Valcom VIP-422A Manual

Valcom Højttaler VIP-422A

Læs gratis den danske manual til Valcom VIP-422A (3 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Valcom VIP-422A, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
1 947764
Issue 1
VIP-422A
LAY-IN TALKBACK IP CEILING SPEAKER
INTRODUCTION
The VIP-422A Lay-In Talkback IP Ceiling Speaker
enable voice access to a single zone of paging over
an IP-based network. This allows a page zone
extension anywhere on the network. The speaker
output level is electrically adjusted during setup.
The lay-in ceiling speaker grille is made of steel
with a white baked enamel finish. The VIP-422A
replaces a 2’ x 2’ ceiling tile. Power is provided to
the unit via a Power over an Ethernet (PoE) switch
meeting the 802.3af specification.
SPECIFICATIONS
Access Methods
PBX, FXO Port w/VIP-811
POTS telephone set w/VIP-811
PBX, FXS Port w/VIP-821
Valcom M Cast Page Group
SIP – enabled telephone system
Features
RJ-45 network connection
Power over Ethernet (PoE) 802.3af compliant
High Efficiency Class-D Amplifier
Environment
Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating
Packing List
Qty. Item
1 Lay-in Ceiling Speaker
1 VSP Document
INSTALLATION
Dimensions/Weight
VIP-422A:
23.75” L x 23.75” W x 3.75” D
(60.33cm) x (60.33cm) x(9.53cm)
Weight: 5.5 lbs. (2.49kg)
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates uses,
and can radiate radio frequency energy and if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case
the user will be required to correct the
interference at his own expense.
2 947764
Network Connection
The VIP-422A has one RJ-45 network connector on
the rear panel. Use a standard Ethernet patch cable
to connect the unit to an Ethernet switch.
Call Switch Connection
For IP Speakers using Talkback functionality, a call
switch input via screw terminals is provided.
Connect a momentary contact switch to Switch 1
and Ground.
-10 dB Line Level Out Connection
The -10dBm Line Level Out may be connected to
up to 40 Valcom Self Amplified Speakers in order to
provide additional sound reinforcement in an area.
IP SPEAKER CONNECTIONS
FIGURE 1
Mute Out Connection
The Mute Out may optionally be connected to the
mute input of Valcom audio management systems
in order to suspend locally originated audio during
intercom announcements. (See Figure 1)
LED 1 and LED 2 Connection
LED 1 (+) and LED 2 (-) is a current limited output
designed to illuminate an optional LED. The LED is
intended to provide visual indication of call
progress. The LED illumination will flash when the
call switch is pressed and will continue to flash until
the call is answered. The LED illumination will be
solid when a connection to the unit is established.
IMPORTANT SAFETY INFORMATION
CONSIGNES DE SÉCURITÉ IMPORTANTES
1. Read these instructions.
Lisez ces instructions.
2. Keep these instructions.
Conservez ces instructions.
3. Heed all warnings.
Respectez tous les avertissements.
4. Follow all instructions.
Suivez toutes les instructions.
5. Do not use this apparatus near water.
Ne pas utiliser cet appareil près de l'eau.
6. Clean only with dry cloth.
Nettoyer avec un chiffon sec.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
Ne pas bloquer les ouvertures de ventilation. Installer formément aux instructions du
fabricant.
8. Do not install near any heat sources such as radiators, heat registers, stoves or other
apparatus (including amplifiers) that produce heat.
Ne pas installer à proximité de sources de chaleur telles que radiateurs, registres de
chaleur, poêles ou autres appareils (y compris les amplificateurs) produisant de la chaleur.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade and the third prong are provided for your safety. If
the provided plug does not fit into your outlet consult an electrician for replacement of the
obsolete outlet.
Ne pas contourner le dispositif de sécurité de la fiche polarisée ou de mise à la terre. Une
fiche polarisée possède deux lames dont une plus large que l'autre. Une fiche de terre a
deux lames et une troisième broche de mise à la terre. La lame large et la troisième
broche sont fournies pour votre sécurité. Si la fiche fournie ne rentre pas dans votre prise,
veuillez consulter un électricien pour le remplacement de la prise obsolète.
10.Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles and the point where they exit from the apparatus.
11.Only use attachments/accessories specified by the manufacturer.
N'utilisez que des fixations / accessoires spécifiés par le fabricant.
12. Use only with the cart, stand, tripod, bracket or table specified
by the manufacturer or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
Utilisez uniquement avec le chariot, stand, trépied, support ou table spécifié par le
fabricant ou vendu avec l'appareil. Quand un chariot est utilisé, Soyez prudent lorsque
vous déplacez l'ensemble chariot / appareil pour éviter des blessures dues au
renversement.
13. Unplug this apparatus during lightning storms or when unused for a long period of time.
Débranchez cet appareil pendant les orages ou lorsqu'il n'est pas utilisé pendant une
longue période de temps.
14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way. Such as when the power supply cord or plug is
damaged, liquid has been spilled, objects have fallen into the apparatus or the
apparatus has been exposed to rain or moisture and does not operate normally or has
been dropped.
Confiez toute réparation à un personnel qualifié. Une réparation est nécessaire lorsque
l'appareil a été endommagé de quelque façon. Par exemple lorsque le cordon
d'alimentation ou la fiche est endommagé, du liquide a été renversé, si des objets sont
tombés dans l'appareil ou le appareil a été exposé à la pluie ou à l'humidité et ne
fonctionne pas normalement ou s'il est tombé.

Produkt Specifikationer

Mærke: Valcom
Kategori: Højttaler
Model: VIP-422A

Har du brug for hjælp?

Hvis du har brug for hjælp til Valcom VIP-422A stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Valcom Manualer

Valcom

Valcom VIP-421 Manual

6 September 2024
Valcom

Valcom InformaCast VIP-120-IC Manual

6 September 2024
Valcom

Valcom InformaCast VIP-402A-IC Manual

6 September 2024
Valcom

Valcom VIP-422A Manual

6 September 2024
Valcom

Valcom V-1019B Manual

6 September 2024
Valcom

Valcom V-1020C Manual

6 September 2024
Valcom

Valcom S-522A-2 Manual

6 September 2024
Valcom

Valcom Clarity S-515 Manual

6 September 2024
Valcom

Valcom V-1023C Manual

6 September 2024
Valcom

Valcom V-1040 Manual

6 September 2024

Højttaler Manualer

Nyeste Højttaler Manualer

LENRUE

LENRUE A2 Manual

15 Juni 2025
Sony

Sony BRAVIA Theatre Bar 6 Manual

15 Juni 2025
Hecate

Hecate G1500 SE Manual

15 Juni 2025
Edifier

Edifier MP330 Manual

15 Juni 2025
Hecate

Hecate G1500 Manual

14 Juni 2025
XLEADER

XLEADER SoundAngel A8 Manual

14 Juni 2025
RCF

RCF DU 31EN Manual

14 Juni 2025
Omnitronic

Omnitronic PS-2.5WB Manual

14 Juni 2025
Greadio

Greadio R-919 Manual

14 Juni 2025
J.W. SPEAKER

J.W. SPEAKER 8700 Evolution J2 Manual

14 Juni 2025