Statron 3250.1 Manual

Statron Ikke kategoriseret 3250.1

Læs gratis den danske manual til Statron 3250.1 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om Statron 3250.1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

voltage regulator

type 3250.1

Use of the power supply unit as agreed contains:

The connection and business of low voltage consumers with an operating voltage between 0 and 36 V direct

voltage. The current consumption of the consumer mustn't exceed 7.5 ares.

Respect! Read absolutely!

These read through these instructions exactly. The right to claim under guarantee dies at damages which are

caused by nonobservance of the instructions. For resultant damages we don't assume any liability.

1. introduction

This power supply unit is of tension with his direct one moving possibilities and current is universally usably for

industry, research and education.

An electronic current limitation protects the power supply unit from overload.

Output voltage is current electronically stabilized and directly adjustably and -- . The electronic current stabilization

can therefore be used to protect consumers from one to high current consumption as adjustable current limitation.

The output voltage then becomes at an overload according to abgesenkt (at short-circuit on near 0 V). This one

overlooked at elimination //stell// the before oriented output voltage automatically again. One becomes the

respective work condition, tension, (cv) or current stabilization (cc) LED reported by ever.

The oriented results are a 3 ½ stellige LCD indication 13 mm readable over ever. The tension or current attitude

carried out about rough -- and fine-tuning control.

2. safety notes

2.1 The power supply unit is built up in safety class I as well as in accordance with VDE 0411 and VDE

0805/DIN EN 60950. The net transformer is built up after DIN VDE 0551/DIN EN 60742 as safety separating

transformer and is checked with 3.75 kVeff primarily/secondarily. It is 0875th it is equipped with a VDE

checked mains power line with protection leader and may be operated or attached only at 230-V alternating

voltage nets with protective earthing therefore radio suppressed in accordance with VDE.

2.2 It has to be respected on this that the protection leader is interrupted (yellowly/green) neither in the mains

power line nor in the piece of equipment or in the net since with interrupted protection leader there is serious

danger. It has to be respected on this furthermore that the insulation is neither damaged nor destroyed.

2.3 power supply units don't belong child hands in!

2.4 The accident prevention regulations of the association of the commercial professional association have to be

observed for electrical plants and operating supplies in commercial facilities.

2.5 Operating power supply units by trained staff is responsible to supervise to hobby and alone help workshops

in schools, education facilities.

2.6 Open of shutters or remove of parts at this, unless if this is possible by hand, voltage-carrying parts can be

exposed. Junctions also can be voltage-carrying. The piece of equipment must be separated from all voltage

sources in front of a comparison, a maintenance, an overhaul or an exchange of parts, if a opening the piece

of equipment is required. After one, at the open piece of equipment under tension unavoidably is

comparison, a maintenance or a repair, may happen only by a qualified employee which is familiar with the

thus obliged dangers or the appropriate regulations for this this if.

2.7 Condensers in the piece of equipment still can be loaded even if the piece of equipment was separated from

all voltage sources.

2.8 It has to be guaranteed that only safeguardings of Nennstromsträrke said the given type and this one are

used as a substitute. The use of mended safeguardings or bridging of the fuseholder are inadmissible. The

piece of equipment is overtaxing safe and short-circuit protected. There is a grave fault to Abschmelzen of

the initial safeguarding which must be removed by a qualified employee before the new intact safeguarding

can be used by this qualified employee.

2.9 Never switch your power supply unit on immediately, if it is taken to a warm room from a cold, then. The

condensation arising at dewfall can destroy your piece of equipment under unfavorable circumstances. Let

the piece of equipment uneingeschaltet on room temperature come.

2.10 At works with power supply units carrying is forbidden to rings by metallic or conductive jewelry like chains,

bracelets, or the like.

2.11 Power supply units aren't allowed for the application at people or animals.

2.12 Critical tensions (> 35 VDC) are caused at the series connection of the exits of one or several power supply

units.

2.13 Ventilation slits of power supply units may not be covered! The pieces of equipment have to be moved to

hard, heavily inflammable documents so that the air can unhinderedly enter the pieces of equipment. The

cooling of the pieces of equipment is made by forced ventilation.

2.14 Power supply units and the attached consumers may not be operated for unbeaufsichtigt. It is (measures z

to the protection and the safeguarding of the attached consumers opposite effects of the power supply units.

B. overloads, failure of the power supply unit) and meet effects and going out dangers (e.g. inadmissibly high

current consumption) of the consumers this one.

Respect! Sensitive consumers must in addition be protected from destruction by external measures!

2.15

In the fault case power supply units can give V direct voltage to tensions over 50 of which dangers start out,

also then if the given output voltages of the pieces of equipment lie more lowly.

2.16 At works under tension tool only allowed particularly for this may be used.

2.17 (the exits of the power supply units/and lines attached to this must be protected from direct touch output

jacks-stick). The used lines must have a sufficient isolation or tension strength and be touch sure the contact

points (safety sockets) to this.

2.18 Transferring metallicly shiny lines and contacts has to be avoided. All these places have to be covered by

suitable, heavily inflammable insulants or other measures and protected which from direct touch. The

electrically leading parts of the attached consumers also have to be protected from direct touch by

corresponding measures.

2.19 To be assumed has that a safe business is no longer possible, it is to put apart from business and to

safeguard against unintentional business the piece of equipment so if. It has to be assumed, that a safe operating

no longer possible if:

Produkt Specifikationer

Mærke:	Statron
Kategori:	Ikke kategoriseret
Model:	3250.1

Har du brug for hjælp?

Hvis du har brug for hjælp til Statron 3250.1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Statron Manualer

Statron 2256.1 Manual

3 Oktober 2025

Statron 3252.1 Manual

2 September 2024

Statron 3250.1 Manual

2 September 2024

Statron 2225.4 Manual

2 September 2024

Statron 2225.2 Manual

2 September 2024

Statron 5359.3 Manual

2 September 2024

Statron 3254.1 Manual

2 September 2024

Statron 3262.1 Manual

2 September 2024

Statron 2223.2 Manual

2 September 2024

Statron 2224.9 Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Kenwood Elegancy ZJP11 Manual

4 Oktober 2025

Fisher & Paykel VB30SPEX3 Manual

4 Oktober 2025

Falmec Level One Manual

4 Oktober 2025

StarTech.com TBLT3MM2M Manual

3 Oktober 2025

Fisher & Paykel VB30SDEI3 Manual

3 Oktober 2025

Fisher & Paykel WB76SPEX3 Manual

3 Oktober 2025

Realme Q5 Manual

3 Oktober 2025

Lumantek ez-Pro VS4 Manual

3 Oktober 2025

Fisher & Paykel EB76PSX3 Manual

3 Oktober 2025

Inkbird ISC-027BW Manual

3 Oktober 2025