Smart-AVI DVXU-TXS Manual

Smart-AVI AV forlænger DVXU-TXS

Læs gratis den danske manual til Smart-AVI DVXU-TXS (2 sider) i kategorien AV forlænger. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Smart-AVI DVXU-TXS, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
DVI-D and USB extension
via Twisted Pair
DVX Plus
www.smartavi.com
© Copyright 2012 Smart-AVI, All Rights Reserved
Notice
The information contained in this document is
subject to change without notice. Smart-AVI makes
no warranty of any kind with regard to this material,
including but not limited to, implied warranties of
Smart-AVI will not be liable for errors contained herein or
for incidental or consequential damages in connection
with the furnishing, performance or use of this material.
No part of this document may be photocopied,
reproduced or translated into another language without
prior written consent from Smart-AVI.
For more information, visit www.smartavi.com.
QUICK START
GUIDE
SmartAVI, Inc. / Twitter: smartavi
11651 Vanowen St., North Hollywood, CA 91605
Tel: (818) 503-6200 Fax: (818) 503-6208
http://www.SmartAVI.com
The following is the wiring standard for terminating UTP/STP
cable using RJ-45 connector:
Connectors: RJ-45
Capacitance: 14 pf/ft (46.2 pf/m)
Conductor Gauge: 24 AWG
Impedance: 100 +/- 15 ohms
Pair 1 Pins 1 & 2
Pair 2 Pins 3 & 6
Pair 3 Pins 4 & 5
Pair 4 Pins 7 & 8
DVX PLUS SPECIFICATIONS
Video Interface Single Link Range
Video Data Rate 1.65 Gbps
Resolution
1920 x 1200 @ 60 Hz, Reso
lution up to 1280 x 1024
min. 75H
Power Supply Universal Switch mode PSU
(90-240V Input) 5VDC 2A
Input Interface DVI-D
USB Data
USB max data rate 12Mbps
USB compatibility 1.0 and 1.1
Connector Type Type A (Transmitter)
Type B (Receiver)
Technical Specifications
Introduction
Preparing & Connecting System CAT5 Cable
Following is the wiring standard for terminating CAT 5 cable
using RJ-45 connector:
Pair 1 Pins 1 & 2
Pair 2 Pins 3 & 6
Pair 3 Pins 4 & 5
Pair 4 Pins 7 & 8
Connectors: RJ-45
Capacitance: 14 pf/ft (46.2 pf/m)
Conductor Gauge: 24 AWG
Impedance: 100 +/- 15 ohms
4 - Pair
Operating Instructions
Once installation is completed verify that the power is
present at all devices in the system. If computer was on
during the set up it might be necessary to reboot the
computer. The peripheral devices should be ready for
use.
Connecting The Transmitter
Connect the transmitter to the host using an A-B 1.
USB cable.
Connect the transmitter to the host DVI-D using 2.
male to male DVI cable.
The A side of the USB connector would go to the 3.
computer host and the B side would be connected
to the transmitter.
Check that power LED is lit. The TX/RX LED should 4.
not be flashing at this time.
In the back of the unit connect the CAT5 cable that 5.
will connect to the receiver (DVXU-RX).
Connecting The Receiver
Connect the receiver to the peripheral device using 1.
A-B USB cable. In this case the A side of the connec-
tor will go to the receiver unit and the B side of the
connector will go the peripheral. Use a USB Hub if
needed.
Connect the receiver unit to the monitor.2.
Join the DVX Plus units using shielded cable for 3.
DVI-D and standard CAT5/6 UTP cable for USB.
Once connected check that the Power LED on both
receiver and transmitter is on and the TX/RX LED is
flashing, indicating that communication exists be-
tween the two units. If receiver LED is not on, make
sure the power supply is connected.
Installation Diagram
AB
Setting the DDC
DDC provides plug-and-play capability to your
displays. When you plug a display into your computer,
the DDC table in the display tells the computer the
optimal resolution to use. This device is capable of
supporting two primary types of displays: PC and Mac.
The default setting is PC.
switches as shown below:switches as shown below:
1&2 ON, 3&4 OFF 1&2 OFF, 3&4 ON
To change this setting,
fr e TRANSMITTER om th
by removing the four side
screws. Next, locate the
DIP switches near the rear
of the device next to the
Data Port (RJ45 Ethernet
Port).
STP
STP6
Introduction
DVX Plus extends Universal Serial Bus (USB 1.1) and
Digital Visual Interface (DVI-D) signals via com-
mon twisted pair cable. Using a unique method of
transparent data transfer, the system allows a USB
peripheral and a DVI display to be located up to 225
feet from the CPU.
Features
• Extends USB and DVI-D signals up to 225ft from
the computer.
• U easy to ses in tall,s inexpens e twisted piv air cable.
• Data recovery for digital video.
• Supports 1920x1200 digital video resolution.
• Fully compliant with USB 1.1 specifications.
• Supports 1.5 and 12 Mbps data rates.
• Compatible with all operating systems.
• Ext r pter r er re-ernal powe ada fo tran ittsm and
ceiver unit.
• Fully transparent (does not use any emulation).
• Plug and play.
DVX Plus Package Contents
Qty Items Part No.
1 DVX Plus Transmitter unit DVXU-TX
1 DVX Plus Receiver unit DVXU-RX
2 5 volt dc power supply PS5VDC2A
Connecting The Transmitter
1. Connect the transmitter to the host using an A-B USB
cable.
2. Connect the transmitter to the host DVI-D using male
to male DVI cable.
3. The A side of the USB connector would go to the
computer host and the B side would be connected to
the transmitter.
4. Check that power LED is lit. The TX/RX LED should not
5. In the back of the unit connect the CAT5 cable that will
connect to the receiver (DVXU-RX).
Connecting The Receiver
1. Connect the receiver to the peripheral device using A-B
USB cable. In this case the A side of the connector will
go to the receiver unit and the B side of the connector
will go the peripheral. Use a USB Hub if needed.
2. Connect the receiver unit to the monitor.
3. Join the DVX Plus units using shielded cable for DVI-D
and standard CAT6 STP cable for USB. Once con-
nected check that the Power LED on both receiver and
transmitter is on and the , indicating RX LED goes OFF
that communication exists between the two units. If
receiver LED is not on, make sure the power supply is
connected.
AB

