Viking E-30-PT Manual


Læs gratis den danske manual til Viking E-30-PT (8 sider) i kategorien Samtaleanlæg. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Viking E-30-PT, eller vil du spørge andre brugere om produktet?

Side 1/8
PRODUCT MANUAL
Designed, Manufactured and Supported in the USA
S E C U R I T Y & C O M M U N I C AT I O N S O L U T I O N S
Provide Reliable and Intelligent
Communication In Noisier Locations
Features
The E-30-PT is designed to provide quick and reliable
communication in noisier areas. The mic sensitivity is set
to a low level until the TALK button is pressed then it is
raised to a normal level. In this way, the assuresE-30-PT
that the called party’s voice will be broadcast over the
speaker. In applications where the background noise
can be louder than the person calling, a handset type
phone is recommended.
The E-30-PT features non-volatile memory, a built in
dialer, and intelligent call progress detection for automatic
hang-up when the call is completed. The can beE-30-PT
programmed to dial up to 5 different numbers on ring no
answer or busy and can be configured to dial these
numbers until answered.
The E-30-PT-EWP shares all of the features of the
E-30-PT in addition to Enhanced Weather Protection
(EWP) for outdoor installations where the unit is exposed
to precipitation or condensation. EWP products feature
foam rubber gaskets and boots, silicon sealed
connections, gel-filled butt connectors, as well as
urethane or thermal plastic potted circuit boards with
internally sealed, field-adjustable trim pots and DIP
switches for easy on-site programming.
Vandal Resistant Features: 14 gauge louvered 316
stainless steel faceplate with permanent laser etched
graphics, speaker/mic screen, heavy duty metal “Call”
button and T-10 Torx security mounting screws
Marine grade 316Weather Resistant Features:
stainless steel faceplate, T-screws and push button
switch. Switch internally sealed per IP67. Mylar
speaker. Self-draining mic mount. Faceplate, mic and
speaker gaskets. Weather resistant powder paint on
optional ( ).VE-5x5 DOD 424
E-30-PT-EWP is designed to meet IP66 Ingress
Protection Rating (see for more information)DOD 859
• Push to talk button
• Telephone line powered
• Non-volatile E2memory (no batteries required)
• Programmable to dial up to 5 numbers on busy or ring
no answer
• Blue off-hook LED indicator
• Volume adjustments for microphone and speaker
Advanced call progress detection: disconnects on
busy signal, return to dial tone, CPC, reorder tone,
maximum call time out and programmable silence
time out
• Selectable auto-answer feature for monitoring
• Selectable push button disconnect
• Extended temperature range (-30°F to 150°F)
• Flush mountable using included plastic rough-in box
• Optional surface mount back box ( )VE-5x5 DOD 424
Non-ADA Hot-Line Phones for:
• Terminals • Parking lots/ramps
• Stadiums • Convention centers
ATM machines
Gate and Door Entry Phones for:
• Business lobbies • Residences
• Vehicular and Pedestrian gates
Power: Telephone line powered. Minimum 24V DC talk
battery voltage, with a minimum loop current of 20mA
loop. Loop current may be boosted on low current lines
with a Viking Model talk battery booster (seeTBB-1B
DOD 632).
Minimum Ring Voltage: 90VAC RMS
Dimensions: Overall-5” x 5” x 2.25” (127mm x 127mm x
57mm), Plastic Electrical Box-4x 4” x 2.12(102mm x
102mm x 54mm )
Shipping Weight: 2.2 lbs (1 Kg)
Operating Temperature: -30°F to 150°F (-34°C to 65° C)
Humidity - E-30-PT: 5% to 95% non-condensing
Humidity - E-30-PT-EWP: Up to 100% condensing
Connections - E-30-PT: RJ11 jack
Connections - E-30-PT-EWP: Gel-filled butt connectors
E-30-PT/EWP
Speaker Phone with
Push to Talk Button
February 5, 2018
Applications
Specifications
VIKING
E-30-PT/E-30-PT-EWP
Brushed 316 Stainless steel
shown with optional VE-5x5
CAUTION - When installing on an analog extension of a phone
system: Some phone systems do not conform to analog telecom
