Chapin 20003 Manual

Chapin Ikke kategoriseret 20003

Læs gratis den danske manual til Chapin 20003 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 44 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 22.5 anmeldelser. Har du et spørgsmål om Chapin 20003, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

6-4566

Four Position Nozzle

Boquilla de 4 posiciones

Buse à 4 positions

1. Hose to Tank

2. Nozzle / Extension Wand

Attach nozzle to shut-off handle or extension wand per

Fig. 2A-2D depending on the style of extension wand

included with sprayer.

3. Filter

The ﬁlter helps prevent clogging while spraying. It is located on the end of the outlet tube

inside your sprayer tank.To clean ﬁlter, remove the discharge assembly from the tank (Fig.1A).

Make sure the ﬁlter is positioned at the bottom of the tank as pictured (Fig. 3A).

Note: Filters are not supplied with deck sprayers.

1) Check tightness of hose nut to be sure hose is securely attached to the tank outlet. Do:

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are found, replace hose before

using. Replace with original manufacturer’s parts only.

3) Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and exterior of tank for signs of Do:

deterioration of body and bottom. Any sign of deterioration indicates possible tank weakening and could result in explosive

bursting under pressure. If any of these signs are found, discard tank immediately and replace. Do not attempt to patch leaks,

etc., as this could result in serious injury.

4) Follow Filling, Pressurizing and Spraying Instructions, except use water only (Pump plunger 10-20 strokes and inspect Do:

for leaks).

5) Direct shut-off away from you and open to make sure discharge is not clogged. Do:

6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank, and proceed with Filling,

Pressurizing and Spraying Instructions.

7) Inspect all metal parts including the wand, nozzle and ﬁttings for rust, corrosion and pitting. If any of these conditions Do:

are found, replace affected part with original manufacturer’s part before using.

5. Pre-Use Check

6. Filling

1) Turn pump handle counterclockwise and remove pumpDo:

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Fill tank to no more than the proper gallon marker. Do NOT: overﬁll to accommodate pump.Do:

4) Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and tighten securely. Do:

8. To Release Pressure

Sprayers with no pressure release valve

Do: With pump facing away, turn locked handle counterclockwise until air

begins to escape. Stop turning handle when you hear air escaping.

Do: Point pump away until all air has escaped.

015646R0322

Discharge/ Tool Holder Assembly

• Insure the tool holder is assembled to the tank adapter before mounting the discharge assembly (Fig.1A).

The Tool Holder snaps into the groove of the tank adapter. Figure 1D shows how the shield and cup are mounted

(Not all models are provided with tool holder, spray shield and measuring cup).

• Insert the outlet tube portion of the discharge assembly into the tank adapter (Fig. 1A).

• Firmly insert the outlet tube portion into the tank adapter (Fig. 1B) leaving no gap between the tank adapter and outlet

tube adapter. Firmly tighten the retaining nut to the tank adapter (Fig. 1C).

To prevent hose from blowing off, hose must cover both barbs on the outlet tube adapter and

touch ﬂange (Fig. 1B) before hose nut is securely tightened (Fig. 1C).

Retaining Nut -

Securely tightened.

Tool

Holder

Measuring

Cup

Spray

Shield

Tool

Holder

Outlet

Tube

Dis-

charge

Assembly

Filter

4. Shield Attachment to Wand

Snap shield onto wand as shown. Using the spray shield will help protect your plants etc.

from over spray. (Not all models are provided with spray shield).

Parts, Piezas, Pièces

6-2001

Hose Kit

Juego de manguera

Nécessaire de tuyau

6-5364

Measure Cup

Taza para medir

Tasse à mesurer

6-5385

Spray Shield

Pantalla de pulverización

Bouclier de pulvérisation

7. Pressurizing and Spraying

Do: Turn handle

clockwise to tighten.

Push handle down,

turn 1/4 turn counter-

clockwise to release.

Do: Push handle, down,

turn 1/4 turn clockwise

to lock. Begin spraying.

Re-pump sprayer as

required to maintain

spray force.

Do: Pump until you

feel resistance.

Do: Turn end of nozzle

to adjust spray pattern.

010842

Tool Holder

Soporte para la herramienta

Porte-outils

No Gap

Tank

Adapter

Outlet

Tube

Adapt

6-3337

Straps

Tirantes

Sangles

6-6003

Nozzle

Boquilla

Buse

301120-4

Fan Nozzle

(brass tip)

Boquilla

Buse

3-4843

Fan Nozzle Pack

Paquete de boquilla a chorro

Ensamble de buse à jet éventail

Filter

11. Troubleshooting - Tank pressurizes but does not spray.

WARNING: Release pressure in tank before troubleshooting.

