Atlas Sound FAP42T-UL2043 Manual

Atlas Sound Højttaler FAP42T-UL2043

Læs gratis den danske manual til Atlas Sound FAP42T-UL2043 (1 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 57 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 29 anmeldelser. Har du et spørgsmål om Atlas Sound FAP42T-UL2043, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/1
Ceiling Material up to 2"
Tile
Bridg
e
Auxillary
Suspension
Point
Dog Leg
In Inverted
Ceiling Material up to 1
1
/
4"
Tile
Bridge
Auxillary
Suspension
Point
Dog Leg
In Normal
Position
FAP42T-UL2043
Installation
Instructions
ATS003117 RevA 5/08
FAP42T-UL2043
Installation Instructions
Mounting Template
9" Diameter
The Atlas Sound Strategy Series
®
II assembly mounts easily into existing
construction drop ceiling or drywall materials
Painting Shield
8
1
⁄2" Diameter
Drop Tile Ceiling Installation
1. Remove 2' 2' or 2' 4' tile. x x
2. Align adjustable dual rail -ring assembly on rear of tile& C in
desired position.
3. Using template provided mark cutout circle with marker and cut hole. (9" FAP42T-UL2043)
4. Affix C-ring assembly to rails using screws provided and position assembly on rear of ceiling tile.
Replace tile into grid making sure that formed ends of tile bridge rails engage T-bar tile support rails.
5. Bring service loop from rear of tile, through tile bridge C-ring to access panel located on side of
enclosure. Terminate the service loop to Phoenix style connector provided (please note polarity). Combination knockouts are
provided to facilitate conduit.
6. Insert enclosure through front of tile. Using standard #2 Phillips screwdriver or screw-gun, tighten dogleg four
assemblies until they engage C-ring assembly. DO NOT OVER-TIGHTEN DOG LEG SCREWS!
7. Adjust front mounted switch to desired wattage tap setting or 8 Ω* (See important note regarding 8 operation) Ω
8. Install press-fit grille into front bezel ring. Push baffle upwards until baffle is flush with bezel ring.
9. For safety and seismic considerations a suspension ring is integrated into input panel section of unit. Atlas Sound strongly suggests
that a support wire be installed from this support point to a suitable anchor point above ceiling grid. In drop tile applications, this wire
can usually be installed from an adjacent tile access near speaker location.
Dry Wall ("Hard Deck") Installation
1. Using template provided, mark cutout circle in desired mounting location and cut hole. (9" FAP42T-UL2043)
2. Place tile bridge rails and C-ring through hole. Use V shaped edge of C-ring to align tile bridge assembly above ceiling (alignment screws -
provided are not required for this type of installation)
3. Bring service loop from through the tile bridge C-ring to access panel located on side of the enclosure. Terminate service loop to Phoenix style /
connector provided (please note polarity). Combination knockouts are provided to facilitate conduit.
4. Insert enclosure into hole. Using standard #2 Phillips screwdriver or screw-gun, tighten dogleg assemblies until they engage the C-ring assembly.four
DO NOT OVER-TIGHTEN DOG LEG SCREWS!
5. Adjust front mounted switch to desired wattage tap setting or 8 Ω* (See important note regarding 8 operation)Ω
6. Install press-fit grille into front bezel ring. Push baffle upwards until baffle is flush with bezel ring.
New Construction (Darywall Ceilings)
Use of optional FAP42-TR
1
(for use with FAP42T ) new construction bracket essentially reserves speaker mounting location prior to drywall installation in-UL2043 new
construction. Bracket mounts between 16" or 24" OC studs and includes a
3
⁄ " 8 downward lip to provide a template for drywall installers to cut around. For final
installation, please follow instructions below.
Note: tile bridge components are not used in new construction applications where new construction bracket is utilized.
1. Bring service loop through hole in ceiling provided by pre construction bracket to access panel located on side of Enclosure.
Terminate service loop to Phoenix style connector provided (please note polarity). Combination knockouts are provided to facilitate conduit.
2. Insert speaker assembly into hole. Using standard #2 Phillips screwdriver or screw-gun, tighten four dog leg assemblies until they engage
ring provided on new construction bracket. DO NOT OVER-TIGHTEN DOG LEG SCREWS!
3. Adjust front mounted switch to desired wattage tap setting or 8 Ω* (See important note regarding 8 operation) Ω
4. Install press-fit grille into front bezel ring. Push baffle upwards until baffle is flush with bezel ring.
Typical rallel Hookup of Full nge 70.7/100V SpeakersPa Ra
1 2
3 4 5 6 master
power
power
Inpu
t
+
-
Typical 120Watt 70.7V Output
Tap ttage tal 64 ttsWa To : Wa
Amplifier
16W @ 70.7V
Full ngeRaFull ngeRaFull ngeRa
16W @ 70.7V16W @ 70.7V
FAP42T-UL2043 FAP42T-UL2043 FAP42T-UL2043 P42T-UL2043FA
-
+ +
-
+
Full ngeRa
16W @ 70.7V
-
+
-
1
FAP42-TR Has not been evaluated by UL Laboratories
NOTE: Dog legs will accommodate ceiling material thickness up to 1
1
⁄ 4" as shipped from factory.
For thicker ceiling materials (up to 2") simply unscrew and flip dog legs as shown.
DO NOT OVER-TIGHTEN DOG LEGS IN EITHER CONFIGURATION!
NOTE: UL recognized conduit clamp must be used for conduit
connections. Cable connection cavity is not intended to be used
as a junction box.
FREQUENCY RESPONSE: 70 Hz - 20 kHz SENSITIVITY: 88 dB (1 W/1 M)
NOTE: *DO NOT USE 8 Ω SETTING WITH 70.7V/100V SYSTEMS! *DO NOT
OVERPOWER IN 8 CONFIGURATION! AMPLIFIER OUTPUT SHOULD NOT Ω
EXCEED 16 W RMS @ 8 PER SPEAKERΩ
ATS003117 RevA 5/08

