Walrus Audio Eons Manual


Læs gratis den danske manual til Walrus Audio Eons (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Walrus Audio Eons, eller vil du spørge andre brugere om produktet?

Side 1/4
For Eons, man has thought the sound of thunder to be
from the heavens above, echoing boastfully over us as
we stay safe from its greatness. However, legend tells of
a stoic and indomitable beast residing in the highest
mountains seen and heard only by the most brash of
travelers. With gnarled and twisted horns, this creature
emits a sound thicker than Earth’s crust to command
attention and warn all who stand in his way. This is Eons.
VOLUME
The Vol” knob sets the overall output
volume of the pedal. The Voltage” and
“Gain” controls are very interactive with
the overall output volume of the pedal,
so there is plenty of volume on tap to
compensate.
VOLTAGE
POWER STUFF
The Voltage” knob allows you to adjust the circuit’s
operating voltage. At its minimum, the main fuzz
section of the circuit will operate at around 3
volts, resulting in a “dying battery sound. At its
maximum, the main fuzz section of the circuit will
operate at around 18 volts, resulting in a more open
and less compressed sound with added bass.
As you cut the voltage, the pedal will begin to
produce a starved sound and have a brighter
frequency response. As you approach noon
on the “Voltage” control, the pedal will begin
to have a gating effect. Lower voltages will also
drastically reduce the output volume of the
pedal. This knob behaves slightly differently
across all the different modes.
Got questions or need a repair? Email help@walrusaudio.com to talk
with a real live human about your Walrus gear!
This product comes with a limited lifetime warranty.
Click Here for more info.
9 volt DC, Center Neg.
100mA min*
*The use of an isolated power supply is
recommended for powering all Walrus Audio Pedals.
Daisy chain power supplies are not recommended.
GAIN
The “Gainknob sets the
amount of gain applied to
your guitar signal passing
through the fuzz circuit. This
parameter is also highly interactive
with the “Voltage” knob. Pushing more
gain through the pedal at lower voltage settings
will result in grittier and dirtier sounds. Lower gain
settings at lower voltages will result in very starved
sounds. It can even cause the signal to cut out
completely at lower extremes, so adjust to taste!
BASS
TREBLE
The “Bass” knob allows you to cut or boost low
frequencies after the fuzz circuit. This can be
helpful for tightening up the low end or
increasing the low frequency emphasis. Starting
at noon, turn down to remove bass and turn up
to add bass.
The “Treble” knob allows you to increase
clarity in the high frequency region or tame
them depending on your amplifier and rig.
Like the bass control, you may find that
at higher gains you will want to add more
treble, and at lower gains you may
want to roll the treble back. Starting
at noon, turn down to cut out
highs and turn up to allow
more highs.
MODE SWITCH
The “Mode” switch is a five-position rotary
switch. Each position offers a different
combination of frequency response and clipping
style employed by the pedal. You can think of
each position as a different “flavorof the pedal.
Each position is described in more detail below.


Produkt Specifikationer

Mærke: Walrus Audio
Kategori: Ikke kategoriseret
Model: Eons

Har du brug for hjælp?

Hvis du har brug for hjælp til Walrus Audio Eons stil et spørgsmål nedenfor, og andre brugere vil svare dig