Clean shut-off (Fig. 11A- 11D)

10. Fatigue-Free Spraying

For constant spraying, push down on shut-off handle and move grey locking

mechanism away from you. To release, squeeze handle and move the grey locking

mechanism back towards you. ( Not all models are provided with this feature).

Red,

Fine spray for

ﬁner washes

Blue,

Medium spray for

sealers

Yellow,

Course spray for semi-

transparent stains

Attach cap to shut-off handle or extension wand (Fig. 2F-2G).

1 piece style

Deck Sprayers Only (Fig. 2E-2G)

Insert nozzle into cap (2E).

10A

Locking

mechanism

Sprayers with pressure release/relief valve

Fig. 8A: Lift and hold the cap OR, turn the valve slowly counterclockwise

until air is completely exhausted.

Fig. 8B: Pull up stem until air is completely exhausted.

Fig. 8C: Pull ring out until air is completely exhausted.

Do: Point valve away from you when releasing pressure.

6-7756

Extension wand (brass)

Vara de extensión

Lance de rallonge

6-7749

Extension wand (poly)

Vara de extensión

Rallonge

301272-1

Nozzle

(brass tip)

Boquilla

Buse

2B 2C

8C8C

6-46456-8156

Relief Valve

Válvula de descarga de presión

Soupape de décompression

6-8258 6-4648

Sk-1154-1

WARNING: Improper use or failure to follow instructions can result in explosive failure causing serious eye or

other injury. For safe use of this product you must read and follow all instructions. Do not leave a pressurized sprayer

in the hot sun. Heat can cause pressure build-up resulting in possible explosion. Do not store or leave solution in tank

after use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when spraying. Never

use any tool to remove pump if there is pressure in sprayer. Never stand with face or body over top of tank when

pumping or loosening pump to prevent ejecting pump assembly and/or solution from striking and injuring you. Never

pressurize sprayer by any means other than the original pump. Do not attempt to modify this sprayer. Replace parts

only with manufacturer’s original parts. Never spray ﬂammable, caustic, acidic, chlorine, bleach or other corrosive

solutions or heat, pressure, or gas producing chemicals. Always read and follow chemical manufacturer’s

instructions before use with this sprayer as some chemicals may be hazardous when used with this sprayer.

WARNING

6-2000

Shut-off Handle

Mango de cierre

Poignée du robinet

Congratulations!

You have just purchased a quality Chapin product.

Call us @ 1-800-950-4458 or www.chapinmfg.com

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

6-1925

Repair Kit (not included)

Juego de reparación (no incluido)

Kit de réparation (non inclus)

WARNING

Insert notches

from underside of

handle into plunger

grooves and turn

counterclockwise.

Tighten plunger clockwise until

ﬂush to top of shut-off body.

Do not over-tighten or unit may

not spray. Slide forks under

plunger, push handle down

until it snaps into place.

11B

Pull handle

straight up.

11A

Handle

11D

Plunger ﬂush

with body

Clean Nozzle Assembly (Fig. 11E)

Remove nozzle cap. Clean and re-assemble.

11E

Remove plunger, diaphragm

and spring. Wash diaphragm

with mild detergent.

Reassemble: Hold shut-off

upright as shown, place spring

in hole, place diaphragm on

top of spring. Reassemble

plunger and tighten.

11C

Plunger

Spring

Diaphragm

9. Care, Storage and Maintenance

1) Follow chemical manufacture’s instructions for cleaning. Rinse thoroughly with recommended solvent. Do:

Follow Filling, Pressurizing and Spraying Instructions, except pump unit only 8-10 strokes. Be sure that the wand

and nozzle are thoroughly rinsed after each use.

2) Do: Open shut-off and allow water to run through discharge assembly.

3) Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer. Do:

4) Store sprayer tank upside down, with pump removed, in a warm dry location. Do:

5) Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening in cover.Do:

P.O. Box 549 700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.1-800-950-4458 www.chapinmfg.com

Produkt Specifikationer

Mærke:	Chapin
Kategori:	Ikke kategoriseret
Model:	20003

Har du brug for hjælp?

Hvis du har brug for hjælp til Chapin 20003 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Chapin Manualer

17 September 2025

27 August 2025

27 August 2025

26 August 2025

26 August 2025

22 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

WALI PM-003-W Manual

3 November 2025

Beverage-Air Horizon HRP3HC-1HG Manual

3 November 2025

ANCEL FX4000 Manual

3 November 2025

Intermatic OP2GY18 Manual

3 November 2025

Hillvert HI-LJE-111 Manual

3 November 2025

Phoenix Contact AXL F DI32/1 1F Manual

3 November 2025

ANCEL FX3000 ELITE Manual

3 November 2025

Unilux NYMPHEA Manual

3 November 2025

MSW PRO-E 20 Manual

3 November 2025

Ikea HOTELLRUM 305.780.28 Manual

3 November 2025