OttLite Archer L1604BS9-SHPR Manual

OttLite Lys Archer L1604BS9-SHPR

Læs gratis den danske manual til OttLite Archer L1604BS9-SHPR (1 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 12 anmeldelser. Har du et spørgsmål om OttLite Archer L1604BS9-SHPR, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Archer Floor Lamp

L1604BS9-SHPR LPF43

CONGRATULATIONS !

You’ve purchased the ﬁnest in natural lighting technology with your new

OttLite® product.

PRODUCT REGISTRATION FORM

Please complete the enclosed Product Registration Form and return it

today by mail, or register online by going to: OttLite.com/warranty.

WARNING: To prevent electric shock, make sure the lamp is not plugged

in until all assembly steps are complete.

This lamp includes an OttLite® Natural Daylight LED Bulb.

LAMP ASSEMBLY

1. Unpack all lamp parts and lay out on the ﬂoor with base ( ) A

laying ﬂat.

Thread pole ( ) to base ( ) by hand turning clockwise until tight.B A

Thread middle pole ( ) to lower pole ( ) by hand turning clockwise C B

until tight.

Thread upper pole ( ) to middle pole ( ) by hand turning clockwise D C

until tight.

Thread arm ( ) into upper pole ( ). Note: Pull excess cord from bottom E D

of base (A) as needed.

6. Thread rear arm weight (F E G) into ( ) and then thread the top pole ( ) as

shown.

7. Refer to BULB INSERTION/REMOVAL to install bulb (H) in lamp.

8. Plug the cord (I) into a standard 120V AC outlet.

9. To turn the lamp ON or OFF press the foot switch ( ) located on J

the cord.

10. To adjust shade angle, loosen thumb screw (K) and move shade to

desired position and then tighten thumb screw (K).

11. To adjust shade angle move shade to desired position (L).

12. The shade can be adjusted UP/DOWN or LEFT/RIGHT within pivot joint

(M). To adjust the direction of the shade (H), grasp shade and move

UP or DOWN within pivot joint (M) until it reaches a stop OR turn shade

(L) LEFT/RIGHT in a circular motion. DO NOT force the shade into any

position as damage may occur.

BULB INSERTION /REMOVAL

Make sure that the lamp is not plugged into an electrical socket.

If the lamp has been in use, allow it to cool approximately 5 minutes

before proceeding.

To install a bulb ( ) in the socket, thread the base of the bulb into the H

socket turning clockwise until snug. CAUTION: DO NOT overtighten the

bulb. Overtightening the bulb may make removal difﬁcult or damage

the lamp or bulb.

To remove a bulb ( ) already installed in the lamp, unthread the bulb from H

the socket turning counterclockwise to loosen.

SAFETY WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK, OR INJURY TO PERSONS

1. Turn lamp off and WAIT UNTIL BULB IS COOL before handling.

2. Bulb gets hot quickly! Touch only switch/plug when turning ON

or OFF.

3. Never use with an extension cord unless the plug can be fully

inserted into the receptacles in the extension cord.

4. Do not alter the plug.

5. INDOOR USE ONLY.

NOTE: The important safety instructions appearing in this instruction

sheet are not meant to cover all possible conditions and situations that

may occur. It must be understood that common sense, caution, and

care must be used with any electrical product.

CAUTION! IMPORTANT SAFETY INSTRUCTIONS: THIS PORTABLE LAMP

HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A FEATURE TO

REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET

ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE

PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. NEVER USE

WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED. DO NOT ALTER

THE PLUG.

CAUTION! TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG

TO WIDE SLOT, FULLY INSERT. CAUTION! IF THE EXTERNAL FLEXIBLE CABLE OR

CORD OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY

THE MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN

ORDER TO AVOID A HAZARD. INDOOR USE ONLY.

FCC PART 15

Note: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that the interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that of the receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference

that may cause undesired operation.

CAUTION: Any change or modiﬁcation to product not expressly

recognized by OttLite Technologies voids OttLite’s responsibility for

proper function of product.

CAN ICES-005 / NMB-005

EngLiSH Archer Floor Lamp

INS180446 REV120718

Produkt Specifikationer

Mærke:	OttLite
Kategori:	Lys
Model:	Archer L1604BS9-SHPR

Har du brug for hjælp?

Hvis du har brug for hjælp til OttLite Archer L1604BS9-SHPR stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lys OttLite Manualer

OttLite CS309G5W Manual

10 Februar 2025

OttLite Covington L1604NK9-SHPR Manual

22 Januar 2025

OttLite Archer L1604BS9-SHPR Manual

22 Januar 2025

OttLite P93009 Manual

22 Januar 2025

OttLite Creative Curves A30009-FFP Manual

12 Januar 2025

OttLite Good Housekeeping Manual

11 November 2024

OttLite Aglow Manual

10 November 2024

OttLite Rise Manual

11 September 2024

OttLite Shine Manual

11 September 2024

OttLite Power Up Manual

11 September 2024

Lys Manualer

Nyeste Lys Manualer

Honeywell HW-T12312 Manual

13 August 2025

V-TAC VT-10176 Manual

13 August 2025

Eurolite LED IP TMH-H420 Manual

13 August 2025

Eurolite LED Silent Par 6 QCL Floor Manual

13 August 2025

Neewer FS600C Manual

13 August 2025

Eurolite LED IP PAR 12x8W QCL Manual

13 August 2025

Philips Ultinon Essential LED 11258UE2X2 Manual

13 August 2025

Plus More MO-HF024 Manual

13 August 2025

Philips Ultinon Essential LED 11362UE2X2 Manual

12 August 2025

Philips Ultinon Essential LED 11005UE2X2 Manual

12 August 2025