Produkt Specifikationer

Mærke: Smart-AVI
Kategori: AV forlænger
Model: DVXU-TXS

Har du brug for hjælp?

Hvis du har brug for hjælp til Smart-AVI DVXU-TXS stil et spørgsmål nedenfor, og andre brugere vil svare dig


AV forlænger Smart-AVI Manualer

Smart-AVI

Smart-AVI HFX Manual

9 Januar 2025
Smart-AVI

Smart-AVI HFX-KM Manual

9 Januar 2025
Smart-AVI

Smart-AVI FDX-AVPRO Manual

1 Januar 2025
Smart-AVI

Smart-AVI HDX-POE Manual

1 Januar 2025
Smart-AVI

Smart-AVI RKT16-HDX100 Manual

1 Januar 2025
Smart-AVI

Smart-AVI HDX-LX Manual

1 Januar 2025
Smart-AVI

Smart-AVI SFXPRO-4P Manual

1 Januar 2025
Smart-AVI

Smart-AVI XTPRO Manual

1 Januar 2025
Smart-AVI

Smart-AVI SFXPRO-2P Manual

1 Januar 2025
Smart-AVI

Smart-AVI FVX-3000-Pro Manual

1 Januar 2025

AV forlænger Manualer

Nyeste AV forlænger Manualer

Kramer

Kramer 690R Manual

1 August 2025
Tripp Lite

Tripp Lite B132-100-1 Manual

31 Juli 2025
Tripp Lite

Tripp Lite B126-1A1SR Manual

31 Juli 2025
Tripp Lite

Tripp Lite B127U-002-PDPD2 Manual

31 Juli 2025
Tripp Lite

Tripp Lite B140-004 Manual

31 Juli 2025
Tripp Lite

Tripp Lite B127U-002-PHPH2 Manual

31 Juli 2025
Tripp Lite

Tripp Lite B126-2A0 Manual

31 Juli 2025
Tripp Lite

Tripp Lite B126-1A1-PLHD Manual

31 Juli 2025
Tripp Lite

Tripp Lite B013-330 Manual

31 Juli 2025
Tripp Lite

Tripp Lite B127U-111-PHPH Manual

30 Juli 2025