Denver CAP-4300 Manual

Denver Modtager CAP-4300

Læs gratis den danske manual til Denver CAP-4300 (10 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 20 anmeldelser. Har du et spørgsmål om Denver CAP-4300, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/10
HIGH EFFICIENCY POWER AMPLIFIER
OWNER'S MANUAL
CAR AUDIO SYSTEM
PLEASE READ CAREFULLY BEFORE INSTALLING OR OPERATING THIS UNIT
CAP-4300
WARNING
Make sure you choose a suitable place to mount the unit. The position should be completely dry
with a good circulation of air, and from a mechanical point of view very stable.
ENG-1
System planning
Proper system planning is the best way to
maximize your amplifier performance. By
planning your installation carefully you can
avoid situations where the performance of the
reliability of your system is compromised. Your
authorized dealer has been trained to
maximize your system's sonic potential. Your
dealer is a valuable resource in helping you
with your system design and installation.
Speaker requirements
Each channel of your amplifier can easily drive
4 speaker loads when used in the stereo Ω
mode. When a channel-pair is bridged, the
recommended minimum load impedance is 3 Ω
for subwoofer use, and 4 for full range Ω
operation. Although operation with lower
impedances is not likely to cause immediate
damage to the internal circuitry, the unit will
most likely overheat, causing the thermal
protection circuitry to shut down the amplifier.
When the chassis cools down, normal
operation will resume. Continuing to operate
the amplifier under these conditions is not
recommended and will reduce its life
expectancy.
Most speakers designed for car audio
operation are 4 impedance. Connecting two Ω
such speakers in parallel will result in a 2 Ω
impedance load as seen by the amplifier.
Some subwoofer models feature a dual 4 Ω
voice coil design. Connecting these voice coils
in parallel will result in a 2 nominal Ω
impedance, which is not recommended for use
with bridged channels of your amplifier.
Series wiring
Parallel wiring
Series/parallel wiring

Produkt Specifikationer

Mærke: Denver
Kategori: Modtager
Model: CAP-4300

Har du brug for hjælp?

Hvis du har brug for hjælp til Denver CAP-4300 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Modtager Denver Manualer

Denver

Denver CAP-4300 Manual

6 August 2024
Denver

Denver CAP-4320 Manual

11 August 2023

Modtager Manualer

Nyeste Modtager Manualer

CYP

CYP AU-A220 Manual

30 Juli 2025
Sirus

Sirus I-Amp 8.150T Manual

30 Juli 2025
AER

AER Colourizer 2 Manual

30 Juli 2025
Sirus

Sirus I-Amp 1.300T Manual

30 Juli 2025
PAC

PAC AP4-FD32 Manual

30 Juli 2025
CYP

CYP PUV-1540S-RX Manual

30 Juli 2025
ART

ART USB Dual Pre Manual

29 Juli 2025
SSL

SSL Pure Drive Quad Manual

29 Juli 2025
SSL

SSL Pure Drive Octo Manual

29 Juli 2025
CYP

CYP PUV-1550SRX Manual

29 Juli 2025