Rane MP 2016 Manual

Rane Blander MP 2016

Læs gratis den danske manual til Rane MP 2016 (8 sider) i kategorien Blander. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Rane MP 2016, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Manual-1

MP 2016

ROTARY DJ MIXER

OPERATORS MANUAL

QUICK START

The MP 2016 is not a UREI! The MP 2016 has many features absent in the UREI. To fully realize all of the benefits

provided by these additional features, please read the entire manual. For those of you who should read the manual, but

won’t, here’s the short version.

There are four dedicated phono preamplifiers. One each for Input Channels 1-4. Switches on the rear panel set each

preamplifier for LINE or PHONO operation. Make sure you have these switches set correctly for your application.

There are two dedicated MIC preamplifiers, one each for Input Channels 5-6. Rear panel switches set each preampli-

fier for LINE or MIC operation. Make sure you have these switches set correctly. MIC GAIN controls adjust each

preamplifier for the correct sensitivity. With a MIC selected and ENGAGED, set the INPUT GAIN control to “10” and

adjust MIC GAIN to just keep the Input Channel SIG/OL indicator green, not red. Set the tone controls as desired. The

MIC ENGAGE switch ducks the BOOTH Output by 12 dB unless defeated with internal jumpers.

All five stereo AUX Inputs are available for each of the six Input Channels.

Adjust INPUT GAIN controls so they blink the green SIG/OL indicator. If an indicator stays red, the INPUT GAIN

control is set too high. This provides optimum signal to noise, dynamic range and MIX LEVEL control consistency.

The BOOTH may select CUE or MASTER as its source. CUE allows monitoring Inputs in the booth without head-

phones.

The XP 2016 switch engages the optional XP 2016 processor. If the XP 2016 is not connected, the switch has no

effect. See page Manual-7 for XP 2016 features.

The EFFECTS LOOP switch switches the Loop in (up) or out (down). If nothing is connected to the EFFECTS

LOOP RETURN, the switch has no effect.

The MASTER MONO/STEREO switch influences both BOOTH and HOUSE OUTPUTS. It does not affect the

EFFECTS LOOP or TAPE OUTPUTS.

Two TAPE OUTPUTS are provided. One is PRE-EFFECTS Loop and one is POST-EFFECTS Loop. The POST-

EFFECTS Loop Tape Output has a LEVEL control and may be used as a pre-tone control AUX Output.

The MP 2016 uses high performance tone control circuits that isolate the signal into three bands. The level of each

band is independently controlled, and then recombined. This topology provides full “kill” for TREBLE, MID and BASS.

The MASTER SIG/OL indicator monitors the master mix before and after the tone controls. This indicator should

light green most of the time. It is OK for it to flash red on occasion. This provides optimum signal-to-noise and dynamic

range. HOUSE and BOOTH level controls do not affect the MASTER SIG/OL indicator.

The HOUSE OUTPUT has both BALANCED and UNBALANCED Outputs. Always use the BALANCED Outputs

for longer cable runs (typically greater than 10 feet, or 3 meters).

Headphone cueing allows monitoring MASTER or CUE SOURCE. If MIX LEVEL controls are operated at less than

“7”, be sure to turn the PHONES LEVEL down before selecting CUE SOURCE as it may be much louder than the

Master Mix. The Headphone Output is low-impedance high-current, so do not short the tip and ring together or to ground.

Never connect anything except an approved Rane power supply to the red thing that looks like a telephone jack on the

rear of the unit. This is an AC input and requires special attention if you do not have a power supply exactly like the one

originally packed with your unit. See the full explanation of the power supply requirements elsewhere in this manual.

WEAR PART

The MP 2016 contains no wear parts. The XP 2016 contains the following wear part subject to the ninety (90) day warranty

period described on page Service-1: (1) Active Crossover Assembly F 60.

Manual-2

MP 2016 FRONT PANEL CONTROLS

INPUT SELECTORS 1-4

Each six-position Input Selector chooses a dedicated

PHONO/LINE preamplifier, or one of five stereo AUX

Inputs as its Input Channel source. (PHONO/LINE switches

are located on the rear panel).

INPUT SELECTORS 5-6

Each six-position Input Selector chooses a dedicated

mono MIC Input, or one of five stereo AUX Inputs as its

Input Channel source. (MIC GAIN trim, MIC/LINE switch

and MIC tone controls are located on the rear panel).

MIC ENGAGE

MIC 1 and MIC 2 ENGAGE switches allow switching a

mic on (up) or off (down). MIC Input must be selected and

MIC ENGAGE on to activate a MIC Input. When a mic is not

in use, be sure to switch MIC ENGAGE off. The MIC

ENGAGE switches also activate the Booth Ducker. This

attenuates the Booth Output -12 dB whenever a MIC EN-

GAGE switch is on, even if MIC Input is not selected

(internal jumpers allow disabling the Booth Ducker—see

Mic/Line Inputs on page Manual-6).

INPUT GAIN

INPUT GAIN controls allow the user to match input

levels. Adjust these controls to make the SIG/OL indicator

flash green. If the indicators turn red, reduce the INPUT

GAIN. Adjusting the INPUT LEVEL controls correctly

maximizes dynamic range and provides consistent MIX

LEVEL response.

Input

SIG/OL

These dual color indicators provide help in setting correct

input levels. A flashing green indication is optimal. The red

indicator should remain off during normal operation.

MIX LEVEL

These studio-grade controls determine the Master MIX

LEVEL. For optimum performance, set the INPUT GAIN

controls as indicated above, and then operate MIX LEVELS

between “7” and “10” for full mix. Use the HOUSE and

BOOTH LEVEL controls to set the output levels. Always set

the MIX LEVEL controls to minimum when not in use.

Produkt Specifikationer

Mærke:	Rane
Kategori:	Blander
Model:	MP 2016

Har du brug for hjælp?

Hvis du har brug for hjælp til Rane MP 2016 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Blander Rane Manualer

24 Juni 2025

22 Juni 2025

22 Juni 2025

21 Juni 2025

21 Juni 2025

21 Juni 2025

21 Juni 2025

21 Juni 2025

21 Juni 2025

21 Juni 2025

Blander Manualer

Nyeste Blander Manualer

Ibiza Sound MX401 Manual

14 September 2025

Mackie 1642VLZ4 Manual

14 September 2025

Mackie ProFX10v3+ Manual

14 September 2025

Mackie Master Fader Control App Manual

14 September 2025

Mackie DL32S Manual

14 September 2025

Mackie 1402VLZ4 Manual

14 September 2025

Mackie Onyx 12 Manual

14 September 2025

Mackie ProFX12v3 Manual

14 September 2025

Mackie 1604VLZ4 Manual

14 September 2025

Mackie Pro FX30 v3 Manual

14 September 2025