Alpine RUX-H02 Manual

Alpine Fjernbetjening RUX-H02

Læs gratis den danske manual til Alpine RUX-H02 (3 sider) i kategorien Fjernbetjening. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Alpine RUX-H02, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
12S21070J91-0
WARNING
This symbol means important instructions. Failure to follow
them can result in serious injury or death.
DO NOT DISASSEMBLE OR ALTER.
Doing so may result in an accident, re or electric shock.
KEEP SMALL OBJECTS SUCH AS BATTERIES OUT OF THE REACH OF CHILDREN.
Swallowing them may result in serious injury. If swallowed, consult a
physician immediately.
DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY
DRIVING YOUR VEHICLE.
Any function that requires your prolonged attention should only be
performed a er coming to a complete stop. Always stop the vehicle in
a safe location before performing these functions. Failure to do so may
result in an accident.
KEEP THE VOLUME AT A LEVEL WHERE YOU CAN STILL HEAR OUTSIDE NOISE WHILE
DRIVING.
Failure to do so may result in an accident.
Do not ingest battery, Chemical Burn Hazard.
e remote commander contains a coin/ button cell battery. If the coin/
button cell battery is swallowed, it can cause severe internal burns in
just 2 hours and can lead to death. Keep new and used batteries away
from children. If the battery compartment does not close securely, stop
using the product and keep it away from children. If you think batteries
may have been swallowed or placed inside any part of the body, seek
immediate medical attention.
CAUTION
This symbol means important instructions. Failure to follow
them can result in injury or material property damage.
DO NOT MIX NEW BATTERIES WITH OLD BATTERIES. INSERT WITH THE CORRECT BATTERY
POLARITY.
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions. When inserting the batteries,
be sure to observe proper polarity (+ and –) as instructed.
Handling Precautions
Do not drop or apply shock to the unit. It may get permanently
damaged.
Keep the unit away from water and moisture, direct sun and heat, and
excessive dust.
Never use scouring pads, steel wool, abrasive powders or harsh
chemical agents, such as lye solution, for cleaning.
Clean with a soft, lint-free cloth or cotton swab slightly dampened
with a mild solution of detergent and water.
Do not operate this unit in a manner that could distract you from
driving safely.
Installation of Remote Control Holder
Do not leave the remote control mounted on the holder, if it is direct
sunlight. Remove the remote control from the holder and put it in the
glove compartment.
If double-sided adhesive tape cannot install the holder securely, use
screws.
When mounted to the Display Audio, do not press the unit hard to
operate it. The Display Audio may be damaged.
ALPINE WIRELESS KNOB
RUX-H02
Supported models
This product connects to the following models.
iLX-507/iLX-F509/iLX-F511/i509
And This product can also be mounted on the iLX-F509/F511. Check P3 for details.
1500 Atlantic Blvd,
Auburn Hills, Michigan 48326 U.S.A.
Phone 1-800-ALPINE-1 (1-800-257-4631)
- 2 -
Attachment
RUX-H02 Mounting Bracket1 Mounting Bracket2
x1 x1 x1
Battery Screw1 Screw2
(CR2032)
x1 x2 x2
Location of Controls
(1) (3)
(2)
(1) LED Indicator
It turns on when the unit is connected/operated.
(2) Rotary Knob
To turn the volume up and down, respectively.
(3) Lid
Turn counter-clockwise to open the lid.
Connecting the unit
1. Insert the battery using the following procedure:
* Ensure the positive (+) side faces up as shown in the illustration
below.
When the battery is set, the unit enters the connection standing-by
mode. While the LED is  ashing, perform the procedure in Step 2.
If the LED turns o while performing the procedure in Step 2, press
the Rotary Knob. The LED starts  ashing again.
2.
Follow this procedure to connect the RUX-H02 to the Display
Audio unit.
1) Select [Setup].
2) Select [Device], then [Device List].
3) Select [Add New Device].
4) Select [ALPINE KNOB].
5) Select [YES] when the screen below is displayed.
MEMO
When the Display Audio is o for a certain period of time, the unit
is disconnected.
The unit is reconnected automatically when the Display Audio is
turned on and the Rotary Knob is operated.
* It may take some time for the unit to reconnect in some situa
tions.

Produkt Specifikationer

Mærke: Alpine
Kategori: Fjernbetjening
Model: RUX-H02

Har du brug for hjælp?

Hvis du har brug for hjælp til Alpine RUX-H02 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Fjernbetjening Alpine Manualer

Alpine

Alpine RUE-4190 Manual

12 Januar 2023
Alpine

Alpine RUE-4360 Manual

28 December 2022
Alpine

Alpine RUE-4191 Manual

21 December 2022
Alpine

Alpine RUX-H02 Manual

17 December 2022
Alpine

Alpine RUE-M300 Manual

20 Oktober 2022

Fjernbetjening Manualer

Nyeste Fjernbetjening Manualer

Absima

Absima CR7P Manual

29 September 2025
Insignia

Insignia NS-RMTSNY21 Manual

29 September 2025
Insignia

Insignia NS-RMT8D21 Manual

29 September 2025
ProMaster

ProMaster PRO5439 Manual

29 September 2025
Insignia

Insignia NS-RMTVIZ21 Manual

29 September 2025
ProMaster

ProMaster PRO7599 Manual

29 September 2025
ProMaster

ProMaster PRO1782 Manual

29 September 2025
ProMaster

ProMaster PRO7337 Manual

29 September 2025
ProMaster

ProMaster PRO7606 Manual

29 September 2025
Neets

Neets 310-0350 Manual

29 September 2025