- FCC COMPLIANCE -
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation. If the device is not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications and void
the user's authority to guarantee the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
2880 SUPER MULTI-TRACK LOOPER
Foot Controller
- DESCRIPTION -
Congratulations on your purchase of the Electro-Harmonix remote Foot
Controller accessory that was designed work with the 2880 Super Multi-
track Looper! The Foot Controller allows you to use your 2880 remotely,
with your feet! The perfect performance pedal giving you total hands free
control as you play. It gives you foot access to the following switches: Track
select, New Loop, Record, Play, Octave and Reverse.
- SETUP -
To properly setup the Foot Controller with a 2880 you will need one standard
guitar cable with a ¼” plug on each end:
Plug one end of the guitar cable into the 2880 Footswitch jack.
Plug the other end of the guitar cable into the Foot Controller’s jack.
Upon connecting the 2880 Foot Controller to the main unit, all 6 LEDs (on
the FC) will light briefly for 1 second.
- CONTROLS -
The following descriptions detail the functions of all of the Footswitches and
LEDs (lights) on the 2880 Foot Controller. All 6 switches and LEDs on the
Foot Controller duplicate the switches and LEDs on the 2880 with the same
name.
Important: The Electro-Harmonix Foot Controller obtains all of its power
from the 2880 Super Multi-track Looper. Use only a standard ¼” guitar cable
to connect the Foot Controller to the 2880. A standard guitar cable has Tip
and Sleeve conductors. The Foot Controller does not require batteries or an
AC Adapter.