Produkt Specifikationer

Mærke: Atlas Sound
Kategori: Højttaler
Model: FAP42T-UL2043

Har du brug for hjælp?

Hvis du har brug for hjælp til Atlas Sound FAP42T-UL2043 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Atlas Sound Manualer

Atlas Sound

Atlas Sound PM4FA-B Manual

20 September 2025
Atlas Sound

Atlas Sound MLE-3T Manual

19 September 2025
Atlas Sound

Atlas Sound FS12T-99 Manual

18 September 2025
Atlas Sound

Atlas Sound HT327 Manual

9 Juni 2025
Atlas Sound

Atlas Sound IP-8SM Manual

28 December 2024
Atlas Sound

Atlas Sound IP-SDM Manual

21 August 2024
Atlas Sound

Atlas Sound M1000-W Manual

21 August 2024
Atlas Sound

Atlas Sound I8SM+ Manual

21 August 2024
Atlas Sound

Atlas Sound PM8GD-B Manual

21 August 2024
Atlas Sound

Atlas Sound SMA-15 Manual

21 August 2024

Højttaler Manualer

Nyeste Højttaler Manualer

Energy Sistem

Energy Sistem TempoRave Manual

11 December 2025
RCF

RCF C 5215-W MKIII Manual

10 December 2025
RCF

RCF X 28 L Manual

10 December 2025
Fostex

Fostex PM0.4d Manual

8 December 2025
Amphion

Amphion Argon 3LX Manual

8 December 2025
Amphion

Amphion Argon 7LX Manual

8 December 2025
Fostex

Fostex PM0.3 Manual

8 December 2025
Fostex

Fostex US300 Manual

8 December 2025
JBL

JBL 8128 Manual

7 December 2025
FiiO

FiiO SP5 Manual

7 December 2025