AXESS AXFD-PTT Manual


Læs gratis den danske manual til AXESS AXFD-PTT (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 72 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 36.5 anmeldelser. Har du et spørgsmål om AXESS AXFD-PTT, eller vil du spørge andre brugere om produktet?

Side 1/4
AXFD-PTT
I N S T A L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2022 METRA ELECTRONICS CORPORATION REV. 4/8/22 INSTAXFD-PTT
SYNC BYPASS HARNESS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors
or
• Solder gun, solder, and heat shrink
• Tape
• Wire cutter
• Zip-ties
TABLE OF CONTENTS
Connections .........................................................2-3
FORD SYNC BYPASS HARNESS FOR 2010-2014
APPLICATIONS
• Provides the connection for your Push to Talk (PTT) button on the
steering wheel.
• Retains the PTT button on the steering wheel for aftermarket radios.
Ford
Flex 2010-2012
Edge 2010-2010
Mustang 2010-2014
Expedition 2011-2014
(Vehicles equipped with 4-inch screen and SYNC is not being retained)
2
CONNECTIONS
• Connect the Gray/Red Gray/Red to the of the AXFD-PTT.
(FOR PROGRAMING REFER TO THE AXSWC instructions)
WHEN USING THE THE AXSWC:
WHEN USING A TURBO/TACTILE KIT:
Tape off
To Gray/Red wire of AXFD-PTT
• From the 24 pin connector, cut the Yellow/Red wire in half and tape off the half going to the 24 pin.
(See Tape off image below)
• Connect the other half of the Yellow/Red wire to the Gray/Red wire of the AXFD-PTT.
(See To Gray/Red wire image below)
• Once your connections are spliced you can now reconnect your interface and wait until the screen reads
SWC Configured
, and then test your aftermarket radio for proper operation.


Produkt Specifikationer

Mærke: AXESS
Kategori: Ikke kategoriseret
Model: AXFD-PTT

Har du brug for hjælp?

Hvis du har brug for hjælp til AXESS AXFD-PTT stil et spørgsmål nedenfor, og andre brugere vil svare dig