LiftMaster 956EVC-P2 Manual

LiftMaster Ikke kategoriseret 956EVC-P2

Læs gratis den danske manual til LiftMaster 956EVC-P2 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 9 anmeldelser. Har du et spørgsmål om LiftMaster 956EVC-P2, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
3-BUTTON REMOTE CONTROLS
MODELS 953EV, 953EV-P2, 953EVC, 953EVC-P2,
956EV, 956EV-P2, 956EVC, AND 956EVC-P2
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of reach
of children. NEVER permit children to
operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after January 1, 1993.
The garage door opener activates when the programmed button on the remote control is pressed. The
remote control can activate up to three garage door openers.
Make sure the garage door opener has a working light bulb because it is a programming indicator.
LED LED
4
Press and release the Learn
button on the garage door
opener.
3To exit programming mode,
press any remote control
button the button except
that was just programmed.
Install the visor clip.
7
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
To test, press the programmed
button on the remote control...
1
Within 30 seconds...
The Learn LED will light.
5 6
Press and hold the program button
the remote control until the LED on
the of the remote control front
turns on.
Learn
Button
Click
Click
The garage door
opener will activate.
2Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses Garage Door Opener Type
1
2
3
4
Yellow Learn Button (Security+ 2.0
®)
Purple Learn Button (315 MHz Security+®)
Red/Orange Learn Button (390 MHz Security+®)
Green Learn Button (390 MHz Billion Code)
MODELS 953EV, 953EV-P2,
953EVC AND 953EVC-P2
MODELS 956EV, 956EV-P2,
956EVC AND 956EVC-P2
GARAGE ACCESS SYSTEM
REMOTE
GARAGE ACCESS SYSTEM
KEYCHAIN REMOTE
PREPARE
PROGRAM THE REMOTE CONTROL (953EV, 953EV-P2, 953EVC AND 953EVC-P2)
953EV, 953EV-P2,
953EVC AND
953EVC-P2
956EV,
956EV-P2,
956EVC AND
956EVC-P2
Para Manual en Español ir a:
http://www.chamberlain.com/CatalogResourcesV3/en-us/shared/files/tucmanuals/114A5043SP.pdf
WARNING: This product can expose you to chemicals including lead, which are known to the State
of California to cause cancer or birth defects or other reproductive harm. For more information go
to www.P65Warnings.ca.gov
OROR
Locate the button on Learn
the garage door opener.
NOTE: Your garage door
opener may look different.
Learn
LED
Learn
LED
Learn LED
Locate the Program button on the
remote control.
Program Button
Program Button
Green LED or
Red/Orange
Purple Yellow
4
Press and release the Learn
button on the garage door
opener.
3To exit programming mode,
press any remote control
button the button except
that was just programmed.
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
1
Within 30 seconds...
The Learn LED will light.
5
Press and hold the program button
the remote control until the LED on
the of the remote control front
turns on.
Safety pin or
paper clip
Learn
Button
Click
Click
2Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses Garage Door Opener Type
1
2
3
4
Yellow Learn Button (Security+ 2.0®)
Purple Learn Button (315 MHz Security+®)
Red/Orange Learn Button (390 MHz Security+®)
Green Learn Button (390 MHz Billion Code)
To test, press the programmed button on the remote control...
6
The garage door opener
will activate.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)this device
must accept any interference received, including interference that may cause undesired operation.
BATTERY
The LED on your remote will stop flashing when the battery is low and needs
to be replaced. To replace battery, open the case as shown. Insert battery
positive side up (+). Replace the battery with only 3V CR2032 coin cell
batteries. Dispose of old battery properly.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212° F (100° C) or
incinerate.
1-800-528-9131
REPLACEMENT PARTS
Battery ...................................................10A20
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29B137
(Models 953EV, 953EV-P2, 953EVC & 953EVC-P2 ONLY)
1
2
3
WARRANTY
www.chamberlain.com
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of this
product that it is free from defect in materials and/or workmanship for a
period of 1 year from the date of purchase.
Pry open the case with a
screwdriver blade.
956EV, 956EV-P2, 956EVC AND
956EVC-P2
Pry open the case first in the
middle (1), then at each side (2
and 3) with the visor clip.
953EV, 953EV-P2, 953EVC AND
953EVC-P2
PROGRAM THE REMOTE CONTROL (956EV, 956EV-P2, 956EVC AND 956EVC-P2)
Remote Control Transmitter 953EV: IFT #: RCPCH9518-0362
Remote Control Transmitter 953EVC: IFT #: RCPCH9518-0362-A1
Remote Control Transmitter 956EV: IFT #: RCPCH9518-0360
Remote Control Transmitter 956EVC: IFT #: RCPCH9518-0360-A1

Produkt Specifikationer

Mærke: LiftMaster
Kategori: Ikke kategoriseret
Model: 956EVC-P2

Har du brug for hjælp?

Hvis du har brug for hjælp til LiftMaster 956EVC-P2 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret LiftMaster Manualer

LiftMaster

LiftMaster 041-0405-000 Manual

15 Juni 2025
LiftMaster

LiftMaster LMHNTG Manual

4 September 2024
LiftMaster

LiftMaster CAPXSTKPL Manual

3 September 2024
LiftMaster

LiftMaster BG790 Manual

3 September 2024
LiftMaster

LiftMaster 64LM Manual

3 September 2024
LiftMaster

LiftMaster CAPXSHOOD Manual

28 August 2024
LiftMaster

LiftMaster myQ-SGC2WCH Manual

21 August 2024
LiftMaster

LiftMaster CAPXS Manual

21 August 2024
LiftMaster

LiftMaster MGJ5011U Manual

21 August 2024
LiftMaster

LiftMaster LMWEKITU Manual

21 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Grundig

Grundig GIEI827578PN Manual

1 August 2025
Finlux

Finlux FC-550mmW Manual

1 August 2025
Thermaltake

Thermaltake Toughpower PF3 Platinum Manual

1 August 2025
Olivetti

Olivetti d-Copia 4524MFplus Manual

1 August 2025
Grundig

Grundig GEBD19401BPH Manual

1 August 2025
Thermaltake

Thermaltake Max 3504 Manual

1 August 2025
Tripp Lite

Tripp Lite N286-100G-SR4SA Manual

1 August 2025
Tripp Lite

Tripp Lite Protect It! TLP88USBB Manual

1 August 2025
Tripp Lite

Tripp Lite Protect It! TLP664USBB Manual

1 August 2025
Silver Cross

Silver Cross Tide Manual

1 August 2025