Roland RMP-3 Manual


Læs gratis den danske manual til Roland RMP-3 (10 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 96 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 48.5 anmeldelser. Har du et spørgsmål om Roland RMP-3, eller vil du spørge andre brugere om produktet?

Side 1/10
– 1 – C5100025 1RCC
fig.Panel
1. Mini Speaker
For the metronome’s beep sound only. If the
OUTPUT jack is being used, no sound is
output.
2. [METRONOME] Button
Selects the metronome parameter.
3. [START/STOP] Button
Starts and stops the metronome.
4. PHONES VOLUME Knob
Adjusts the OUTPUT jack’s volume.
* The volume of the mini speaker is adjusted with CLICK
VOLUME.
5. [COACH] Button
Selects the Coach mode.
6. VALUE [+]/[-] Button
Use these buttons to change the values of
each parameter.
To increase the value rapidly, hold down [+]
and press [-]. To decrease the value rapidly,
hold down [-] and press [+].
7. BEAT Indicator
Flashes along quarter notes.
Red indicator flashes on accent beats.
8. Head
9. Sensor
10.Tuning Bolts
Adjusts the head tension.
Thank you, and congratulations on your choice of the Roland RMP-3.
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (on another
leaflet). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel
assured that you have gained a good grasp of every feature provided by your new unit, Owner’s manual should be read in its
entirety. The manual should be saved and kept on hand as a convenient reference.
As shipped, the RMP-3’s battery is not installed. Please read “Preparations—Loading the Battery” and follow the
instructions to install the battery.
Copyright © 2005 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Panel Description
1
2
4
5
3
7
9
10
8
6
– 2 –
Side Panel
fig.Side
1. Security Slot ( )
http://www.kensington.com/
2. MIX IN Jack
For connecting an external audio source
(CD, MD, etc.) for playing along.
3. OUTPUT Jack
For headphones, amp, or audio system.
* The RMP-3 outputs sounds in monaural.
4. AC Adaptor Jack
Connect the AC adaptor (optional) here.
5. POWER Switch
Turns the power on/off.
fig.BattCase.e_50
1. Press down and slide off the lid of the battery compartment
(located on the bottom of the unit).
2. Connect the snap cord to the battery, and place it inside the
battery compartment.
* Verify the battery’s polarity (+ versus -).
3. Securely close the battery cover.
* Do not let the snap cord get caught in the battery compartment lid.
When to Change the Battery
The Battery LOW indicator ( ) at the lower left of the
display begins to flash when the battery power drops.
Insufficient battery power lowers the volume level of the mini speaker and causes unstable
operation. Replace the battery as soon as possible.
A BOSS PSA series AC adaptor (sold separately) can be used to power the RMP-3.
Turn off the power before connecting the AC adaptor.
Use only the BOSS PSA-series AC adaptor. Other adaptors may cause malfunction or damage
to the RMP-3 and must never be used.
The Battery LOW indicator ( ) flashes when the battery power drops while the AC
adaptor is used.
fig.Bolt
BEFORE playing the RMP-3, you must tune the head to your preferred
playing tension. The head is NOT tuned before shipping.
Always tighten the tuning bolts in the order shown in the figure.
* Failure to adjust the tension may result in damage to the head.
* Head tension may change with extended use. Make adjustments as needed.
5
4
2
1 3
Preparations
Loading the Battery
Connecting the AC Adaptor
Adjusting the Head Tension
Battery
Snap
9V
Battery
1
7
8
63
45
2


Produkt Specifikationer

Mærke: Roland
Kategori: Ikke kategoriseret
Model: RMP-3

Har du brug for hjælp?

Hvis du har brug for hjælp til Roland RMP-3 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Roland Manualer

Roland

Roland ATUP-EX Manual

9 Juni 2025
Roland

Roland PD-10X Manual

1 Juni 2025
Roland

Roland VH-11 Manual

31 Maj 2025
Roland

Roland PD-12X Manual

31 Maj 2025
Roland

Roland FD-7 Manual

28 Februar 2025
Roland

Roland VR-3EX Manual

26 Februar 2025
Roland

Roland KSFE50 Manual

20 Februar 2025
Roland

Roland KS-V7 Manual

30 December 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer