Satel AVD-100 Manual

Satel Deur-/ramme sensor AVD-100

Læs gratis den danske manual til Satel AVD-100 (4 sider) i kategorien Deur-/ramme sensor. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 11 anmeldelser. Har du et spørgsmål om Satel AVD-100, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

147

AVD-100

WIRELESS VIBRATION DETECTOR

AND MAGNETIC CONTACT

avd100_en 11/16

The AVD-100 detector senses vibrations associated with attempts to force a door or window

(vibration detector), as well as detects opening of a door or window (magnetic contact). The

detector is designed for use as part of the ABAX two-way wireless system. This manual applies

to the detector with firmware version 5.01, which is supported by:

 ACU-120 / ACU-270 controller,

 ACU-100 / ACU-250 controller with firmware version 4.03 2014-05-15 (or newer),

 ARU-100 repeater with firmware version 2.00 2014-05-15 (or newer),

 INTEGRA 128-WRL control panel with firmware version 1.12 2013-12-20 (or newer).

1. Features

 Piezoelectric sensor.

 Advanced processing of signal from piezoelectric sensor.

 Two reed switches allowing to select the magnet installation manner.

 Remote configuration.

 LED indicator enabled in test mode.

 Tamper protection against cover removal and tearing enclosure from the wall.

2. Specifications

Operating frequency band ......................................................................... 868.0 MHz ÷ 868.6 MHz

Radio communication range (in open area).................................................................. up to 500 m

Battery......................................................................................................................... CR123A 3 V

Battery life expectancy ............................................................................................approx. 3 years

Standby current consumptio µA n.................................................................................................50

Maximum current consumption .............................................................................................16 mA

Typical detection range of vibration detector, depending on mounting surface:

concrete................................................................................................................ 1.5 m

brick...................................................................................................................... 2.5 m

wood ..................................................................................................................... 3.5 m

steel ......................................................................................................................... 3 m

PVC .................................................................................................................... 2.25 m

Environmental class according to EN50130-5............................................................................... II

Operating temperature range .................................................................................. -10 °C...+55 °C

Maximum humidity ............................................................................................................... 93±3%

Detector enclosure dimensions ........................................................................... 26 x 112 x 29 mm

Surface mounted magnet enclosure dimensions...................................................26 x 13 x 19 mm

Surface mounted magnet spacer dimensions.......................................................26 x 13 x 3.5 mm

Flush mounted magnet enclosure dimensions ......................................................28 x 10 x 10 mm

Weight ...................................................................................................................................... 78 g

2 AVD-100 SATEL

3. Description

The detector takes up two positions in the ABAX system (first: magnetic contact; second:

vibration detector). For some alarm systems, you can select when adding the detector, whether it

will occupy one or two positions on the list of devices. If the detector occupies one position, only

vibration detector is supported.

Electronics board

Figure 1 shows the inside of the detector.

CR123A lithium battery.

tamper switch.

The LED and reed switches are placed on the other side of the

electronics board.

Alarms

The detector reports alarm in the following cases:

 opening enabled reed switch contacts after removal of magnet,

 registering of strong vibrations,

 registering of a predefined number of weak vibrations,

 opening the tamper switch (tamper alarm).

Operating modes

The detector operating mode is defined remotely.

Active – information about each alarm is sent immediately.

Passive – information about tamper alarm is sent immediately, while

information about other alarms is sent only during the polling time.

This operating mode prolongs the battery life.

Test mode

If you want to test the detector, you can remotely enter the test mode.

When in the test mode, the detector LED is working.

LED

The LED is working for 2 minutes after battery is inserted, as well as in the test mode. The LED

indicates:

 polling – short flash (80 milliseconds),

 alarm – ON for 2 seconds.

Battery status control

When the battery voltage is below 2.75 V, information about low battery is sent during each

transmission.

Note: For additional information about the detector and its configuration please refer to the

manual for ABAX wireless system controller.

4. Installation

There is a danger of battery explosion when using a different battery than

recommended by the manufacturer, or handling the battery improperly.

Be particularly careful during installation and replacement of the battery. The

manufacturer is not liable for the consequences of incorrect installation of the

battery.

Produkt Specifikationer

Mærke:	Satel
Kategori:	Deur-/ramme sensor
Model:	AVD-100

Har du brug for hjælp?

Hvis du har brug for hjælp til Satel AVD-100 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Deur-/ramme sensor Satel Manualer

Satel AMD-103 Manual

21 August 2024

Satel S-3 Manual

19 August 2024

Satel AVD-100 Manual

17 August 2024

Deur-/ramme sensor Manualer

Nyeste Deur-/ramme sensor Manualer

Optex OA-4500 Manual

30 December 2025

Optex OA-Edge T Manual

5 December 2024

ORNO OR-SH-17600 Manual

6 September 2024

ORNO OR-SH-17601 Manual

6 September 2024

Emos THS916A Manual

4 September 2024

Emos GS827 Manual

4 September 2024

Emos GS869 Manual

4 September 2024

Avidsen HomeSensor Window Manual

4 September 2024

Kanlux ROLF JQ-L Manual

4 September 2024

Kanlux SENTO Manual

4 September 2024