OttLite Power Up Manual

OttLite Lys Power Up

Læs gratis den danske manual til OttLite Power Up (1 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 101 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 51 anmeldelser. Har du et spørgsmål om OttLite Power Up, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

CONGRATULATIONS!

You’ve purchased the ﬁnest in natural lighting technology with your new OttLite

product.

PRODUCT REGISTRATION FORM

Please complete the enclosed Product Registration Form and return it today by mail.

WARNING: To prevent electric shock, make sure the lamp is not plugged in until

all steps are complete.

NOTE: THIS UNIT IS FULLY ASSEMBLED

Remove lamp from packing, placing lamp body base (A) ﬂat on a steady surface.

Connect power adapter input (H) into connector (J) in the rear-bottom of the lamp.

3. Plug the power adapter (G) into a standard household 120V AC outlet. Note:

Only use with the supplied power adapter to avoid damage or ﬁre.

4. Turn the lamp ON/OFF by using power switch in touch panel (B) located on top of

base (A). Power switch (B) is a “touch” switch that controls the dimmer function

from low to high brightness setting. A quick touch will turn the lamp on and off.

5. Wireless charger for Qi-certiﬁed devices (C) is located in the center of base (A).

See Wireless Charging Instructions section for details.

6. To power LED dimmer setting, slightly touch switch (B) to turn “ON” lamp and

achieve the following:

• To operate dimmer function; continuously “press” switch to increase

brightness. Stop pressing switch once desired brightness level is achieved.

• Continuously “press” switch again to decrease brightness. Stop pressing

switch once desired brightness level is achieved.

7. To reposition the light, hold the lamp base (A) steady and grasp either lamp

body (D) or shade (E) depending on needed adjustment.

WIRELESS CHARGING INSTRUCTIONS:

Wireless charging requires a Qi-certiﬁed device. To determine if your device is

Qi-certiﬁed, please visit the Wireless Power Consortium website.

To wirelessly charge a device, perform the following:

• Check for

a RED light on top of base (A). This signiﬁes a device can be charged

• Place the device, which supports Qi wireless charging standard, face up on the middle

of the Qi wireless charging icon (C).

• A different light on top of base (A) will turn BLUE noting charging mode is active.

• When the device is centered on the Qi wireless charging icon (C), a solid BLUE

light will indicate the device is charging properly. If a solid light, or a NOTE: RED

or blinking light is visible, this indicates the device is not charging and RED BLUE

needs to be properly centered.

• Check the charge level on your device periodically to determine when device is fully

charged. NOTE: Lamp DOES NOT provide any indication of when device is fully charged.

CAUTION!

DEVICE MAY BECOME WARM DURING CHARGING. THIS IS NORMAL

AND PART OF THE PROCESS. CHARGING TIMES VARY BY DEVICE.

SAFETY WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS

1. Turn lamp off and before handling. WAIT UNTIL LAMP HEAD (E) IS COOL

2. The LED panel (F) might get hot after several hours of continuous use DO NOT place

your hands directly on LED light panel.

3. Never use with an extension cord unless the plug can be fully inserted into the

receptacles in the extension cord.

4. Do not alter the plug.

5. The lamp head included with this unit cannot be replaced by the consumer.

6. INDOOR USE ONLY.

NOTE: The important safety instructions appearing in this instruction sheet are not meant

to cover all possible conditions and situations that may occur. It must be understood that

common sense, caution, and care must be used with any electrical product.

CAUTION!

IF THE ExTERNAL FLExIBLE CABLE OR CORD OF THIS LUMINAIRE IS

DAMAGED, IT SHALL BE ExCLUSIVELY REPLACED BY THE MANUFACTURER OR ITS SERVICE

AGENT OR A SIMILAR qUALIFIED PERSON IN ORDER TO AVOID A HAzARD. INDOOR USE ONLY.

CAUTION!

THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN

THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.

FCC PART 15

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that the

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that of the receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

CAN ICES-001 (B)/NMB-001 (B)

CAN ICES-005 (B)/NMB-005 (B)

CAUTION: Any change or modiﬁcation to product not expressly recognized by

OttLite Technologies voids OttLite’s responsibility for proper function of product.

POWER ADAPTER SPECIFICATION:

Input: AC 100-240V, 50/60 Hz, 1.2A Max

Output: 12V DC, 2A with a Male DC Plug

Qi CHARGER SPECIFICATION:

Output: 5V, 1A or 5 watts

THIS LAMP CONTAINS a 5V, 2,1A USB output port (K) located on the bottom rear of

lamp. USB port can charge items such as tablets, cellular phones, etc.

The “Qi” symbol is a trademark of the Wireless Power Consortium

English Power Up LED Desk Lamp with Wireless Charging

Power Up LED Desk Lamp with Wireless Charging

CS030QI CS030QI-SHPR X8A

INS180458 REV123118

Produkt Specifikationer

Mærke:	OttLite
Kategori:	Lys
Model:	Power Up

Har du brug for hjælp?

Hvis du har brug for hjælp til OttLite Power Up stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lys OttLite Manualer

OttLite CS309G5W Manual

10 Februar 2025

OttLite Covington L1604NK9-SHPR Manual

22 Januar 2025

OttLite Archer L1604BS9-SHPR Manual

22 Januar 2025

OttLite P93009 Manual

22 Januar 2025

OttLite Creative Curves A30009-FFP Manual

12 Januar 2025

OttLite Good Housekeeping Manual

11 November 2024

OttLite Aglow Manual

10 November 2024

OttLite Rise Manual

11 September 2024

OttLite Shine Manual

11 September 2024

OttLite Power Up Manual

11 September 2024

Lys Manualer

Nyeste Lys Manualer

Bellevue Norwood BOWS57936CH Manual

20 December 2025

Vaxcel Tremont P0323 Manual

20 December 2025

Regina Andrew Montecito 17-1022 Manual

20 December 2025

Alora Amelia EW519213 Manual

20 December 2025

Canarm Marcella IOL322 Manual

20 December 2025

Progress Lighting P400326 Manual

20 December 2025

Progress Lighting P2713 Manual

20 December 2025

Vaxcel Camden H0288 Manual

20 December 2025

Vaxcel Marshall H0296 Manual

20 December 2025

Progress Lighting P2010 Manual

20 December 2025