Princeton Tec Remix 450 RGB Manual

Princeton Tec Lommelygte Remix 450 RGB

Læs gratis den danske manual til Princeton Tec Remix 450 RGB (2 sider) i kategorien Lommelygte. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Princeton Tec Remix 450 RGB, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Opération de commutation Betriebsartenschalter

* Princeton Tec calculates total burn time as the time it takes for the light source to produce a

minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.

* Princeton Tec définit la durée totale d’éclairage comme le temps nécessaire à la source

lumineuse pour produire un minimum de 0,25lux à 2mètres. 0,25lux équivaut à peu près à la

luminosité d’une pleine lune dans un ciel nocturne dégagé.

Battery Installation –

See Battery Installation Diagram

• 3 AAA

• Alkaline (LR03)

• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment and

recommends recycling batteries. For more information

about battery recycling, please go to:

www.batteryrecycling.com

To install the batteries, unlatch the battery door.

Open the Remix case by popping the door latch

over the catch and rotate the door open.

Install three AAA batteries according to the polarity

markings on the inside of the cabinet. Observe

proper battery polarity when installing the batteries.

Improper installation of the batteries will damage the

light and void the warranty.

Rotate the door to the closed position, squeeze the

body between your forefingers and thumb to snap the

door latch over the catch.

WARNING !

• Never mix fresh and used batteries.

• Never mix different battery brands or

chemistry types.

• Always remove drained batteries immediately.

• Remove batteries during long periods of storage.

NOTE: Rechargeable NiCad or NiMH batteries

may result in reduced brightness due to lower

nominal voltage.

Switch Operation – See Switch Operation diagram

The Remix has two light sources to choose from: three

Ultrabright LEDs and one Maxbright LED. The

Ultrabright LEDs have one level in each of three color

modes: red, green and blue. The white Maxbright LED

has two modes (Low and High).

The first press will turn the light on in red mode. A

subsequent press within 1.6 seconds changes to

green, and another press within 1.6 seconds

changes to blue. To activate the Maxbright LED,

press and hold the button down until the light turns

on in low mode. Another press within 1.6 seconds

will change to high level.

NOTE: If you keep the button pressed the light will

continue to switch back and forth between the 5mm

and Maxbright LED until you release the button.

Any button press after two seconds will turn the light off.

One final note about the light function – If you have the

light turned on, (and more than 1.6 seconds has

passed since your last button press) and you press

and hold the button down to switch light sources, you

will be in darkness for about one second as the light

sees this press as a signal to turn the light off and

switch to the other light source simultaneously.

**The times listed on the rear of the package

assume that you start with fresh batteries and use

only one mode.

Troubleshooting

If the Remix fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is confirmed.

• Check the light for water contamination on the

circuit board. The light will resume normal operation

once the water is shaken or blown out and the light is

left open until completely dry. If the light has been

contaminated with salt water, flush the unit with fresh

water and dry as described above.

USA– International 5-Year Warranty

WARRANTY – Princeton Tec warrants this product to

be free from defects in workmanship and materials

under normal use for 5 years. This warranty covers all

of the component parts of the product except batteries.

This warranty does not cover deterioration due to

normal wear or damage due to misuse, alteration,

negligence, accidents, or unauthorized repair.

Princeton Tec will repair or replace parts which are

defective in workmanship or materials.

After (3) unsuccessful attempts (within the warranty

period) to repair the product, you have the right to elect

replacement of the product or a refund of the purchase

price less allowance for use of the product. NO

INCIDENTAL OR CONSEQUENTIAL DAMAGES ARE

INCLUDED IN THIS WARRANTY. (Some states do not

allow the exclusion or limitation of incidental or

consequential damages, so the above limitations or

exclusions may not apply to you.) This warranty gives

you specific legal rights, and you may also have other

rights which vary from state to state.

Princeton Tec reserves the right to change product

specifications without notice.

FOR CALIFORNIA RESIDENTS:

WARNING: This product contains Bisphenol A (BpA) a

chemical known to the State of California to cause birth

defects or other reproductive harm.

Return Policy

If your light fails to operate, follow these simple steps:

1) Check batteries. Replace if necessary.

2) To send your light in for repair or replacement, first

contact Princeton Tec customer service at

1-800-257-9080 to request an RMA number. Please

have your light model, date of purchase and a brief

description of the fault your are experiencing. No

warranty repairs will be accepted without an RMA

number.

3) Return the light to: Princeton Tec, PO Box 8057

Trenton NJ 08650. Postage due and freight collect

items will not be accepted.

4)Upon receipt your light will be processed in about

two weeks. Please allow additional time for return

transportation from NJ.

Princeton Tec

PO Box 8057,

Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

www.princetontec.com

press 1x = Low

press 2x = High

1 MAXBRIGHT

LED

LOW

53H

HIGH

28H

DISTANCE (Meters)

10 52 73

COLOR

61H

To switch between light

sources, press and hold

button (1-2 seconds)

Remplacement des piles Einlegen der Batterien

1 2

press 1x = Red

press 2x = Green

press 3x = Blue

3 ULTRABRIGHT

LEDs

English

0417

Figure 1 –Switch Operation

Opération de commutation Betriebsartenschalter

Figure 2 – Battery Replacement

Remplacement des piles Einlegen der Batterien

DISTANCE (Meters)

0 10

www.princetontec.com

REMIX RGB

LED HEADLAMP

Operating and Maintenance

Instructions

Notice d’utilisation et d’entretien

Bedienungsanleitung

Produkt Specifikationer

Mærke:	Princeton Tec
Kategori:	Lommelygte
Model:	Remix 450 RGB

Har du brug for hjælp?

Hvis du har brug for hjælp til Princeton Tec Remix 450 RGB stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lommelygte Princeton Tec Manualer

Princeton Tec Snap Manual

11 Juli 2025

Princeton Tec AXIS Rechargeable Manual

25 Februar 2025

Princeton Tec Remix 450 RGB Manual

25 Februar 2025

Princeton Tec Vizz Manual

25 Februar 2025

Princeton Tec Vizz II Manual

16 December 2024

Princeton Tec Helix Manual

4 September 2024

Princeton Tec Yukon HL Manual

31 August 2024

Princeton Tec Snap Solo Manual

31 August 2024

Princeton Tec HYB-BK Manual

31 August 2024

Princeton Tec Apex Recharheable Manual

31 August 2024

Lommelygte Manualer

Nyeste Lommelygte Manualer

ArmyTek Prime C2 Pro Manual

17 Oktober 2025

Coleman 2000006663 Manual

12 Oktober 2025

Ansmann Daily Use 300B Manual

11 Oktober 2025

Maglite TRM4RE4 Manual

11 Oktober 2025

Milwaukee M12 ALIP Manual

8 Oktober 2025

Olight M21 X Warrior Manual

8 Oktober 2025

Draper Expert 31082 Manual

2 Oktober 2025

Draper 90033 Manual

1 Oktober 2025

Draper Expert 31095 Manual

1 Oktober 2025

Nitecore P40 Manual

1 Oktober 2025