Telmor ASR Classic 5G Protected Manual

Telmor TV antenne ASR Classic 5G Protected

Læs gratis den danske manual til Telmor ASR Classic 5G Protected (4 sider) i kategorien TV antenne. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Telmor ASR Classic 5G Protected, eller vil du spørge andre brugere om produktet?

Side 1/4
GZT TELKOM
-TELMOR SP. Z O.O,
ul. Schuberta 104, 80-172 Gdańsk, Polska
tel. 58 739 59 59, e-mail: handlowy@telmor.pl, www.telmor.pl
ASR Classic 5G Protected
Instrukcja obsługi
User manual
antena DVB-T2
DVB-T2 antenna
Dziękujemy za zakup anteny „asr Classic 5G protected”. Antena posiada wbudowany przedwzmacniacz, który
gwarantuje możliwie najlepsze parametry, tak aby sygnał dostarczany do Państwa odbiornika DVB
-T/T2 był
najwyższej jakości. Poniższa instrukcja została przygotowana dla 2 typów anten ASR Classic 5G Protected: w
komplecie z ZZA-7 i bez.
Thank you for purchasing the „asr Classic 5G protected” antenna. The antenna has a built-in preamplifier that
guarantees the best parameters so that the signal delivered to your DVB-T/T2 receiver is of the highest quality.
The following instructions have been prepared for 2 types of ASR Classic 5G Protected antennas: complete
with ZZA-7 and without.
14.12.2023
IO 6542-0078-240
GZT TELKOM
-TELMOR SP. Z O.O,
ul. Schuberta 104, 80-172 Gdańsk, Polska
tel. 58 739 59 59, e-mail: handlowy@telmor.pl, www.telmor.pl
Standardowe wyposażenie anteny
1. Nakręcane złącze typu „F-RG6” (z uszczelką) x 1szt.
2. Instrukcja obsługi x 1szt.
3. Zasilacz i zwrotnica zasilająca typu ZZA-7 (w wersji z ZZA-7 w komplecie)
Sposób montażu anteny
Po zamocowaniu anteny na maszcie, odkręcić niebieskie pokrętła boczne o ok. 3,5 obrotu, rozłożyć reflektory
anteny na obie strony i zablokować je w tym położeniu używając ponownie pokręteł.
UWAGA !!! Wszystkie podłączenia należy bezwzględnie przeprowadzać przy odłączonych od sieci energetycznej urządzeniach
odbiorczych DVB-T/T2. Nieprzestrzeganie tej zasady może doprowadzić do uszkodzeń, które nie podlegają roszczeniom z tytułu
udzielonej GWARANCJI.
Sposób podłączenia anteny – „asr Classic 5G protected”
1. Do podłączenia anteny z odbiornikiem DVB-T/T2 stosować dobrej jakości kabel koncentryczny RG6 o
impedancji 75 Ohm. Zalecamy kable serii TT 113 Cu PVC PE w wersji zewnętrznej, które zapewnią długoletnią
pracę bez względu na warunki atmosferyczne.
2. Od strony anteny „asr Classic 5G protected” przygotować kabel koncentryczny ze złączem typu “F męskie”.
W przypadku stosowania innego typu kabla, należy zastosować dedykowany do niego typ złącza „F męskie”.
3. Kabel ze złączem “F-RG6” nakręcić na gniazdo typu “F” znajdujące się z tyłu belki anteny
4. Od strony odbiornika DVB-T/T2 zastosować złącze typu IEC męskie (złącze TV).
4a. W przypadku zakupu anteny ze zwrotnicą ZZA-7 w komplecie nie ma potrzeby nabywania dodatkowych
złącz gdyż zwrotnica została już wyposażona w złącze IEC męskie
5. Odbiornik DVB-T/T2 lub TV podłączyć do gniazda zasilania 230V, uruchomić urządzenie.
6. W przypadku gdy odbiornik DVB-T/T2, umożliwia zasilanie przedwzmacniacza napięciem 5V, nie trze-
ba stosować zwrotnicy ZZA-7 i zasilacza. Wystarczy zakupić wtyk IEC np. WKW lub WPW (odpowiedni dla
zastosowanego kabla antenowego), zamontować wtyk IEC i włożyć go do gniazda antenowego TV. Następnie
zgodnie z instrukcją odbiornika załączyć napięcie zasilania przedwzmacniacza (5V).
7. Uruchomić tryb wyszukiwania programów TV (cyfrowych naziemnych) w odbiorniku DVB
-T/T2 lub TV
Standard antenna equipment
1. Screw-on connector type „F-RG6” (with seal) x 1 pc.
2. User manual x 1pcs.
3. Power supply and power supply crossover type ZZA-7 (depends on version)
How to mount the antenna
After mounting the antenna on the mast, unscrew the blue side knobs by approximately 3.5 turns, unfold the
antenna reflectors on both sides and lock them in this position using the knobs again.
ATTENTION !!! All connections must be made with DVB
-T/T2 receiving devices disconnected from the power grid. Failure to
comply with this rule may result in damage that is not subject to claims under the WARRANTY.
Antenna connection method – „asr Classic 5G protected”
1. To connect the antenna to the DVB-T/T2 receiver, use a good quality RG6 coaxial cable with an impedance
of 75 Ohm. We recommend TT 113 Cu PVC PE series cables in the outdoor version, which will ensure long-
-term operation regardless of weather conditions.
2. From the antenna side, prepare a coaxial cable with an „F male” connector. If a different type of cable is
used, the „F male” connector type dedicated to it should be used.
3. Screw the cable with the “F-RG6” connector onto the “F” type socket located on the back of the “asr Classic
5G protected” antenna beam
4. On the DVB-T/T2 receiver side, use an IEC male connector (TV connector).
4a. If you purchase an antenna with a ZZA-7 diplexer, there is no need to purchase additional connectors
because the diplexer is already equipped with an IEC male connector.
5. Connect the DVB-T/T2 receiver or TV to the 230V power socket and turn on the device.
6. If the DVB-T/T2 receiver allows the preamplifier to be powered with 5V, there is no need to use the ZZA-7
crossover and power supply. Just buy an IEC plug, e.g. WKW or WPW (suitable for the antenna cable used),
install the IEC plug and insert it into the TV antenna socket. Then, according to the receiver’s instructions,
turn on the preamplifier supply voltage (5V).
7. Start the search mode for TV programs (digital terrestrial) in the DVB-T/T2 or TV receiver


Produkt Specifikationer

Mærke: Telmor
Kategori: TV antenne
Model: ASR Classic 5G Protected

Har du brug for hjælp?

Hvis du har brug for hjælp til Telmor ASR Classic 5G Protected stil et spørgsmål nedenfor, og andre brugere vil svare dig




TV antenne Telmor Manualer

TV antenne Manualer

Nyeste TV antenne Manualer