Mounting
Bracket Arms
Decorative
Covers
Elliptical
Tilt Mount
Triple Mount
Structure Side Skirt Thread Depth
Indicator
M6 x 25mm
5
32˝ Allen Wrench
M4 x 16mmM4 x 25mm M5 x 16mm M5 x 25mm
M6 x 30mm M8 x 25mm M8 x 30mm M8 x 70mm Griplate™
Washers
AST-2446/2
x18
M8 x 16mm
Minimum four (4)
complete turns
Pan Philips
Threaded
Coupler
Mount
Lower Half
Upper Half
The ceiling should be capable of supporting a weight of at least ve times
the product weight. If not, the ceiling surface must be reinforced. Proper
installation procedure by qualied personnel as outlined in the installation
instructions must be adhered to.
Mounting hardware is not included with this product. Commercially
available hardware must be used for this installation. The hardware used
will depend on your installation environment (i.e. wood stud, concrete
surface, metal I-beam etc).
Separate the upper and lower halves of the AST-2446/2 by removing both
M8 screws and wave washers. Unpack the trio mount and place it on the
ground.
The set screw on the threaded coupler must be backed out in order for the
AST-2446/2 to be threaded into place.
Thread the lower half of the AST-2446/2 into the threaded coupler on the
trio mount. The lower half of the AST-2446/2 must be threaded fully until
the piece is safely secured to the threads, then tighten the screw back into
place. Use the screwdriver to tighten the set screw once the AST-2446/2
has been attached.
The following steps must be performed by a minimum of three people:
Two people lift the trio mount into place. Align the upper and lower halves
of the AST-2446/2. Slide the lower half/trio mount into the upper half of the
AST-2446/2.
It is recommended that the height, and location, of the ECM-3000 be
determined prior to performing the following steps.
Determine the mounting height. Align the M8 mounting holes on the upper
and lower halves of the AST-2446/2 and insert the M8 screws and wave
washers. Use the 516˝ wrench to tighten the M8 screws.
Verify that all hardware is secure and tight before proceeding to the next
section.
M4 x 30mm M5 x 30mm M6 x 16mm
M6 x 45mm M8 x 45mm
Universal Spacers
AST-2446/2
Lower Half
Upper Half
M8 Pan
Philips
Screw
Allen Wrench
x1 x3 x3 x6 x6
x18
x3 x1
x18x18 x18 x18
x18 x18 x18 x12 x24
x1
x18 x18 x18
x72
x18 x18
1
Required for installation
Included components
Max Flat-Panel Capacity: 80 lb. each
