
Wireless Over-Ear Headphones with Active Noise Cancellation
Model: EDF200173
W800BT SE
Manual
EN 1. Power ON/OFF
Press and hold the power button to power on/o.
2. First pairing
1. Once powered on, the headphones will automatically enter
Bluetooth pairing mode.
2. Select "EDIFIER W800BT SE" from your device list to connect.
1. In ON state, press and hold the " " button for about 3 seconds to
enter Bluetooth pairing mode.
2. Select "EDIFIER W800BT SE" from your device list to connect.
Note: For subsequent use, the headphones will automatically connect to the device used last time.
3. Pairing for new device
1. Pair device A with the headphones successfully.
2. Press and hold the " " button for 3 seconds to re-enter Bluetooth
pairing mode, and then select "EDIFIER W800BT SE" in device B
settings to connect.
3. Select "EDIFlER W800BT SE" again in device A settings to connect,
and the multipoint connection is done.
Note: For subsequent use, the headphones wil automatically reconnect to the two devices used
last time.
4. Multipoint connection
5. Charging
Input: 5V 1A
Connect the headphones to a power source via the USB-C cable for
charging.
Note: 1. Make sure the USB-C po is completely d before charging.
2. When charging with a USB-C cable, the product is used as wired headphones and
Bluetooth functions are unavailable.
6. Controls
Note:
1. "x 1" Press , "x 2" Double press, "x 3" Triple press, "—" Press and hold;
2. Download EDlFlER ConneX App for more customizable control settings.
1. In ON state, press the " " button 5 times to nish reset.
2. The headphones will automatically enter Bluetooth pairing
mode if successful.
7. Reset
Connect to the headphones via the USB-C cable. Wired listening will
automatically disable Bluetooth mode.
8. Wired listening
● Call
● Music
● Mode
ON
OFF
-
-
1s
1s
EDIFIER W800BT SE
Bluetooth
EDIFIER W800BT SE
Bluetooth
3s
①
②
③
EDIFIER W800BT SE
Bluetooth
A
EDIFIER W800BT SE
Bluetooth
A
B
x2
x1
x1
x3
x1
x1
x1
x1
x5
x6