro USB cable, and then reconnect

to restart charging. If ﬂashing

continues, move your lantern to a

cooler environment before continuing

charging.

Do not remove the screws holding

the lantern cabinet together. There

are no user serviceable parts inside

the lantern.

General Care and Warnings

• Properly charge the battery to

maximize its lifespan. Lithium

ion batteries do not suffer from a

“memory effect,” and for battery

longevity it is preferable to charge

more frequently if possible, rather

than to fully deplete the battery’s

charge;

• To avoid damaging your lighting

system, use only chargers that meet

the approved speciﬁcations.

• Helix Backcountry Rechargeable,

battery pack and cable are not

submersible. Submerging in water

will damage the system and void the

warranty.

• To keep your lighting system looking

new, use a mild soap and water

solution with a rag or sponge to

periodically wipe off dirt.

HELIX

BACKCOUNTRY

RECHARGEBLE

LED LANTERN

www.princetontec.com

0217

Figure 1 – Switch Operation

LEFT TO RIGHT = WHITE

RIGHT TO LEFT = COLOR

CENTER PRESS = DIM

SWIPE x 2 = MEDIUM

SWIPE x 3 = FLASH

SWIPE = OFF

Figure 3 – Globe Removal

Figure 2 – Charging

Charge

Indicator

Figure 4 – Globe Installation

1 2

Figure 5 – Compressing and Opening

Produkt Specifikationer

Mærke:	Princeton Tec
Kategori:	Lommelygte
Model:	Helix

Har du brug for hjælp?

Hvis du har brug for hjælp til Princeton Tec Helix stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lommelygte Princeton Tec Manualer

Princeton Tec Snap Manual

11 Juli 2025

Princeton Tec AXIS Rechargeable Manual

25 Februar 2025

Princeton Tec Remix 450 RGB Manual

25 Februar 2025

Princeton Tec Vizz Manual

25 Februar 2025

Princeton Tec Vizz II Manual

16 December 2024

Princeton Tec Helix Manual

4 September 2024

Princeton Tec Yukon HL Manual

31 August 2024

Princeton Tec Snap Solo Manual

31 August 2024

Princeton Tec HYB-BK Manual

31 August 2024

Princeton Tec Apex Recharheable Manual

31 August 2024

Lommelygte Manualer

Nyeste Lommelygte Manualer

ArmyTek Prime C2 Pro Manual

17 Oktober 2025

Coleman 2000006663 Manual

12 Oktober 2025

Ansmann Daily Use 300B Manual

11 Oktober 2025

Maglite TRM4RE4 Manual

11 Oktober 2025

Milwaukee M12 ALIP Manual

8 Oktober 2025

Olight M21 X Warrior Manual

8 Oktober 2025

Draper Expert 31082 Manual

2 Oktober 2025

Draper 90033 Manual

1 Oktober 2025

Draper Expert 31095 Manual

1 Oktober 2025

Nitecore P40 Manual

1 Oktober 2025