standards and might not be compatible with the E-30-PT speaker
phones. For a detailed description of the telephone line
specifications required for any of the E-30-PT phones, see DOD#
869.
Features Overview
Installation
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
Caution: When warm air comes in contact with cold surfaces, such as outside walls, it causes condensation. To help
prevent condensation from accumulating inside the , bring conduit into the bottom of the unit. If this is notE-30-PT
possible, drill a 1/4” diameter hole in the bottom of the plastic rough-in box.
*Note: Peel off paper liner and adhere gasket to the back of the faceplate, centering it over the four corner mounting
holes. Be careful to position the modular jack inside the chassis as not to damage the components on the circuit
board.
A. Mounting
2
1 2
ON
CALL
VIKING©
PUSH TO TALK BUTTON: Raises microphone
volume to normal level when pressed.
Speaker Screen: Stainless steel speaker
screen with 0.018" diameter holes to prevent
punctures from paperclips, etc.
Faceplate: 14 gauge Marine grade 316
stainless steel faceplate and push button
switch (sealed per IP67). Speaker: Mylar speaker with rubber gasket to
maintain water-tight seal and eliminate water
deterioration.
Condensation Drain Hole
Mounting Screws: (4) 6-32 x 3/4" Marine
grade 316 stainless steel, flat head, 5/64"
hexdrive, screws (included).
LED: Lights Blue for "In-Use" indication.
Faceplate Gasket: 1/8" thick closed cell PVC
to provide a water-tight seal.
Earth Ground: To increase surge protection,
loosen the screw labeled (as shown) and
fasten a wire with ring terminal (included) from
the mounting screw to Earth Ground (grounding
rod, water pipe, etc.)
Microphone Volume
Speaker Volume
DIP Switches (see page 7):
1: Push Button Feature (connect / disconnect)
2: Auto Answer Feature (on/off)
3: Programming Switch (normal/programming)
Microphone: Omni-directional microphone
with protective water-resistant cloth.
DIP Switches (see page 7):
1: Normal Audio Detection
2: Increased Audio Detection
PUSH TO
TALKCALL Button: Push to initiate call, push again
to disconnect. Solid 316 stainless steel
internally sealed per IP67.
Front View of Optional
VE-5x5 (not included)
2.25”
Condensation
Drain Hole
5.14”
5.22” 3.25”
Rear View of VE-5x5
(not included)
(4) 0.38 diameter
(for gooseneck mounting)
(4) 0.2 x 0.43 slots
for double gang box
(2) 0.2 x 0.43 slots
for single gang box
(1) .74" dia 3.0” 3.3”
3.0”
Wall Stud
Front View of
Plastic Rough-In
Box (included)
Wire knock out
39.5”
41.41”
3.81”
* Adhere gasket to front panel,
centering over mounting holes
CALL
PUSH T O
T ALK
CALL
CO N NE CT E D
4.0"
"Push to Talk"
Button
Call Connected Red LED
"Call" Button
5.0”
2.1”
Marine grade 316 stainless steel faceplate
and push button switches (sealed per IP67)
(4) 6-32 X 3/4” Marine grade 316 stainless steel, flat
head, 5/64" T-10 Torx Security Screws (included)
Side View of
VE-GNP
(not included)
(2) Standard flat head dry wall
(sheet rock) screws (not included)
Condensation
Drain Hole
Important: E-30-PTThe will
NOT mount to a standard
double gang box.
Note: The plastic rough-in box (part # ) may be purchased separately in advance. Go to259576
www.vikingelectronics.com and click on “ ”. Spare Parts


Produkt Specifikationer

Mærke: Viking
Kategori: Samtaleanlæg
Model: E-30-PT
Kode for international beskyttelse (IP): IP67
Bredde: 127 mm
Dybde: 57 mm
Højde: 127 mm
Vægt: 1000 g
Produktfarve: Rustfrit stål
Driftstemperatur (T-T): -26 - 54 °C
Forbindelsesteknologi: Ledningsført
Certificering: FCC Part 68\nFCC Part 15
Placering: Væg
Nem at installere: Ja
Antal knapper: 2
Antal udendørs enheder: 1
Indendørsenhed inkluderet: Ingen
Udendørsenhed inkluderet: Ja

Har du brug for hjælp?

Hvis du har brug for hjælp til Viking E-30-PT stil et spørgsmål nedenfor, og andre brugere vil svare dig




Samtaleanlæg Viking Manualer

Samtaleanlæg Manualer

Nyeste Samtaleanlæg Manualer