Kicker zx 350 2 Manual

Kicker Bilradio zx 350 2

Læs gratis den danske manual til Kicker zx 350 2 (4 sider) i kategorien Bilradio. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Kicker zx 350 2, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
©2007 Stillwater Designs
ZX
STEREOAMPLIFIER
ZX350.2, ZX450.2, ZX550.2, ZX850.2
+
_
+
+
_
+
_
_
+12V
18"
(45cm)
24"
(60cm)
XOVER
XOVER
XOVER
Installation
1. Mounting Choose a structurally sound location to mount your Kicker amplifi er. Make sure there
are no items behind the area where the screws will be driven. Choose a location that allows at least
4” (10cm) of open ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled
passenger compartment. Drill four holes using a 7/64” (3mm) bit and use the supplied #8 screws to
mount the amplifi er.
2. Wiring Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to
the amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint and corrosion free
solid metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger)
between the battery's negative post and the vehicle chassis is recommended.
The ZX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low
level signals from your car stereo’s source unit. Ideally, when connecting the source unit to the amplifi er,
the ZX amplifi er’s input level switch should be set to “LO” and a low-level signal should run from the
source unit’s stereo RCA output to the stereo RCA input on the end panel of the amplifi er using RCA
interconnect cable. If a low-level stereo RCA output is not available on the source unit, the signal can
be delivered to the amplifi er using the high-level speaker outputs on the source unit. Set the input level
switch on the end panel of the amplifi er to “HI”. Crimp and solder RCA connectors to the end of the
speaker wire running from the high-level speaker outputs on the source unit and connect the wire to the
RCA Inputs on the end panel of the amplifi er as shown in Figure 1. Either input method will provide a
low-level output signal at the RCA output, which effectively passes the audio signal to another amplifi er
or component. Keep the audio
signal cable away from factory wiring
harnesses and other power wiring. If
you need to cross this wiring, cross it
at a 90 degree angle.
Install a fuse within 18” (45cm) of the battery and in-line with the 8 gauge power cable connected to your
amplifi er. If you ever need to remove the amplifi er from the vehicle after it has been installed, the ground
wire should be the last wire disconnected from the amplifi er--just the opposite as when you installed it.
See the fuse chart on the following page for power and ground wire size, and fusing recommendations.
3. Confi guration The following diagrams show the most common confi gurations for your Kicker ZX
series amplifi er.
ZX.2SeriesAmplifi er
Owner’sManual
Tw o ChannelModels: ZX350.2 / ZX450.2 / ZX550.2 / ZX850.2
Authorized Kicker Dealer:
Purchase Date:
Amplifi er Model Number:
Amplifi er Serial Number:
Congratulations on your
KICKER purchase!
Please record your purchase
information and keep your sales
receipt for validation of warranty.
__________________________
__________________________
__________________________
__________________________
INSTALLATION
2ZX.2AMPLIFIER
CONFIGURATION
3
+12V
18"
(45cm)
24"
(60cm)
+12V
18"
(45cm)
24"
(60cm)
Figure 2
Figure 3
Figure 4
Minimum Impedance of 2 ohms per channel in stereo operation
Minimum impedance of 4 ohms while in bridged operation
Minimum impedance of 4 ohms mono and 2 ohms per channel in stereo simultaneously
Ground
Remote
Turn-On
Fuse
Battery
High Pass
High Pass
Low Pass
Ground
Remote
Turn-On
Fuse
Battery
Ground
Remote
Turn-On
Fuse
Battery
Signal In
Bridge Wiring
Bridge Wiring
Bridged Operation (Mono)
Two Channel Operation (Stereo)
Stereo and Mono Operation Simultaneously (SAMS)
Note: To get the best performance from your new Kicker Amplifi er, we recommend using genuine Kicker Accessories and Wiring.
Performance
Model ZX350.2 ZX450.2 ZX550.2 ZX850.2
RMS Power in Watts, all channels driven
@14.4 Volts, 4Ω stereo, ≤ 1% THD+N 110 x 2 150 x 2 205 x 2 295 x 2
@ 2Ω stereo, ≤ 1% THD+N 175 x 2 225 x 2 275 x 2 425 x 2
@ 4Ω mono, ≤ 1% THD+N 350 450 550 850
Length: in(cm) 13 1/2 (34.2) 16 3/4 (42.5) 20 (50.7) 23 1/4 (59)
Specifi cations common to all models:
Height: in(mm) 2 1/8 (54mm)
Width: in(mm) 9 5/8 (244mm)
Frequency Response, ± 0.5 db: 20 Hz - 20 kHz
Signal-to-Noise Ratio: >95db, a-weighted, re: rated power
Input Sensitivity: Low Level: 125mV-5V
High Level: 250mV-10V
Selectable Electronic Crossover: Variable HI, LO or OFF (bypass), 50 - 200Hz, 12db/Octave
Bass Boost: Variable 0-18db Bass Boost @ 40Hz
+
+
>
+
>
Core Cable
Ground or Shielding
High-level Speaker Output Wire
To Amplifi er
To Source Unit
Figure 1
ModelZX350.2 1 (ONE) 50 AMPERE FUSE PowerGroundWire 8GA
ModelZX450.2 1 (ONE) 60 AMPERE FUSE PowerGroundWire 4GA
ModelZX550.2 1 (ONE) 70 AMPERE FUSE PowerGroundWire 4GA
ModelZX850.2 1 (ONE) 120 AMPERE FUSE PowerGroundWire 2GA
Signal In
Signal Out
Signal In
Signal Out
Signal Out

Produkt Specifikationer

Mærke: Kicker
Kategori: Bilradio
Model: zx 350 2

Har du brug for hjælp?

Hvis du har brug for hjælp til Kicker zx 350 2 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Bilradio Kicker Manualer

Kicker

Kicker KX300.4 Manual

4 Oktober 2024
Kicker

Kicker IX 406 Impulse Manual

22 September 2024
Kicker

Kicker DX500.1 Manual

12 September 2024
Kicker

Kicker IX 702 Impulse Manual

31 August 2024
Kicker

Kicker KX850.2 Manual

31 August 2024
Kicker

Kicker X50 Manual

23 August 2024
Kicker

Kicker zx 350 2 Manual

23 August 2024
Kicker

Kicker KX 400.4 Manual

22 August 2024
Kicker

Kicker ZX 300.1 Manual

22 August 2024
Kicker

Kicker kx 600 1 Manual

22 August 2024

Bilradio Manualer

Nyeste Bilradio Manualer

Pyle

Pyle PLD40MU Manual

9 August 2025
Aiwa

Aiwa ICD-820DAB Manual

8 August 2025
Boss

Boss BCPA14 Manual

7 August 2025
LG

LG LAC5900IN Manual

6 August 2025
Alpine

Alpine CDE-9827R Manual

3 August 2025
Alpine

Alpine CDM-9805R Manual

3 August 2025
Alpine

Alpine CDE-9821R Manual

2 August 2025
Alpine

Alpine APF-X303VW Manual

2 August 2025
Alpine

Alpine CDM-7874RB Manual

2 August 2025
Alpine

Alpine CDA-7944R Manual

2 August 2025