W D CA I SARNING ANS UT ON
· Make sure is at the fuse boxPOWER COMPLETELY OFF
· Have your fixture installed by a qualified licensed electrician
· Prepare everything in a clear area
· Wear gloves at all times during this installation
· Read instructions carefully before you start assembly
· Keep this installation sheet for future reference
C DA:ANA 19054 28 - Sur V3Z 6Mth Ave., rey, C B 3
USA: 3035 E L i Rd. V s, N 1. one Mounta n - Las ega V 8908
TE CH N I C PO RTA L SU P
te cal pport lor .comchni su @a alighting
• T r f ar s u t out t et a ot he impo tant sa egu ds and in tr c ions lined in his she c nn
cov l c m ccer all possib e onditions and tsitua ions that ay o ur. t I must be
unde ood ion and tain ol ed.rst that caut erc are fa torsc c must be f low These
in ions ided y and high endstru tcar rove p fo yor ur safet we l cy re omm that a
li ensed, ined e trician in tall nic tra l ce s this u t.
• T ur t ou t orre t sta sta arhis fixt e is designed o be m n ed on a c c ly in lled nd d
rou o o throu r box ith a e r T box nd or ctagon b x OR gh a wi ing w a pl st r f ame. he
mu sec oun ed ding.st be ure yl m t to the e he st turruco tf buil The ossb rcar and
ha sho be he her ware sud pplied u ld used, dire t y ou tc l m n ing t fixture to t o
bo a ke e to orre t t ure.x my ma it impossibl c c ly align he fixt
A LSSEMB Y TRU ONINS CTI S
Remove fixture from its original package.
Separate mounting plate (1c) from fixture (2a) by removing washers
(2c) and fixture screws (2b).
Attach mounting plate (1c) to electrical junction box (1a) using junction
box screws provided (1e) in hardware package.
Secure mounting plate (1c) to mounting surface with anchors (1f) and
Make proper electrical connections (black neutral to hot white “L”, to
“N”, ground to “GND”) with wire nuts (1b) provided in hardware
Attach fixture (2a) to mounting plate (1c) with washers (2c) and fixture
Install the recommended lamp (4a) (not provided) (referred on the
socket label for maximum wattage and type) to fixture socket. Attach
fixture glass (3a) to fixture (2a).
To prevent moisture from entering the electrical junction box (1a) and
causing a short, seal around the top and side perimeter between the
fixture and the wall surface with weather resistant caulking (Illustration
1). The space at the bottom should be left un-caulked to prevent
You are now ready to enjoy your fixture.
