JA-60 “Comfort“ changes overview  
 
There  are  several  changes  and  improvements  in  the  new  version  of  the  system  JA-60  “Comfort”.  The  reason  of  the  changes  is  to 
extend the current system and some of them are the result of communication with customers and installation companies. 
 
The bellowed list pertains to the SW version FM 61211 compared to the version FM 61210. 
 
Change  Programming 
sequence  Function  Reason  Note 
Power supply 
check   
In case of power failure of the control 
panel (battery or mains supply) the 
technology alarm is triggered, no matter 
what the status of the system is set 
(armed/disarmed) 
User is warned of the limited function 
of the intruder system in any case   
Panic   
The alarms of the particular sources are 
counted up to four, after this number the 
detector is ignored if the line of the four 
alarm event from this sensor has not 
been interrupted by any other source or 
by the system status change 
(arming/disarming). The panic alarms 
are not counted! 
The source of the panic alarm, e.g. 
panic button, is not ignored after the 
fourth alarm event and the sources is 
able to transmit any other event. 
 
Delayed 
detector test   39X 
During the arming process is the user’s 
attention drawn to the active delayed or 
next delayed detectors 
The function was extended for 
installation companies demand   
Programming 
mode  6999 
Direct oversetting of the Programming 
mode to the User mode without the “N” 
key and master code entering 
The set bypasses and theirs features 
are kept on    
Periphery 
enrolment  299  The enrolment sequence may be 
transmitted in the User mode as well  
The user is allowed to enrol 
peripheries without the service code 
knowledge 
Timer  64 nahhmm  Possibility of the counter setting in the 
User mode  
The user is allowed to set the 
automatic arming and disarming 
timer without the service code 
knowledge 
Further 
information in 
the user manual