Eltako FDT55EB-wg Manual

Eltako Ikke kategoriseret FDT55EB-wg

Læs gratis den danske manual til Eltako FDT55EB-wg (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Eltako FDT55EB-wg, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

1-way wireless rotary switch for single

mounting 80 x 80 x 25 mm over a  ush box or

mounting into the E-Design55 switching

system. With battery (lifetime 2-8 years).

Smart Home sensor.

The scope of supply comprises a moun ting

base with snapped-on electronics, a frame

R1UE55 and a cover panel with rotary knob.

The rotary switch sends dimming values

(brightness values) to the dimming actuator.

At switching off over the rotary switch, this

value is stored into it. If several rotary switches

are taught in in the same dimming actuator,

and dimming commands are alternatively

sent from different ones, it can be that

brightness jumps appears during the dimming

process.

To teach-in the wireless rotary switch to the

actuators, remove the rotary knob.

2 internal 3 V CR1632 button cells are supplying

the power for several years.

To replace the button cell, just remove the

front panel and the rotary knob.

Only assemble on a  at surface:

Screw on mounting base or stick it on using

the enclosed adhesive foil. Then snap on the

frame, remove the battery insulations, plug on

the rotary knob and snap on the front panel.

We recommend stainless-steel countersunk

screws 2.9x25 mm, DIN 7982 C, for screw

connections. Both with rawl plugs 5x25 mm

and with 55 mm switch boxes. Set of 2 stain-

less-steel countersunk screws 2.9x25 mm

and plugs 5x25 mm are enclosed.

Minimum brightness can be adjusted in 3 steps

with one jumper. You can also select the soft-on

function which switches on the lighting grad-

ually.

Wireless sensor without wire

Wireless rotary switch

FDT55EB-

Temperature at mounting location:

-20°C up to +50°C.

Storage temperature: -25°C up to +70°C.

Relative humidity:

annual average value <75%.

30 055 539 - 1

Press on the middle of the rotary knob to

switch on at the last dimming value or to save

the current dimming value and switch off.

Wireless switching actuators FSR61, FL62

and FSLA can be switched on by pressing or

turning and switched off by pressing.

The following applies to FD62:

Turn to the right (clockwise) to dim up. The

turning speed determines the dim-up speed.

If the dimming actuator was switched off to

the right at the start of dimming, switch-on is

at minimum brightness followed by gradual

dim-up. This is the children‘s room circuit.

If the rotary knob is turned to the right jerkily

– with the actuator previously switched on or off

– dim-up is rapid to full brightness. This corre-

sponds to the double-click function of a normal

direction pushbutton, top

Turn to the left (anticlockwise) to dim-down

to the minimum brightness adjusted on the

dimming actuator. The turning speed deter-

mines the dim-down speed.

If the rotary knob is turned to the left jerkily,

dim-down is rapid to the minimum brightness

adjusted on the dimming actuator.

Teach-in:

To teach in the wireless rotary switch in

the actuators, pull off the rotary knob and

the front panel. Press and hold the mini

pushbutton (LRN) which is then accessi-

ble and brie y press the rotary knob

shaft.

Please look on the corresponding actua-

tors manual for the teaching-in position.

Teach-in telegram: 0xE0400D80

If the FDT55EB- is taught-in in FL62, FD62 or

FSLA, con rmation telegrams are auto-

matically switched on and sent. It locks

automatically the teach-in mode.

Enable teach-in mode with FDT55EB-:

Plug in the two jumpers on the 4 pins to

select the minimum brightness and brie y

press the rotary spindle.

Clear rotary switch from actuator:

Plug both jumpers on the 4 pins to select

minimum brightness and brie y press the

rotary spindle three times.

Then replug the two jumpers to the

required positions for minimum bright-

ness and Soft-On.

If the dimming actuator was switched off to

the left at the start of dimming, switch-on is

at minimum brightness followed by gradual

dim-up by turning to the right.

To replace the CR1632 button cells, just

remove the cover panel comprising the

rotary knob.

Set the minimum brightness in 3 steps using

the Min. Level jumper.

The lowest dimming value of 10% is situated in

the as-delivered state (jumper plugged onto

the two centre pins).

To reduce the lowest dimming value to 1%,

plug the jumper onto the two left pins.

To raise the lowest dimming value to 20%,

plug the jumper onto the two right pins.

When the Soft-On jumper is plugged onto the

two pins, is selected and the lighting Soft-On

is switched on gradually.

The crossed-out waste container indicates

that batteries may not be disposed with ot-

her household or commercial waste.

Batteries can be returned free of charge to

the retail outlet after use.

Attention: Danger of explosion if

battery is replaced improperly.

Only replace it by an equivalent

type!

Frequency 868.3 MHz

Transmit power max. 10 mW

Hereby, Eltako GmbH declares that the radio

equipment type FDT55EB- is in com pliance

with Directive 2014/53/EU.

The full text of the EU declaration of

conformity is available at the following

internet address: eltako.com

Must be kept for later use!

Eltako GmbH

D-70736 Fellbach

Technical Support English:

+49 711 943 500 25

technical-support@eltako.de

eltako.com

28/2022 Subject to change without notice.

Manuals and documents in further

languages

http://eltako.com/redirect/FDT55EB-

1. App 2. 3.

www.

Produkt Specifikationer

Mærke:	Eltako
Kategori:	Ikke kategoriseret
Model:	FDT55EB-wg

Har du brug for hjælp?

Hvis du har brug for hjælp til Eltako FDT55EB-wg stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Eltako Manualer

Eltako MS Manual

31 August 2024

Eltako FUD61NP-230V Manual

30 August 2024

Eltako FT4F-rw Manual

30 August 2024

Eltako FT4F-wg Manual

30 August 2024

Eltako DL-PD-300W-RLC-HS Manual

30 August 2024

Eltako DSZ15DM-3x80A Manual

30 August 2024

Eltako FTN14 Manual

30 August 2024

Eltako FT55R Manual

30 August 2024

Eltako FUD71L Manual

30 August 2024

Eltako FTS14EM T Manual

30 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

DAP-Audio VPC-12 Manual

9 Januar 2026

Halo H47ICAT Manual

9 Januar 2026

Rocstor Y10E021-B1 Manual

9 Januar 2026

Eliet DZC750 Manual

9 Januar 2026

Crystorama Glacier GLA-9707-OP Manual

9 Januar 2026

JBL Quantum 950 Wireless Manual

9 Januar 2026

Ikea KRUSTISTEL 505.857.87 Manual

9 Januar 2026

Canarm KE-12S Manual

9 Januar 2026

Glass Warehouse GW-FL-32 Manual

9 Januar 2026

Vaxcel Dockside T0215 Manual

9 Januar 2026