Crestron DM-TX-4KZ-202-C Manual

Crestron AV forlænger DM-TX-4KZ-202-C

Læs gratis den danske manual til Crestron DM-TX-4KZ-202-C (2 sider) i kategorien AV forlænger. Denne vejledning er vurderet som hjælpsom af 40 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 20.5 anmeldelser. Har du et spørgsmål om Crestron DM-TX-4KZ-202-C, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

DO GUIDE

DM-TX-4KZ-202-C/DM-TX-4KZ-302-C

DigitalMedia 8G+® 4K60 4:4:4 HDR Transmitters

DO Connect the Device

Connect the device as required for the application.

Connections, Left Side (DM-TX-4KZ-302-C Shown)

Connections, Right Side

DO Install the Device

The Crestron® DM-TX-4KZ-202-C and DM-TX-4KZ-302-C can be mounted onto a at surface or onto

a rack rail.

Mounting onto a Flat Surface

Using four mounting screws (not included), mount the device onto a at surface such as a wall or a

ceiling.

Mounting onto a Wall

Mounting onto a Rack Rail

The DM-TX-4KZ-202-C and DM-TX-4KZ-302-C mount onto the front or rear rail of a rack. Position

either the left or right mounting ange of the device so that the holes align with the holes in the rack.

Then, secure the device to the rack using two rack mounting screws (not included).

Mounting onto a Rack Rail

DO Check the Box

QTY PRODUCT PART NUM.

1 Connector, 2-Pin 2003574

1 Connector, 5-Pin 2003577

1 Power Pack, 24 Vdc 1.25 A, 100-240 Vac 2045870

HDMI IN 1–2:

From HDMI®

audio/video

sources

DM OUT:

To DM® switcher,

receiver, or other

DM device or to

HDBaseT® device

24 V

1.0 A:

From included

power pack

HDMI OUT:

To HDMI

display

DISPLAY

PORT IN:

DisplayPort digital

video/audio input*

*DISPLAY PORT IN is available on the DM-TX-4KZ-302-C only.

COMPUTER:

To computer

or other USB

HID compliant

host

IR:

To IR

controllable

device

LAN:

10BASE-T/

100BASE-TX

Ethernet to

local network

device

COM:

RS-232

device

USB HID:

To mouse/

keyboard or

other USB HID

compliant device

Ground

DO GUIDE DOC. 7939A (2050054) 12.17

Specications subject to change without not ice.

NOTE: The DM OUT port is a PoDM+ powered device (PD) port and is also compatible with

HDBaseT® PoE+. To receive PoDM+, the device requires connection to a DigitalMedia™ switcher or

other equipment that has a corresponding PoDM+ power sourcing equipment (PSE) port. To receive

HDBaseT PoE+, the device requires connection to equipment that has a corresponding HDBaseT

PoE+ PSE port. Connection to the included power pack is not required when PoDM+ or HDBaseT

PoE+ is used to power the device.

Any wiring that is connected to a PoDM+ or HDBaseT PoE+ PSE port is for intrabuilding use only and

should not be connected to a line that runs outside of the building in which the PSE is located.

NOTE: The LAN port can connect to an Ethernet switch only if the DM OUT port does not connect

to a DigitalMedia switcher.

For information about DM OUT and LAN connector wiring, refer to the following illustrations.

DM OUT Connector Wiring

LAN Connector Pin Assignments

DO Set the IP Address

The conguration of the transmitter within the DigitalMedia 8G+

® system determines how the IP

address of the transmitter is set:

• If the transmitter connects to a DigitalMedia switcher, the transmitter is congured by the

switcher automatically.

• If the transmitter connects to a DigitalMedia 8G+ receiver, the transmitter uses its own

conguration settings. By default, DHCP is enabled. If assignment of the default IP

address to the transmitter is desired, hold down the button while the unit boots up. SETUP

The default IP address overwrites the current setting. The default IP address of the

DM-TX-4KZ-202-C is 192.168.1.251. The default IP address of the DM-TX-4KZ-302-C is

192.168.1.252. To manually set a different IP address, use Crestron Toolbox™ software.

DO Learn More

Visit the website for additional information and the latest rmware

updates. To learn more about this product, use a QR reader

application on your mobile device to scan the QR image.

Crestron Electronics

15 Volvo Drive, Rockleigh, NJ 07647

888.CRESTRON | www.crestron.com

As of the date of manufacture, the product has been tested and found to comply with specications for CE marking.

This product is Listed to applicable UL

® Standards and requirements tested by Underwriters Laboratories Inc.

Ce produit est homologué selon les normes et les exigences UL applicables par Underwriters Laboratories Inc.

This unit is for indoor use only. It is not intended for outdoor use.

Cet appareil est réservé à une utilisation en intérieur. Il n’est pas destiné à une utilisation en extérieur.

Federal Communications Commission (FCC) Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

CAUTION: Changes or modications not expressly approved by the manufacturer responsible for compliance could void the

user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Industry Canada (IC) Compliance Statement

CAN ICES-3(B)/NMB-3(B)

The specic patents t hat cover Crestron products are listed at .www.crestron.com/legal/patents

The product warranty can be found at .www.crestron.com/legal/sales-terms-conditions-warranties

Certain Crestron products cont ain open source sof t ware. For specic informat ion, visit . www.crestron.com/legal/open-source-sof t ware

Crest ron, the Crestron logo, Crestron Toolbox, DigitalMedia, Digit alMedia 8G+, and DM are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United Stat es and/

or other count ries. HDBaseT and t he HDBaseT Alliance logo are either t rademarks or registered trademarks of t he HDBaseT Alliance in the United States and/or other countries. HDMI and the

HDMI logo are eit her trademarks or registered trademarks of HDMI Licensing LLC in the Unit ed States and/or other countries. UL and the UL logo are either trademarks or regist ered trademarks

of Underwriters Laboratories, Inc. in the United States and/or ot her countries. Ot her trademarks, registered trademarks, and trade names may be used in t his document to refer to either the

ent ities claiming t he marks and names or their products. Crest ron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in t ypography or

photography.