Statron 2225.2 Manual

Statron Ikke kategoriseret 2225.2

Læs gratis den danske manual til Statron 2225.2 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Statron 2225.2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Operating instruction lab

power supply unit

type 2225.2

The intended application of the power supply unit covers:

- link and operation of low-voltage consumers with an operating voltage between 0 and 24 VDC. The power input of

the consumer may not exceed 6,0 A.

Note! Absolutely read!

- Read this guidance exactly. With damage, which is caused by neglect of the guidance, the warranty claim goes

out. For damages we do not take over adhesion.

1. introduction

this power supply unit is universally applicable with its infinitely variable adjustment possibilities of voltage and

current for school, occupation, hobby etc.. An electronic current limiting protects the power supply unit against

overloading. Output voltage and - current are electronically stabilized and infinitely variable adjustable. Thus the

electronic restraint current can as adjustable Current limiting to be used, in order to protect consumers against a too

high power input. In the case of an overloading the output voltage is then lowered accordingly (in the case of short-

circuit on close 0V). With removal of the overload the output voltage adjusted before resets itself automatically. The

respective operating point - voltage - (u) - or restraint current (i) - is displayed by one red LED each. The adjusted

values are readable over 2 LCD displays or analog displays each. The voltage or current adjustment is made by one

double button each (rough- fine). Additionally a change .

2. Safety notes

2,1 the power supply unit is in safety class system I as well as in accordance with VDE 0411 and VDE 0805 (EN60950)

structured. The supply transformer is structured and with 3,75 kVeff is primarysecondarily checked according to

DIN VDE 0551 as safety insulating transformer. It is radio-screened in accordance with VDE 0875T11 curve B. Es

is equipped with a VDE checked main with protective grounding and may therefore only to 230-V-

Wechselspannungsnetzen with protective grounding be operated or attached.

2,2 it is to be made certain that protective grounding (yellow/green) is interrupted neither in the main nor in the device or

in the network, since with interrupted protective grounding mortal danger exists. It is to be made certain further that

the isolation is damaged nor destroyed neither.

2,3 power supply units do not belong into child hands!

2,4 in commercial mechanisms is to be considered the rules for the prevention of accidents of the federation of the

commercial Berufgenosssen schaften for electrical system and resources.

2,5 in schools, training facilities, hobby and self-help workshops. is by hand possible for

2,6 when opening covers or removing from sections, except if this, can live sections be opened. Also interface can be

live. Before an alignment, maintenance, a repair or an exchange of sections the device must be separate from all

voltage supplies, if opening of the device is necessary. If thereafter an alignment, maintenance or a repair at the

opened device under voltage are inevitable, may take place only by means of a specialist, who is familiar with the

associated dangers or the relevant regulations for it.

2,7 condensers in the device can be still loaded, even if the device were separated from all voltage supplies.

2,8 it is to be guaranteed that only protections of the indicated type and the indicated call stromstraerke are used as

back-up. The use of repaired protections or bridging the fuse holder is illegal. The device is overload-proof and

short-circuit-protected. When burning the input protection through a serious error is therefore present, which must

be eliminated by a specialist, before the new intact protection can be used by this specialist.

2,9 switching it your power supply unit never equivalent if it is brought by a cold into a warm space. The condensation

developing thereby can destroy your device under unfavorable circumstances. Let the device unein switched to

room temperature come. carrying of metallic or conductive decoration is forbidden to

2,10 with work with power supply units such as chains, bracelets, rings or the like.

2,11 power supply units are not certified for application at humans or animals.

2,12 during the series connection of the outputs one or several power supply units is produced lethal voltages (>35

VDC).

2,13 louvers of power supply units may not be taken off! The devices are on hard to place with difficulty inflammable

documents so that air can occur the devices unhindered. The cooling of the devices takes place predominantly via

convection.

2,14 power supply units and the attached consumers may not be operated unsupervised. Measures are to be taken to

the protection and the protection of the attached consumers in relation to effects of the power supply units (e.g.

overvoltages, failure of the power supply unit) and the effects and dangers outgoing from the consumers

themselves (e.g. illegally high power input). Note! Sensitive consumers must be protected additionally by external

measures against destruction!

2,15 in the event of an error can deliver power supply units voltages over 50 V DC voltage, from which dangers

proceed, also then if the indicated output voltages of the devices lower is situated.

2,16 with work under voltage for it expressly certified tools may be only used.

2,17 the outputs of the power supply units (exit hub/clamps) and to it attached lines must be protected against direct

contact. In addition the used lines must sufficient isolation or tension strain possess and the contact points be

contact-voltage-proof (safety sockets).

2,18 shifting metallically bright lines and contacts is to be avoided. All these places are by suitable to take and to protect

thus against direct contact with difficulty inflammable insulants or other measures off. Also the electrically leading

sections of the attached consumers are to be protected by appropriate measures against direct contact.

2,19 if to assume it is that a safe operation is no longer possible, then is the device out of operation to set and against

unintentional operation protect. It is to be assumed that a safe operation is no longer possible, if - the device or the

mains cable visible damages indicates, - the device any longer does not operate, - after longer storage under

unfavorable conditions, - after heavy transport stresses.

Produkt Specifikationer

Mærke:	Statron
Kategori:	Ikke kategoriseret
Model:	2225.2

Har du brug for hjælp?

Hvis du har brug for hjælp til Statron 2225.2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Statron Manualer

Statron 2256.1 Manual

3 Oktober 2025

Statron 3252.1 Manual

2 September 2024

Statron 3250.1 Manual

2 September 2024

Statron 2225.4 Manual

2 September 2024

Statron 2225.2 Manual

2 September 2024

Statron 5359.3 Manual

2 September 2024

Statron 3254.1 Manual

2 September 2024

Statron 3262.1 Manual

2 September 2024

Statron 2223.2 Manual

2 September 2024

Statron 2224.9 Manual

2 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Kenwood Elegancy ZJP11 Manual

4 Oktober 2025

Fisher & Paykel VB30SPEX3 Manual

4 Oktober 2025

Falmec Level One Manual

4 Oktober 2025

StarTech.com TBLT3MM2M Manual

3 Oktober 2025

Fisher & Paykel VB30SDEI3 Manual

3 Oktober 2025

Fisher & Paykel WB76SPEX3 Manual

3 Oktober 2025

Realme Q5 Manual

3 Oktober 2025

Lumantek ez-Pro VS4 Manual

3 Oktober 2025

Fisher & Paykel EB76PSX3 Manual

3 Oktober 2025

Inkbird ISC-027BW Manual

3 Oktober 2025