DBX 786 Manual

DBX Modtager 786

Læs gratis den danske manual til DBX 786 (16 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om DBX 786, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

Precision

Mic Preamp

786

Owner’s Manual

WARNING

FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, wash-

bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should

be taken so that objects do not fall and liquids are not spilled into the enclosure through open-

ings.

POWER SOURCES: The appliance should be connected to a power supply only of the type

described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polar-

ization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to

be walked on or pinched by items placed upon or against them, paying particular attention to

cords at plugs, convenience receptacles, and the point where they exit from the appliance.

SERVICING: To reduce the risk of re or electric shock, the user should not attempt to service

the appliance beyond that described in the operating instructions. All other servicing should be

referred to qualied service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE: Replace fuse

with same type and rating only.

MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a dierent line cord, attach-

ment plug, or both, depending on the available power source at installation. Connect this equip-

ment only to the power source indicated on the equipment rear panel. To reduce the risk of re

or electric shock, refer servicing to qualied service personnel or equivalent.

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The cores in the mains lead are coloured in accordance with the following code:

GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live

As colours of the cores in the mains lead of this appliance may not correspond with

the coloured markings identifying the terminals in your plug, proceed as follows:

• The core which is coloured green and yellow must be connected to the ter-

minal in the plug marked with the letter E, or with the earth symbol, or

coloured green, or green and yellow.

• The core which is coloured blue must be connected to the terminal marked

N or coloured black.

• The core which is coloured brown must be connected to the terminal

marked L or coloured red.

This equipment may require the use of a dierent line cord, attachment plug, or

both, depending on the available power source at installation. If the attachment

plug needs to be changed, refer servicing to qualied service personnel who

should refer to the table below. The green/yellow wire shall be connected direct-

ly to the unit's chassis.

WARNING: If the ground is defeated, certain fault conditions in the unit or in the

system to which it is connected can result in full line voltage between chassis and

earth ground. Severe injury or death can then result if the chassis and earth

ground are touched simultaneously.

LIVE

NEUTRAL

EARTH GND

CONDUCTOR

BROWN

BLUE

GREEN/YEL

BLACK

Normal Alt

WIRE COLOR

WHITE

GREEN

U.K. MAINS PLUG WARNING

moulded mains plug that has been cut o from the cord is unsafe. Discard

the mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUM-

STANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A

13 AMP POWER SOCKET. Do not use the mains plug without the fuse cover

in place. Replacement fuse covers can be obtained from your local retailer.

Replacement fuses are 13 amps and MUST be ASTA approved to BS1362.

The symbols shown above are internationally accepted symbols that warn of

potential hazards with electrical products. The lightning ash with arrowpoint in

an equilateral triangle means that there are dangerous voltages present within the

unit. The exclamation point in an equilateral triangle indicates that it is necessary

for the user to refer to the owner’s manual.

These symbols warn that there are no user serviceable parts inside the unit. Do

not open the unit. Do not attempt to service the unit yourself. Refer all servicing

to qualied personnel. Opening the chassis for any reason will void the manufac-

turer’s warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it o

immediately and take it to a dealer for service. Disconnect the unit during storms

to prevent damage.

C A U T I O N

A T T E N T I O N : R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R

W A R N I N G : T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C 

S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E

R I S K O F E L E C T R I C S H O C K 

D O N O T O P E N

ELECTROMAGNETIC COMPATIBILITY

This unit conforms to the Product Specications noted on the Declaration of Conformity.

Operation is subject to the following two conditions:

• this device may not cause harmful interference, and

• this device must accept any interference received, including interference that

may cause undesired operation.

Operation of this unit within signicant electromagnetic elds should be avoided.

• use only shielded interconnecting cables.

DECLARATION OF CONFORMITY

ManufacturerÕs Name: dbx Professional Products

ManufacturerÕs Address: 8760 S. Sandy Parkway

Sandy, Utah 84070, USA

declares that the product:

dbx 786

conforms to the following Product Specifications:

Safety: EN 60065 (1993)

IEC65 (1985) with Amendments 1, 2, 3

EMC: EN 55013 (1990)

EN 55020 (1991)

Supplementary Information:

The product herewith complies with the requirements of

the Low Voltage Directive 73/23/EEC and the EMC

Directive 89/336/EEC as amended by Directive

93/68/EEC.

dbx Professional Products

Vice-President of Engineering

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

January 19, 1998

European Contact: Your Local dbx Sales and Service Office or

International Sales Office

68 Sheila Lane

Valparaiso, Indiana

46383, USA

Tel: (219) 462-0938

Fax: (219) 462-4596

Produkt Specifikationer

Mærke:	DBX
Kategori:	Modtager
Model:	786

Har du brug for hjælp?

Hvis du har brug for hjælp til DBX 786 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager DBX Manualer

1 Juli 2025

15 August 2024

11 August 2024

11 August 2024

9 August 2024

8 August 2024

6 Juli 2023

22 Maj 2023

9 December 2022

Modtager Manualer

Nyeste Modtager Manualer

Musical Fidelity B1xi Manual

12 August 2025

Artsound MX60MKII Manual

12 August 2025

NAD CI 8-120 DSP V2 Manual

12 August 2025

NAD CI 8-150 DSP V2 Manual

12 August 2025

ESX Signum SX1000.1 Manual

12 August 2025

ESX Signum SX800.4 Manual

12 August 2025

ESX Signum SX800.2 Manual

12 August 2025

Mooer F15i Li Manual

12 August 2025

Yamaha MusicCast RX-S602 Manual

10 August 2025

Strong SRT 3032 Manual

10 August 2025