Panduit Pan-Punch 110 Manual

Panduit Ikke kategoriseret Pan-Punch 110

Læs gratis den danske manual til Panduit Pan-Punch 110 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Panduit Pan-Punch 110, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

Page 1 of 2

Pan-Punch 110 Punchdown System

Part Numbers: P110KB1004Y, P110KB1005Y, P110KB3004Y, P110KB3005Y, P110B1004R2Y,

P110B1005R2Y, P110B1004R4WJY, P110B1005R4WJY

CABLE REQUIREMENT: Terminates most 22-26 AWG solid or stranded

IWC wire with a 0.050" (1.27mm) max. o.d., either PVC or Plenum rated.

INSTALLATION

1. Use appropriate mounting hardware to install base on

desired surface as shown in Figure 1, 3/4" plywood is

recommended. (Tip: Panduit lettering should be upright).

2. Route cables through slots in the base as shown in Figures

1a (4-pair installation) or 1b (25-pair installation). The wire

strip color markings from left to right are white, red, blue,

yellow, and violet.

3. Insert each pair into position in wire strip slots while

maintaining the proper color sequence. Cable jacket end

should be within 1/2" from where cable pairs are inserted.

Cable pairs must remain twisted up to the point of

connection for Category 5e installation.

4. Inspect cable pair color placement prior to using a PDT110

single wire punchdown tool or PDT110M multi-pair

punchdown tool to seat and cut the pairs to length.

5. Position the connecting block over the wired base.

6. Secure the connecting block in place using the PDT110M

multi-pair punchdown tool. It is important to keep the tool

perpendicular to the base to ensure a good termination. Use

a combination of 3, 4, and 5-pair connecting blocks to

completely fill the wire strip, such as:

- Five 5-pair connecting blocks

- Five 4-pair connecting blocks and one 5-pair

connecting block

- Seven 3-pair connecting blocks and one 4-pair

connecting block

Figure 1a (4-pair installation)

Figure 1b (25-pair installation)

Figure 2b

Figure 2a

5 PAIR KIT

4 PAIR KIT

LOCATION

Mounting a system at the right height will make wiring changes The optimum heiand additions cost efficient. ght, from the

floor to the top of a 300 pair Pan-Punch base, is 68 inches. If the customer needs don’t exceed the wiring capacity of one

base of 100 pair, the optimum distance from the floor to the top of the system can be reduced to 43 inches. This height will

allow for expansion of 300 pair on top and 300 pair underneath.

4-pair cables are installed from the center out to the sides, in groups of

three. Three cables exit from the left and three exit from the right. Each

channel will contain 12 cables - 6 for upper strip and 6 for lower strip. Far

right slot will be unused.

For clarity, only first two cables are shown. Repeat for other side

WHITE RED BLUE YELLOW VIOLET

25 pair cable (for clarity, only 5 pairs shown) Tip colors marked in 5 pair increments

Notes:

1. Strip back outer jacket of 25-pair cable to edge of wiring block (up to

10 inches) and load one complete wire strip.

2. Follow tip color code sequence as indicated on wire strip.

P110CB

CONNECTING BLOCK

WIRE STRIP

P110B BASE

PDT110M

5-PAIR IMPACT TOOL

Produkt Specifikationer

Mærke:	Panduit
Kategori:	Ikke kategoriseret
Model:	Pan-Punch 110

Har du brug for hjælp?

Hvis du har brug for hjælp til Panduit Pan-Punch 110 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Panduit Manualer

Panduit C2CAC06ABWPAB1 Manual

2 September 2025

Panduit MIW094 Manual

2 September 2025

Panduit MIW125 Manual

2 September 2025

Panduit PES400 Manual

2 September 2025

Panduit CUCGF06DPW1 Manual

2 September 2025

Panduit CUEFRCKITW1 Manual

2 September 2025

Panduit MIM125 Manual

2 September 2025

Panduit CUSREORCPB1 Manual

2 September 2025

Panduit VS2-AVT-3IB Manual

27 August 2025

Panduit VS-AVT-C08-L10 Manual

27 August 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Turbo Air TBC-65SB-N6 Manual

2 September 2025

Speco Technologies N4WNRMM Manual

2 September 2025

Fromm & Starck STAR_FR_04 Manual

2 September 2025

XPower BR-282A Manual

2 September 2025

Grunkel SAN-GRILLNG Manual

2 September 2025

Phoenix Contact BL2 PPC AIO65 7000 Manual

2 September 2025

AVer DL10 Manual

2 September 2025

Rigol HDO1204 Manual

2 September 2025

XPower A-2B Manual

2 September 2025

Horizon Micro FCJJ-44 Manual

2 September 2025