Roland KS-10Z Manual

Roland Ikke kategoriseret KS-10Z

Læs gratis den danske manual til Roland KS-10Z (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Roland KS-10Z, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

5Before using this unit, carefully read the leaet “USING THE UNIT SAFELY” and “IMPORTANT NOTES.” After reading, keep the

document(s) where it will be available for immediate reference.

5This document explains the specications of the product at the time that the document was issued. For the latest information,

refer to the Roland website.

Part Descriptions

Center frame

Side frames

Arms

Legs

Assembly

Attaching the Side Frames

1. Using the included knob bolts, fasten the left and

right side frames to the center frame.

Knob bolts (included)

2. Open the arm and leg of each side frame until you

hear a click.

Make sure that the lock pins of the arm and leg t into

the holes and are secure.

Lock pins

NOTE

When opening the arm and leg of each side frame, take care

not to pinch your nger etc.

Adjusting the Height

Knob bolts

1. Loosen the knob bolt of each side frame.

2. While pulling out the knob bolt,

lift up the arm and adjust it to the

height of the calibration line.

* You must adjust it precisely to the

calibration line.

3. Release the knob bolt.

When you release the knob bolt, it enters the screw

hole.

* Slightly raise and lower the arm to verify that it is locked.

4. Firmly tighten the knob bolt to secure it.

Adjusting the Width

Knob bolt

1. Loosen the knob bolt of the center frame.

2. While pulling out the knob bolt, adjust the width of

the center frame.

3. Release the knob bolt.

4. Adjust the position of the center frame so that the

knob bolt enters the screw hole.

* Slightly slide the side frame to left and right to verify that

it is locked.

5. Firmly tighten the knob bolt to secure it.

Calibration lines

English

Roland is an either registered trademark or trademark of Roland

Corporation in the United States and/or other countries.

Produkt Specifikationer

Mærke:	Roland
Kategori:	Ikke kategoriseret
Model:	KS-10Z
Bredde:	600 mm
Dybde:	620 mm
Vægt:	9800 g
Produktfarve:	Sort
Maksimal belastningsvægt:	100 kg
Sammenfoldelig:	Ingen
Materiale:	Stål
Placering:	Gulv
Styrehjul:	Ingen
Formål:	Tastatur
Højdejustering:	Ja
Højde (min.):	640 mm
Højde (maks.):	910 mm
Antal højde placeringer:	7
Bredde justeringsområde:	590 - 940 mm
Antal understøttede instrumenter:	1