DBX MiniPre Manual

DBX Modtager MiniPre

Læs gratis den danske manual til DBX MiniPre (12 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om DBX MiniPre, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

Mini-Pre

User Manual

Vacuum Tube

Microphone PreAmp

WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING:

KEEP THESE INSTRUCTIONS

HEED ALL WARNINGS

FOLLOW ALL INSTRUCTIONS

CLEAN ONLY A WITH DAMP CLOTH.

DO NOT BLOCK ANY OF THE VENTILATION OPENINGS.

INSTALL ACTURERS IN ACCORDANCE WITH THE MANUF

INSTRUCTIONS.

DO NOT INSTALL ANY NEAR HEAT SOURCES SUCH AS RADI-

ATORS, HEAT REGISTERS, STOVES; OR OTHER APPARATUS

(INCLUDING AMPLIFIERS) THAT T.PRODUCE HEA

ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE

MANUFACTURER.

UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR

WHEN UNUSED FOR LONG PERIODS OF TIME.

WATER AND MOISTURE: Appliance should not be used

near water (e.g. near a bathtub, washbowl, kitchen sink,

laundry tub, in a wet basement, or near a swimming pool,

etc). Care should be taken so that objects do not fall and liq-

uids are not spilled into the enclosure through openings.

POWER SOURCES: The appliance should be connected to

a power supply only of the type described in the operating

instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be

taken so that the grounding or polarization means of an

appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should

be routed so that they are not likely to be walked on or

pinched by items placed upon or against them, paying par-

ticular attention to cords at plugs, convenience receptacles,

and the point where they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the

user should not attempt to service the appliance beyond that

described in the operating instructions. All other servicing

should be referred to qualified service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSI-

BLE FUSE RECEPTACLE: Replace fuse with same type

and rating only.

MULTIPLE-INPUT VOLTAGE: This equipment may require

the use of a different line cord, attachment plug, or both,

depending on the available power source at installation.

Connect this equipment only to the power source indicated

on the equipment rear panel. To reduce the risk of fire or

electric shock, refer servicing to qualified service personnel

or equivalent.

POWER ON / OFF SWITCH: The Power Switch used in this

piece of equipment DOES NOT break the connection from

the Mains.

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

CAUTION: EQUIPMENT IS NOTDISCONNECTED FROM MAINS WHEN SWITCH IS

IN THE OFF POSITION

The cores in the mains lead are coloured in accordance with the following code:

GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live

As colours of the cores in the mains lead of this appliance may not correspond with

the coloured markings identifying the terminals in your plug, proceed as follows:

• The core which is coloured green and yellow must be connected to the ter-

minal in the plug marked with the letter E, or with the earth symbol, or

coloured green, or green and yellow.

• The core which is coloured blue must be connected to the terminal marked

N or coloured black.

• The core which is coloured brown must be connected to the terminal marked

L or coloured red.

This equipment may require the use of a different line cord, attachment plug, or

both, depending on the available power source at installation. If the attachment plug

needs to be changed, refer servicing to qualified service personnel who should refer

to the table below. The green/yellow wire shall be connected directly to the units

chassis.

WARNING: If the ground is defeated, certain fault conditions in the unit

or in the system to which it is connected can result in full line voltage

between chassis and earth ground. Severe injury or death can then

result if the chassis and earth ground are touched simultaneously.

LIVE

NEUTRAL

EARTH GND

CONDUCTOR

BROWN

BLUE

GREEN/YEL

BLACK

Normal Alt

WIRE COLOR

WHITE

GREEN

The symbols shown above are internationally accepted sym-

bols that warn of potential hazards with electrical products.

The lightning flash with arrowpoint in an equilateral triangle

means that there are dangerous voltages present within the

unit. The exclamation point in an equilateral triangle indi-

cates that it is necessary for the user to refer to the owner’s

manual.

These symbols warn that there are no user serviceable parts

inside the unit. Do not open the unit. Do not attempt to serv-

ice the unit yourself. Refer all servicing to qualified person-

nel. Opening the chassis for any reason will void the manu-

facturer’s warranty. Do not get the unit wet. If liquid is

spilled on the unit, shut it off immediately and take it to a

dealer for service. Disconnect the unit during storms to pre-

vent damage.

C A U T I O N

A T T E N T I O N :

R I S Q U E D E C HO C E L E C T R I Q U E - N E PA S O U VR I R

W A R N I N G :

TO R E D U C E TH E R I SK OF F I RE O R E L E CT R I C

S H O CK D O N O T E X PO S E T H I S E Q UI PM E NT T O R AI N O R MO IS T U R E

R I S K O F EL E CT R I C S H O C K

D O N O T O P EN

IMPORTANT SAFETY INSTRUCTIONS

Produkt Specifikationer

Mærke:	DBX
Kategori:	Modtager
Model:	MiniPre

Har du brug for hjælp?

Hvis du har brug for hjælp til DBX MiniPre stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Modtager DBX Manualer

15 August 2024

11 August 2024

11 August 2024

9 August 2024

8 August 2024

6 Juli 2023

22 Maj 2023

9 December 2022

Modtager Manualer

Nyeste Modtager Manualer

DS18 GEN-X G8400.4D Manual

17 Juni 2025

Hifonics Zeus Expansion ZXR750/1E Manual

17 Juni 2025

Futaba R7206 SB Manual

16 Juni 2025

DS18 FRP-3.5K Manual

16 Juni 2025

DS18 SMD-300.4AB Manual

16 Juni 2025

DS18 SMD-3000.1D Manual

16 Juni 2025

DS18 GEN-X G3600.1D Manual

16 Juni 2025

DS18 HYDRO NXL-X1000.1D Manual

16 Juni 2025

DS18 SMD-200.4AB Manual

16 Juni 2025

DS18 GEN-X G1000.4D Manual

16 Juni 2025