Aguilar OBP-3 Manual


Læs gratis den danske manual til Aguilar OBP-3 (6 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Aguilar OBP-3, eller vil du spørge andre brugere om produktet?

Side 1/6
To wire MN (1Z2Z) taper potentiometer, swap positions of the following wires: Bridge P.U. and Neck P.U.; Volume jumper and GND.
Value depends on pickups. Use values recommended by pickup manufacturer.
Inserting 1/4” plug applies power to OBP-3.
Pots shown rear view.
For single pickup, eliminate blend pot - wire pickup directly to volume pot.
GND
1Meg, 1/4W resistors optional,
they reduce switch click.
MID.SELECT switch can be a stand alone switch or part of the push-pull potentiometer. Wiring is the same in both cases.
To wire MN (1Z2Z) taper potentiometer, swap positions of the following wires: Bridge P.U. and Neck P.U.; Volume jumper and GND.
Value depends on pickups. Use values recommended by pickup manufacturer.
Inserting 1/4” plug applies power to OBP-3.
Pots shown rear view.
For single pickup, eliminate blend pot - wire pickup directly to volume pot.
GND
1Meg, 1/4W resistors optional,
they reduce switch click.
MID.SELECT switch can be a stand alone switch or part of the push-pull potentiometer. Wiring is the same in both cases.


Produkt Specifikationer

Mærke: Aguilar
Kategori: Modtager
Model: OBP-3

Har du brug for hjælp?

Hvis du har brug for hjælp til Aguilar OBP-3 stil et spørgsmål nedenfor, og andre brugere vil svare dig