Nxg NX-AW5 Manual

Nxg Højttaler NX-AW5

Læs gratis den danske manual til Nxg NX-AW5 (2 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 41 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 21 anmeldelser. Har du et spørgsmål om Nxg NX-AW5, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
Congratulations on the purchase of your new all-weather speakers. At NXG Technology,
we strive to offer products that are durable, functional, and above all else – speakers that
produce great audio. Like all NXG products, our all-weather speaker line has evolved
from hours of rigorous testing by our engineers and customers and were designed to pro-
vide you with years of great sound, whether in your den, backyard or on your boat. Please
take a moment to to review the installation instructions to ensure that you get the most
from your new speakers.
Unpacking
Carefully remove your new NXG speakers from the box. Inspect the speakers for transit
damage. If you discover damage, contact your dealer immediately. Save your carton – it is the
best possible protection for your speakers should you ever have a need to move them.
Positioning and Mounting Your New NXG Speakers
Note: the distance between yourself and the point directly between the speakers should be
(roughly 20%) greater than the distance between the two speakers. Outside placement may
be different, due to variances in available mounting areas.
1/4– 20 threaded
brass inserts accept
universal style
mounting hardware
(not included).
Negative (Black)
Input Binding Post
CORRECT IN-PHASE HOOK-UP
FIGURE 1
FIGURE 2
All NXG weather-resistant speakers are equipped with
powder-coated ratcheting aluminum mounting brackets
that allow for vertical or horizontal mounting. Be certain
the type of anchor you choose, and the material you
are mounting the anchor into, are capable of holding
the weight of the speaker. (Many mounting anchor sys-
tems are available from your local hardware store.)
After mounting the bracket, connect the wire as shown
in Figure 2, and loosely secure the speaker to the
bracket using the supplied knobs. Adjust the speaker’s
angle for optimum listening area coverage and firmly
hand-tighten the knobs.
Hooking Up Your
New NXG Speakers
STOP! – Make sure that you consult your amplifier’s
owner’s manual regarding speaker hook-up. Your ampli-
fier should be turned off throughout this procedure.
Most speaker wire is polarity coded. This means that
each conductor is labeled either (+) positive or (-) neg-
ative. The (+) positive side may be a different color or
texture than the (-) negative side. On the back of your
amplifier, each channel should be labeled (+) and (-)
as well as color coded red for (+) positive and black for
(-) negative. NXG speaker terminals are color coded
red for (+) positive and black for (-) negative. Be sure
to hook (+) to (+), (red to red), and (-) to (-), (black to
black). (See figure 3.) All connections should be tight.
Inspect connections for frays and stray strands of wire
touching both (+) and (-) terminals. (This will cause a
short and, perhaps, damage your equipment.)
Positive (Red)
Input Binding Post
To Negative Terminal
of Amplifier
To Positive Terminal of
Amplifier
Speaker wire hole Powder-coated
aluminum ratcheting
mounting bracket
BACK VIEW
Bracket knob
NX-AW4, NX-AW5, and NX-AW6
All-Weather Speakers – Outdoor/Indoor/Marine
Standard
1/4 – 20 threads
Hook up with either bare speaker wire as
large as 10 gauge or NXG banana plugs.
MODEL NX-AW4 MODEL NX-AW5 MODEL NX-AW6
4˝ 2-way Indoor/Outdoor Speaker System 5.25˝ 2-way Indoor/Outdoor Speaker System 6.5˝ 2-way Indoor/Outdoor Speaker System
Cabinet: All three models are made of weather-resistant, UV treated, high-impact ABS composite to resist sun-fade and long-term exposure to the elements.
Tweeter: 3/4˝ (19mm) ultra-wide dispersion 3/4 ˝ (19mm) ultra-wide dispersion 1˝ (25.4mm) ultra-wide dispersion
metallic anodized dome metallic anodized dome metallic anodized dome
Woofer: 4˝ (102mm) injection-molded 5.25˝ (133mm) injection-molded 6.5˝ (165mm) injection-molded
metallic anodized cone w/rubber surround metallic anodized cone w/rubber surround metallic anodized cone w/rubber surround
Frequency Response: 75 Hz-20,000 Hz 65 Hz-20,000 Hz 55 Hz-20,000 Hz
Impedance: 8 ohms nominal 8 ohms nominal 8 ohms nominal
Power Handling: 5 to 75 watts 5 to 100 watts 5 to 125 watts
Efficiency: 87 dB 89 dB 90 dB
Speaker Dimensions: 911/16 ˝ H x 6 1/2 ˝ W x 6˝ D 10 3/4 ˝ H x 6 13
/16 ˝ W x 6 5/8 ˝ D 12 7/8 ˝ H x 8˝ W x 71/4˝ D
Weight Each: 5 lbs. 5.5 lbs. 7 lbs.
Caring for Your Speakers
In outdoor applications, we recommend angling the speakers downward
as shown in Figure 1 to reduce exposure to precipitation and hot sun. If
added protection is desired, mount speakers under eaves or other shel-
ter. DO NOT immerse the speakers in water or subject them to direct
water pressure. During winter months, we recommend storing the speak-
ers indoors if you are not using them.
TO CLEAN: All NXG weather-resistant enclosures can be cleaned with
a damp soft cloth and a mild detergent. The aluminum grille can also be
cleaned with the same cloth
Troubleshooting and Service
The NXG speaker is equipped with a tweeter protection device. If
extreme power levels are reached, it will reduce the amount of power
going into the tweeter. If you detect reduced output levels from the speak-
er while playing at a high volume, it is a warning that too much power is
being applied. You must reduce the level by turning down the volume of
your receiver to a safe level or permanent speaker damage may result. It
is important to remember that no amount of protection will prevent dam-
age caused by defective equipment or extreme abuse.
If you should have a problem, first try to determine if it is indeed a
speaker problem. Determine whether the problem exists in both speakers.
If it does, the problem most likely originates in some other components in
the system. If the problem is in one speaker only, reverse your speaker
leads (left to right, right to left). If the problem moves to the other speak-
er, your problem is not in the speakers.
Once you have determined that you have a speaker problem, contact
your dealer for authorized factory service information. If you are unable to
contact your dealer, if your dealer is unable to solve your problem, or if you
have any questions or comments regarding your NXG Speaker System,
please contact us at the address or phone number below.
Specifications
NXG Speakers Two -Year Limited Warranty
If the NXG speaker system proves to be defective in workmanship or materials
within two years from the date of the original customer’s purchase, we will, at
our option, repair or replace the defective product.
Limitation of Implied Warranties
Any implied warranties, including warranties of merchantability and fitness for a
particular purpose, are limited in duration to the length of this warranty.
Exclusion of Certain Damages
NXG’s liability for any defective product is limited to repair or replacement of the
product. NXG shall not be liable for incidental or consequential damages of any
kind or character for any reason. Some states do not allow limitations on how
long an implied warranty lasts and/or do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitations and exclusions
may not apply.
Warranties do not cover electrical or mechanical damage resulting from misuse
or abuse, lack of reasonable care, damage due to force majeure or natural forces,
or inadequate repairs performed by unauthorized service centers. Wear of parts
due to normal use is not covered by this warranty. Shipment of the defective item
for repair under this warranty will be at the customer's own risk and expense. This
warranty is valid for the original purchaser as the final user only.
Warranty Service
Warranty service must be performed by an authorized service center, usually an
NXG speaker systems dealer or its authorized agent. You may obtain a list of
authorized service centers by contacting NXG. All warranty repairs must be
accompanied by the original bill of
sales. No other document is accept-
able or is required. This warranty
gives you specific legal rights, and
you may also have other rights which
vary from state to state. NXG
reserves the right to revise speaker
system specifications without notice.
Scottsdale, AZ
email: nxgtechnology@gmail.com
web: nxgtechnology.com

