TCW Technologies SS-12v Manual


Læs gratis den danske manual til TCW Technologies SS-12v (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 15 anmeldelser. Har du et spørgsmål om TCW Technologies SS-12v, eller vil du spørge andre brugere om produktet?

Side 1/8
1
SmartStart
Model: SS-12v
SmartStart is an electronic control module for the engine starter system on
aircraft. SmartStart improves the safety and security of push-button or key-
switch starting systems by providing an interlocked and time limited operation of
the engine starter. SmartStart controls standard aviation starter contactors and
provides simple integration of control stick switch or panel mounted start
switches. SmartStart includes inputs for interlock and arming switches and
provides a 1 minute timer for activating the starter contactor. The SmartStart
system helps avoid unintentional activation of the engine starting system.
SS-12v is not TSO’d and must only be used in aircraft certified in the
Experimental category.
SS-12v must be installed using the current aircraft standards and
practices. Refer to AC 43.13-2A/1B. The installer/builder is solely responsible
for determining the suitability of the installation and use of this product.
2
Important Notes:
1) SmartStart has an optional Interlock Switch input that may be used to
enable/disable the start contactor. Door/canopy switches may be used to
ensure the engine cannot be started until the door/canopy is properly closed.
This input is a closure to ground to ENABLE the system.
2) It is recommended that the Arming Switch be hidden from view to improve
theft resistance of the aircraft.
3) If using a traditional aircraft keyed mag/start switch and an optional interlock
switch is used, then the terminal marked “Bat” on the key switch is connected to
pin 4, “armed power” on SmartStart.
4) Two wiring diagrams are provided, one with and one without the use of an
interlock switch.
5) All switches used with SmartStart are of the momentary type and need no
particular current rating. The switching of the start contactor is done
electronically with no moving parts and includes fly-back diode protection for the
start contactor.
6) An optional “Armed LED” indicator may be driven from the SmartStart module.
The maximum current on this pin is 50 mA. Do not use with incandescent
indicator lamps. If this feature is unused, leave this pin un-populated in the
connector.
7) An optional Airspeed Switch, model ASW-2, may be connected in parallel with
the arming switch. The use of the airspeed switch will allow in flight restarting
without the need to press the arming switch. When the aircraft is above the
airspeed switch set point (factory calibrated at 40 knots) the arming circuit is
continuously made thereby ensuring the start switch is always active in flight.
Installation instructions:
1) Select an installation diagram that matches the required installation. Diagrams
are provided for installations with and without an interlock switch connection.
Wire aircraft harness per appropriate diagram.
2) Provide power to the SmartStart module through a 5 amp fuse or breaker.
3) The SmartStart module uses a standard 9 pin D-sub connector with the male
pins on the module. Terminate the harness wires in a mating female D-sub
connector.
4) If desired, mount the “Armed LED” on the instrument panel.


Produkt Specifikationer

Mærke: TCW Technologies
Kategori: Ikke kategoriseret
Model: SS-12v

Har du brug for hjælp?

Hvis du har brug for hjælp til TCW Technologies SS-12v stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret TCW Technologies Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer