DBX 586 Manual

DBX Modtager 586

Læs gratis den danske manual til DBX 586 (16 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 75 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 38 anmeldelser. Har du et spørgsmål om DBX 586, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

Vacuum Tube

Preamplifier

558

886

OwnerÕs Manual

WARNING

FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, wash-

bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be

taken so that objects do not fall and liquids are not spilled into the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply only of the type

described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or

polarization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are not like-

ly to be walked on or pinched by items placed upon or against them, paying particular attention to

cords at plugs, convenience receptacles, and the point where they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to service the

appliance beyond that described in the operating instructions. All other servicing should be referred

to qualified service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLYACCESSIBLE FUSE RECEPTACLE:

Replace fuse with same type and rating only.

MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a different line cord,

attachment plug, or both, depending on the available power source at installation. Connect this equip-

ment only to the power source indicated on the equipment rear panel. To reduce the risk of fire or

electric shock, refer servicing to qualified service personnel or equivalent.

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH

A POWER CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The cores in the mains lead are coloured in accordance with the following

code:

GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live

As colours of the cores in the mains lead of this appliance may not corre-

spond with the coloured markings identifying the terminals in your plug,

proceed as follows:

¥ The core which is coloured green and yellow must be connected to

the terminal in the plug marked with the letter E, or with the earth

symbol, or coloured green, or green and yellow.

¥ The core which is coloured blue must be connected to the terminal

marked N or coloured black.

¥ The core which is coloured brown must be connected to the terminal

marked L or coloured red.

This equipment may require the use of a different line cord, attachment

plug, or both, depending on the available power source at installation. If the

attachment plug needs to be changed, refer servicing to qualified service

personnel who should refer to the table above. The green/yellow wire shall

be connected directly to the unit's chassis.

WARNING: If the ground is defeated, certain fault conditions in the unit or

in the system to which it is connected can result in full line voltage between

chassis and earth ground. Severe injury or death can then result if the chas-

sis and earth ground are touched simultaneously.

LIVE

NEUTRAL

EARTH GND

CONDUCTOR

BROWN

BLUE

GREEN/YEL

BLACK

Normal Alt

WIRE COLOR

WHITE

GREEN

U.K. MAINS PLUG WARNING

moulded mains plug that has been cut off from the cord is unsafe.

Discard the mains plug at a suitable disposal facility. NEVER UNDER

ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED

OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET. Do

not use the mains plug without the fuse cover in place. Replacement

fuse covers can be obtained from your local retailer. Replacement fuses

are 13 amps and MUST be ASTA approved to BS1362.

The symbols shown above are internationally accepted symbols that warn of

potential hazards with electrical products. The lightning flash with arrow-

point in an equilateral triangle means that there are dangerous voltages pre-

sent within the unit. The exclamation point in an equilateral triangle indi-

cates that it is necessary for the user to refer to the ownerÕs manual.

These symbols warn that there are no user serviceable parts inside the unit.

Do not open the unit. Do not attempt to service the unit yourself. Refer all

servicing to qualified personnel. Opening the chassis for any reason will

void the manufacturerÕs warranty. Do not get the unit wet. If liquid is

spilled on the unit, shut it off immediately and take it to a dealer for service.

Disconnect the unit during storms to prevent damage.

C A U T I O N

A T T E N T I O N : R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R

W A R N I N G : T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C 

S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E

R I S K O F E L E C T R I C S H O C K 

D O N O T O P E N

ELECTROMAGNETIC COMPATIBILITY

This unit conforms to the Product Specifications noted on the Declaration of

Conformity. Operation is subject to the following two conditions:

¥ this device may not cause harmful interference, and

¥ this device must accept any interference received, including interference

that may cause undesired operation.

Operation of this unit within significant electromagnetic fields should be avoided.

¥ use only shielded interconnecting cables.

DECLARATION OF CONFORMITY

ManufacturerÕs Name: dbx Professional Products

ManufacturerÕs Address: 8760 S. Sandy Parkway

Sandy, Utah 84070, USA

declares that the product:

dbx 586

conforms to the following Product Specifications:

Safety: EN 60065 (1993)

IEC65 (1985) with Amendments 1, 2, 3

EMC: EN 55013 (1990)

EN 55020 (1991)

Supplementary Information:

The product herewith complies with the requirements of

the Low Voltage Directive 73/23/EEC and the EMC

Directive 89/336/EEC as amended by Directive

93/68/EEC.

dbx Professional Products

Vice-President of Engineering

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

February 16, 1998

European Contact: Your Local dbx Sales and Service Office or

International Sales Office

68 Sheila Lane

Valparaiso, Indiana

46383, USA

Tel: (219) 462-0938

Fax: (219) 462-4596

Produkt Specifikationer

Mærke:	DBX
Kategori:	Modtager
Model:	586

Har du brug for hjælp?

Hvis du har brug for hjælp til DBX 586 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager DBX Manualer

1 Juli 2025

15 August 2024

11 August 2024

11 August 2024

9 August 2024

8 August 2024

6 Juli 2023

22 Maj 2023

9 December 2022

Modtager Manualer

Nyeste Modtager Manualer

CYP AU-A220 Manual

30 Juli 2025

Sirus I-Amp 8.150T Manual

30 Juli 2025

AER Colourizer 2 Manual

30 Juli 2025

Sirus I-Amp 1.300T Manual

30 Juli 2025

PAC AP4-FD32 Manual

30 Juli 2025

CYP PUV-1540S-RX Manual

30 Juli 2025

ART USB Dual Pre Manual

29 Juli 2025

SSL Pure Drive Quad Manual

29 Juli 2025

SSL Pure Drive Octo Manual

29 Juli 2025

CYP PUV-1550SRX Manual

29 Juli 2025