ET2 Alumilux E41540-SA Manual

ET2 Lettelse Alumilux E41540-SA

Læs gratis den danske manual til ET2 Alumilux E41540-SA (2 sider) i kategorien Lettelse. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om ET2 Alumilux E41540-SA, eller vil du spørge andre brugere om produktet?

Side 1/2
C o n t e m p o r a r y
L i g h t i n g
PRODUCT NAME: Alumilux
ITEM NUMBER: E41540-SA / E41540-WT
Please consult your electrician for hanging fixture and wiring.
MADE IN CHINA
Page 1 of (2)
To prevent water intrusion, caulk around back-plate
where fixture meets the wall using outdoor silicone
sealant. Leave a small gap at the bottom to allow
moisture to exit.
WARNING: Wires need to be connected to driver found
in canopy and should not be connected directly to
power source or a short may occur.
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation
2.)
Page 2 of (2)
1.)
3.)
4.)
Clean with soft cloth and a mild detergent.
Do not use abrasive cleaner.
C
D
A
B
A
B
C
D
(A)
Backplate
(B)
Mounting bracket
(C)
Wire Nuts (x3)
(D)
Mounting screws (x2)
Step.4: Caulk around fixture with outdoor
silicone sealant to prevent water intrusion.
Leave a small gap at the bottom to allow
moisture to escape. Install fixture to back
plate (B) and tighten mounting screws (D)
to secure.
Step.1: Install Mounting bracket(A) to outlet box.
Step.2: Wire fixture to wires in outlet box.
Green/Copper wire is for Ground.
Step.3: Install Backplate(B) to Mounting
bracket(A).


Produkt Specifikationer

Mærke: ET2
Kategori: Lettelse
Model: Alumilux E41540-SA

Har du brug for hjælp?

Hvis du har brug for hjælp til ET2 Alumilux E41540-SA stil et spørgsmål nedenfor, og andre brugere vil svare dig