Quoizel Dury RDY1712AWH Manual
Læs nedenfor 📖 manual på dansk for Quoizel Dury RDY1712AWH (2 sider) i kategorien Lys. Denne guide var nyttig for 42 personer og blev bedømt med 4.4 stjerner i gennemsnit af 21.5 brugere
Side 1/2
1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
2018 QuoizelInc.
Assembly Instruction Sheet #IS-RDY1712AWH
For Style RDY1712AWH
ReleasedDate:2018-01-31
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Please go to for product cleaning tips. Go to the selection.
(3) B10 Candelabra Base bulbs 60W Maximum.
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
A
Crossbar
Assembly
x 1
Mounting Screw
Hex Nut and
Lock Washer
Mounting Ball
A
Figure 3
B
Fixture
Body
x 1
C
Ceiling Canopy
with Nipple
x 1
D
Spacer Tube
x 1
STEP 1 Install Spacer Tube and Ceiling Canopy-
A. Pass the supply wires and ground wire from fixture through the
Spacer Tube (C) and the Ceiling Canopy with Nipple (B) in turn.
Place the nipple of the Ceiling Canopy with Nipple (B) through the
Spacer Tube (C) and thread the nipple onto the hex coupling on the
top center of the Fixture Body (D). Hand tighten until snug.
Figure 1
B
C
D
Hex Coupling
Supply Wires
with Ground Wire
STEP 2 -Installing the Crossbar Assembly
A. Pass the supply wires with ground wire from outlet box through the
Crossbar Assembly (A). Attach the Crossbar Assembly (A) to the
Outlet Box with the head of the Green Ground Screw facing you.
Secure the Crossbar Assembly (A) with Outlet Box Screws (not
included). Tighten until snug.
Supply Wires
with Ground Wire
Figure 2
Outlet Box Screws
(not included)
Outlet Box
A
STEP 3 -Test Fit the Ceiling Canopy to the Crossbar Assembly
A. Remove the mounting balls from the Crossbar Assembly (A). Place
the ceiling canopy onto the Crossbar Assembly (A) and secure with
mounting balls. Note: The ceiling canopy should be snug against the
ceiling and held tight with the mounting balls. If it is not, adjust the
length of the mounting screws on the Crossbar Assembly (A) by
unscrewing the preassembled hex nut and lock washer and then
screwing the mounting screws in or out of the crossbar until the
correct length is achieved. Once the ceiling canopy is secure,
remove the mounting ball and fixture and proceed to Step 4.
Ceiling Canopy
2of2
2018 QuoizelInc.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
ReleasedDate:2018-01-31
STEP 5 Install the Fixture Body-
A. Position the ceiling canopy and fixture body onto the Crossbar
Assembly (A). Place the holes in the ceiling canopy over the
mounting screws. Secure the fixture body by using the mounting
balls and hand tighten the mounting balls until snug.
Figure 5
Mounting Screw
Mounting Ball
A
STEP 6 Install Bulbs-
A. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Figure 6
Socket
Bulb (not
supplied)
RDY1712AWH
FINISH: ANTIQUE WHITE
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
12.5” Dia.
5.5” Dia.
13.5”
Ceiling Canopy
STEP 4 - Wire Connections
A.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Figure 4
Green Ground Screw
on the Crossbar
White wire
from outlet box White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Produkt Specifikationer
| Mærke: | Quoizel |
| Kategori: | Lys |
| Model: | Dury RDY1712AWH |
Har du brug for hjælp?
Hvis du har brug for hjælp til Quoizel Dury RDY1712AWH stil et spørgsmål nedenfor, og andre brugere vil svare dig
Lys Quoizel Manualer
2 Oktober 2024
1 Oktober 2024
26 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
23 August 2024
Lys Manualer
- Lys Osram
- Lys Workzone
- Lys Beurer
- Lys Nedis
- Lys Maxim
- Lys Profoto
- Lys Hudson Valley
- Lys Deltaco
- Lys Klarstein
- Lys Craftsman
- Lys Runtastic
- Lys Smartwares
- Lys Blackburn
- Lys WiZ
- Lys Omnitronic
Nyeste Lys Manualer
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
1 Juni 2025
31 Maj 2025
31 Maj 2025
31 Maj 2025
31 Maj 2025
31 Maj 2025