Audio-Technica ATW-RM1 Manual

Audio-Technica Ikke kategoriseret ATW-RM1

Læs gratis den danske manual til Audio-Technica ATW-RM1 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 47 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 24 anmeldelser. Har du et spørgsmål om Audio-Technica ATW-RM1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Professional UHF

Wire less Sys mste

ATW-RM1 Rack Mount Hardware Kit

Installation and Operation

Assembly Instructions/ATW-RM1 Rack-mount Hardware Kit

For use with Audio-Technica 2000 and 3000 Series wireless

systems and for the ATW-DA49 antenna distribution system.

This kit contains the hardware necessary for mounting a half-rack

receiver or distribution system in a 19" audio equipment rack; also

brings antennas to the front for improved reception.

The following parts are included:

• Long rack ear

• Short rack ear

• Two BNC bulkhead connectors with mounting hardware

• Two 34" BNC-to-BNC cables

• Six rack ear screws

Figure 1

How to assemble the ATW-RM1 Rack Mount Hardware Kit (see Fig. 1)

1. Remove the nut and lock-washer from each bulkhead connector.

Install the connectors into the two holes in the longfrom the front

rack ear (see Fig. 1). Note that the flat on the threaded section

must be aligned with the flat in each panel hole.

2. Install the lock-washer and nuts (included) over the back of each

bulkhead connector. Secure each connector from the back with its

lock-washer and nut, tightening the nut firmly.

3. Connect one end of each provided BNC-BNC cable to the rear

antenna input jacks on the back of the receiver (or antenna distribution

system amplifier). Attach the other end of each cable to the back of

the BNC bulkhead connectors. Make certain the bayonet twist-rings

are latched on the connectors at both ends.fully

4. Finally, mount the receiver's antennas to each of the BNC bulkhead

connectors.

Bulkhead Connector

Rubber Washer

Lock-Washer

Nut

BNC-BNC Cables

Long Rack Ear

Short Rack Ear

Antennas (not included)

Produkt Specifikationer

Mærke:	Audio-Technica
Kategori:	Ikke kategoriseret
Model:	ATW-RM1

Har du brug for hjælp?

Hvis du har brug for hjælp til Audio-Technica ATW-RM1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Audio-Technica Manualer

Audio-Technica AT33xMONO Manual

6 December 2025

Audio-Technica AT-SC500BB Manual

4 December 2025

Audio-Technica AT-HPC3 Manual

4 December 2025

Audio-Technica AT6098a Manual

29 September 2025

Audio-Technica AT628a Manual

29 September 2025

Audio-Technica AT-HDSL1 Manual

2 August 2025

Audio-Technica AT85EP Manual

2 August 2025

Audio-Technica AT6028 Manual

20 Juli 2025

Audio-Technica AT-VM670xSP Manual

19 Juni 2025

Audio-Technica AT-VM740xML Manual

18 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Waterstone 7800 Manual

11 December 2025

Kwikset 258 Manual

11 December 2025

Schlage F170 Manual

11 December 2025

Moen Align 7565EV Manual

11 December 2025

Energy Sistem ESG M3 Neon Manual

11 December 2025

ALNO MC10244 Manual

11 December 2025

JET TAK-ZX Manual

11 December 2025

Crosley Nashville CF1165 Manual

11 December 2025

Waterstone 1455 Manual

11 December 2025

Laica NE2015 Manual

11 December 2025