Warning: Before assembly of this ki t rea d through t he
complete a ssembly instructions st ep by step and note
all cautions
• Do not install the light in a damp, wet or
outdoor location.
• Do not pick up the light using the horizontal arm.
Always use the vertical arm to carry the light.
• Never posi tion the light by moving the weight.
Always use the horizontal arm holding the LEDs.
• Do not look directly i nto the light source.
• Do not interfere with the flat power cable visible in
the vertical and horizontal a rms of the light. This is
an electrical conductor and key component of t he
product.
• Always use the power supply provided.
Do not re-wire.
• The product is not compatible wit h dimmer circuits .
• The LEDs are non - replaceable – if damaged or
faulty, please cont act Jake Dyson Li ght or your
nearest retailer.
• Only clean with a microfibre cloth.
Warranty: This product has a limi ted 2 year
warranty covering reasonable use of the product. If a
component fails wit hin t he 2 year warranty period, it
will be replaced, s ubject to inspection.
WARNING: This product contains chemicals
known t o the State of California to cause cancer,
birth defects or other reproductive harm.
This equipment has been tes ted and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provid e reasonable protection against harmful
IMPORTANT SAFETY INSTRUCTIONS
interference in a residential installation.
This equipment g enerates, uses and can radiate radi o
frequency energy and, if not inst alled and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interf erence w ill not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to t ry to correct the
interference by one or more of t he following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that t o which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Chang es or modifications not expressly approved by
the party responsible for compliance could void t he
user’s authority to operate the equipment.
EN
