Audio-Technica System 9 ATW-902A Manual

Audio-Technica Ikke kategoriseret System 9 ATW-902A

Læs gratis den danske manual til Audio-Technica System 9 ATW-902A (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Audio-Technica System 9 ATW-902A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

System 9

VHF Wireless System

Installation and Operation

ATW-901a/G

Guitar System

ATW-901a/H

Headworn Microphone System

ATW-901a/L

Lavalier Microphone System

ATW-902a

Handheld Microphone System

PEAKRF

1 2 3 4

CHANNEL

System 9 Installation and Operation

This d

evic lie comp es w th part i 15 of the FCC Rul t t es. Opera ion is bjsu ec

to th e ti condi on that t devi mhis ce does not cause har fu tel in rfe e. renc

A copy of the declaration of conformity can be found on the internet at

www.audio-technica.com.

This device complies with Industry Canada license- empt RSS ex

standard(s). Operation is subject to the following two conditions: (1)

this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired

operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada

applicables aux appareils radio empts de licence. L'exploitation est ex

autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas

produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout

brouillage radioélectrique subi, même si le brouillage est susceptible

d'en compromettre le fonctionnement.

CAUTION! Electrical shock can result from rem al of the receiver ov

serviceable parts inside. Do not expose to rain or moisture.

The circuits inside the receiver and transmitter h e been precisely av

adjusted for optimum performance and compliance with federal

regulations. Do not attempt to open the receiver or transmitter. To do so

will void the warranty, and may cause improper operation.

Notice to individuals with implanted cardiac pacemakers or AICD

devices:

Any source of RF (radio frequency) energy may interfere with normal

functioning of the implanted device. All wireless microphones have

low-p er transmitters (less than 0.05 watts output) which are unlikely ow

Ho ver, since a “body-pack” mic transmitter typically is placed against we

the body, we suggest attaching it at the belt, rather than in a shirt

pocket where it may be immediately adjacent to the medical device.

Note also that any medical-device disruption will cease when the RF

transmitting source is turned off. Please contact your physician or

medical-device provider if you h e any questions, or experience any av

problems with the use of this or any other RF equipment.

Thank you for choosing an Audio-Technica professional wireless

have chosen our products because of their quality, performance and

reliability. This wireless microphone system is the successful result of

years of design and manufacturing experience.

Audio-Technica’s System 9 is a four-channel frequency-agile wireless

system designed to provide rock-solid performance along with

easy setup and clear, natural sound quality. Featuring stackable,

contemporary styling, System 9 is ailable in handheld, headworn, av

compatible user-switchable channels in one of four ailable VHF av

frequencies (169.505, 170.245, 171.045, and 171.905 MHz).

Each Sys m fes nte 9 pro sio al VH i l yF w re ess s ste nc udem i l s a cere iver

and i y-pac e ther a bod k transmitter or l a handhe d mi e/ an microp onh tr s tter.

ATW 0-9 1a UniPak

® b yod -pack tran tsmi ter systems include d mo els

pr -pe acka i i AT- it l Gged w th e ther an GCW gu ar cab e (/ ), a PRO EcW 8H

headworn cropho mi ne (/H), or a lavali mier c (/L) or partf icu r at nsla ap licp io .

All A-T W el Eir ess ssen stial ® h microp ones and ca s, av e ble ailabl se rapa tely,

ar e-te nated e r p rmi f i ny ATW 0or use w th a -9 1 system.

Because System 9 packaging is designed to hold all versions

of the system, some compartments in the carton may be intentionally

left empty.

The ATW-R900a receiver includes a switching power supply that

automatically adapts to changes in mains voltage.

The versatile ATW-T901a UniPak body-pack transmitter has both

a high-impedance input for instruments, and a low-impedance input

with bias connection for use with dynamic and electret condenser

microphones. The ATW-T902a handheld transmitter features a

unidirectional dynamic microphone element.