Produkt Specifikationer

Mærke: Nxg
Kategori: Højttaler
Model: NX-AW5

Har du brug for hjælp?

Hvis du har brug for hjælp til Nxg NX-AW5 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Nxg Manualer

Nxg

Nxg NX-W5.2-LCR-P Manual

21 August 2024
Nxg

Nxg NX-W6.2-P Manual

20 August 2024
Nxg

Nxg NX-C6.2-P Manual

20 August 2024
Nxg

Nxg Onyx NX-C8.2-ENC-X Manual

19 August 2024
Nxg

Nxg NX-C8.3-P Manual

18 August 2024
Nxg

Nxg NX-C8.2-P Manual

18 August 2024
Nxg

Nxg NX-AW5 Manual

10 Juli 2024

Højttaler Manualer

Nyeste Højttaler Manualer

Rockustics

Rockustics StoneHenge II-S/T Manual

30 Juli 2025
Valcom

Valcom InformaCast VIP-428A-IC Manual

30 Juli 2025
Valcom

Valcom InformaCast VIP-431A-IC Manual

30 Juli 2025
Electro-Voice

Electro-Voice Evid 4.2T Manual

30 Juli 2025
Audiocase

Audiocase S10 Manual

30 Juli 2025
JLab

JLab JBuds Party Manual

30 Juli 2025
Valcom

Valcom InformaCast VIP-411A-IC Manual

30 Juli 2025
FoneStar

FoneStar MOV-684PR-L Manual

30 Juli 2025
Marshall

Marshall Middleton II Manual

30 Juli 2025
Audiocase

Audiocase S5 Manual

30 Juli 2025