OttLite P93009 Manual

OttLite Lys P93009

Læs gratis den danske manual til OttLite P93009 (2 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 59 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 30 anmeldelser. Har du et spørgsmål om OttLite P93009, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

INS150220 REV120715

CONGRATULATIONS!

You’ve purchased the ﬁnest in natural lighting technology with your new OttLite

product.

PRODUCT REGISTRATION FORM

Please complete the enclosed product registration form and return it today by

mail, or register online by going to: OttLite.com/warranty.

WARNING: To prevent electric shock, make sure the lamp is not plugged in

until all assembly steps are complete.

CAUTION: TIP HAZARD DO NOT MOVE SHADE OR ACCESSORIES outside

of the shaded area as shown in Figure 1. Shade and accessories must be kept

within the shaded area and must align in the same forward-facing direction

as the base.

LAMP ASSEMBLY

1. Unpack all lamp parts and lay out with the base (A) lying ﬂat on a steady

surface.

2. To ease assembly, straighten gooseneck (G) so that shade (H), neck, and

dowel (F) are in a straight line.

3. Remove wrench ( M), bolt (L) and washer ( K) from the plastic bag included in

the box containing the base.

4. Insert upper pole (C) into the lower pole (B) and thread lightly until tightened.

5. Firmly insert the stem (or bottom) of assembled pole (B-C) into the hole

located in the base (A).

6. Insert bolt ( L) through the washer (K), then into the recessed hole in the

bottom of the base (A) as shown in the diagram.

7. Use the enclosed wrench (M) to tighten the bolt ( L) securely, turning clockwise

until tight.

8. Before assembling shade and gooseneck assembly (G) to upper pole (C),

connect adapter input (D) into connector (E) in the bottom of dowel (F).

See Figure 3. Finish assembly by inserting dowel (F) into upper pole (C).

IMPORTANT: To lock dowel (F) into upper pole (C) make sure “opening”

located on back of dowel is aligned with inner pole “tab” also marked with

an arrow. Inner pole tab and arrow are shown in Figure 4. The shade and

gooseneck assembly (G) should be ﬂush with the upper pole and free to rotate.

Dowel opening can be easily seen in Figure 3.

9. Connect the input jack (N) of adapter (P) into connection (O) located in the

rear-bottom of pole (B).

OPERATION

1. Plug the AC Adapter (P) into a standard household 120V AC outlet. Only NOTE:

use with supplied AC adapter to avoid damage of fire.

2. Turn the lamp ON or OFF by using power switch (J) located in the front-lower

side of gooseneck assembly (G). Power switch (J) is a “touch” switch that

controls the dimmer function of the lamp.

3. To power LED lighting, slightly touch the switch (J) to achieve the following:

• to turn lamp “ON”; touch the switch “once”

• to turn lamp “OFF”; touch the switch a “second” time.

4. To power LED dimmer setting, slightly touch the switch (J) to turn “ON” lamp

and achieve the following:

• to operate dimmer function; continuously “press” switch until light reaches

its lowest setting or “stop” pressing switch when reaching desired lower

light level.

• after reaching desired lower light level, continuously “press” switch again

until reaching original setting.

NOTE: If dimmer function was employed prior to turning “OFF” lamp, the lamp

will return to light setting last employed unless disconnected from adapter.

5. To position the shade simply bend the gooseneck (G) as needed to point the light.

To avoid damaging the lamp, force the flex-neck into a sharp bend. DO NOT

SAFETY WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS

1. Turn off/unplug and before handling.WAIT UNTIL SHADE (H) IS COOL

2. The LED light panel (Q) might get hot after several hours of continuous use, DO

NOT place your hands directly on LED light panel.

3. Never use with an extension cord unless the plug can be fully inserted into the

receptacles in the extension cord.

4. Do not alter the plug.

5. The lamp head included with this unit cannot be replaced by the consumer.

NOTE: The important safety instructions appearing in this instruction sheet are not

meant to cover all possible conditions and situations that may occur. It must be

understood that common sense, caution, and care must be used with any electrical

product.

CAUTION! IF THE ExTERNaL FLExIbLE CabLE OR CORD OF THIS LUmINaIRE IS

DamagED, IT SHaLL bE ExCLUSIvELY REPLaCED bY THE maNUFaCTURER OR ITS SERvICE agENT

OR a SImILaR qUaLIFIED PERSON IN ORDER TO avOID a HazaRD. INDOOR USE ONLY.

FCC PART 15

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that the interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that of the

receiver.

• Consult the dealer or an experienced radio/T V technician for help.

CAUTION: Any change or modiﬁcation to product not expressly recognized

by OttLite Technologies voids OttLite’s responsibility for proper function of product.

CAN ICES-3 (B) / NMB-3 (B)

AC/DC ADAPTER

Input: AC 120V-240V, 50/60 Hz, 0.2A

Output: 20V DC 0.37A with a male DC plug

English Natural Daylight LED Flex Floor Lamp

ble area for shade and

essory

e sécuritaire pour

at-jour et les

essoires

Area útil para la pantalla y

accesorios

DO NOT USE

OR ACCESSO

IN THIS AREA

NE PAS PLAC

L’ABAT-JOUR

CETTE ZONE

NO UTILICE L

PANTALLA Y

ACCESORIOS EN

ESTA AREA

1 / FIGURA 1

Natural Daylight LED Flex Floor Lamp

P9300C ACDL10F

Figure 2 / Figura 2

Figure 3 / Figura 3

Figure 4 / Figura 4

30º 30º

Produkt Specifikationer

Mærke:	OttLite
Kategori:	Lys
Model:	P93009

Har du brug for hjælp?

Hvis du har brug for hjælp til OttLite P93009 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lys OttLite Manualer

OttLite CS309G5W Manual

10 Februar 2025

OttLite Covington L1604NK9-SHPR Manual

22 Januar 2025

OttLite Archer L1604BS9-SHPR Manual

22 Januar 2025

OttLite P93009 Manual

22 Januar 2025

OttLite Creative Curves A30009-FFP Manual

12 Januar 2025

OttLite Good Housekeeping Manual

11 November 2024

OttLite Aglow Manual

10 November 2024

OttLite Rise Manual

11 September 2024

OttLite Shine Manual

11 September 2024

OttLite Power Up Manual

11 September 2024

Lys Manualer

Nyeste Lys Manualer

WiZ Ground Spot Extension Manual

12 November 2025

Sagitter ESA 3FZ Manual

12 November 2025

Lucide Jolijn Manual

12 November 2025

Antari F-1 PRO Manual

12 November 2025

Antari F-5 Fazer Manual

12 November 2025

Sagitter Slimbar 12P Manual

12 November 2025

Lucide Ramin Manual

12 November 2025

Kino Flo FreeStyle T41 LED Manual

12 November 2025

SDJ J-Wash 400 Manual

12 November 2025

Antari F-7 SMAZE Manual

11 November 2025