Both the body-pack and handheld transmitters use internal AA batteries

and h e Power/Mute switches and input Trim (l el) adjustments.av ev

Receiver Installation

Location

For best operation the receiver should be at least 3' (1 m) ab e the ov

ground and at least 3' (1 m) y from a wall or metal surface to awa

sources such as digital equipment, motors, automobiles and neon

lights, as well as away from large metal objects. In multi-channel

systems, position receivers at least 3' (1 m) apart and keep operating

transmitters at least 6' (2 m) from the receivers to help assure

maximum RF performance.

Output Connections

There are two audio outputs on the back panel: balanced and

unbalanced. Use shielded audio cable for the connection between the

receiver and the mixer. If the input of the mixer is a 1/4" jack, connect a

cable from the 1/4" unbalanced audio output on the back of the receiver

housing to the mixer. If the input of the mixer is an XLR-type input,

connect a cable from the balanced XLR-type audio output on the back

panel to the mixer.

Power Connection

Connect the DC plug on the included AC p er adapter to the DC ow

p er input on the back of the receiver. Secure the cord over the cord ow

hook on the back of the receiver, to keep the plug from being detached

by an accidental tug on the cord. Then plug the adapter into a standard

120 Volt 60 Hz AC p er outlet. ow

(Note that the receiver has no p er Off/On switch. The receiver will be ow

energized when er the power adapter is connected and plugged into ev

the AC outlet. Unplug the p er supply from the AC outlet when the ow

system is not in use — both for safety, and to conserve energy.)

Antennas

A n el “dipole” antenna system on the receiver improves operation ov

by providing a “ground” element in addition to the usual “signal”

element. Position the two antennas at 90° in the form of a “V,” or

position the left (“signal”) antenna vertically and the right (“ground”)

antenna horizontally, in the shape of an “L” (Fig. A). Use the position

that performs better in your operating environment. Be certain to

extend both antennas to their full 15" (38 cm) length by holding them at

their bases and pulling out on their caps. Both antenna elements may

be swiveled to the left and right, but do not attempt to rotate them in a

screwing/unscrewing motion. To do so may damage the antenna and/or

receiver. For best performance, locate the receiver so its antennas are

in direct line-of-sight to the transmitter’s likely operating position.

Produkt Specifikationer

Mærke:	Audio-Technica
Kategori:	Ikke kategoriseret
Model:	System 9 ATW-902A

Har du brug for hjælp?

Hvis du har brug for hjælp til Audio-Technica System 9 ATW-902A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Audio-Technica Manualer

Audio-Technica AT-VM740xML/H Manual

15 Juni 2025

Audio-Technica AT-VM750xSH/H Manual

15 Juni 2025

Audio-Technica AT8705 Manual

1 Juni 2025

Audio-Technica AT-VMN60xSL Manual

31 Maj 2025

Audio-Technica AT-VMN20xEB Manual

31 Maj 2025

Audio-Technica AT-VMN70xSP Manual

31 Maj 2025

Audio-Technica AT-VMN30xEN Manual

30 Maj 2025

Audio-Technica AT-VMN10xCB Manual

30 Maj 2025

Audio-Technica AT-VMN50xSH Manual

30 Maj 2025

Audio-Technica AT-VMN45xML Manual

30 Maj 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Planet XGPN-100 Manual

15 Juni 2025

Proficook PC-EKA 1283 Manual

15 Juni 2025

OmniMount OBSP8 Manual

15 Juni 2025

Levenhuk FS10 Manual

15 Juni 2025

Vestil PM4-2148-LP Manual

15 Juni 2025

ElectriQ STRV-W1-B Manual

15 Juni 2025

Adler AD 4521 Manual

15 Juni 2025

AMX HydraPort HPX-AV102 Manual

15 Juni 2025

Hughes & Kettner Red Box Mk II Manual

15 Juni 2025

Hughes & Kettner Quantum QC 412 Manual

15 Juni 2025