Electro Harmonix Cock Fight Manual


Læs gratis den danske manual til Electro Harmonix Cock Fight (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Electro Harmonix Cock Fight, eller vil du spørge andre brugere om produktet?

Side 1/4
1
Cock Fight
Cocked Talking Wah with Fuzz
Congratulations on your purchase of the Electro-Harmonix , a dual-Cock Fight
filter fuzz box. The contains two different expressive filters: a Cock Fight
traditional wah pedal filter CRY, and a formant filter TALK used for vowel sounds.
The also has a fuzz section that can be added before or after the Cock Fight
filter section, or taken out of the signal path. The BOTTOM and BIAS controls
allow additional tone shaping possibilities. Connect an expression pedal or a
control voltage to the expression input jack for even more sound control.
WARNING: Your Cock Fight comes equipped with an Electro-Harmonix 9.6DC-200BI
power supply (same as used by Boss®
& Ibanez®: 9.6 Volts DC 200mA). The Cock Fight
requires mA at 9VDC with a center negative plug. Using the wrong adapter or a plug 40
with the wrong polarity may damage your Cock Fight and void the warranty.
-QUICK SETUP-
Connect the output plug of the supplied power adapter to the 9V power jack.
Plug your instrument in the INPUT jack; connect your amp to the OUTPUT jack.
Set VOL to about three o’clock, FREQ to max, BOTTOM to min, left switch to
CRY, and right switch to FUZZ OFF. Press the footswitch so that the LED light is
lit. With the effect turned on, you will hear a slight boost in volume as well as a
brighter sound. Adjust the FREQ knob to dial in the cocked wah sound to your
taste. Connect an optional expression pedal to vary the frequency of the filter
continuously as you would with a traditional wah pedal.
- CONTROLS -
VOL Knob Use this knob to adjust the master output volume.
FREQ Knob Use to adjust the frequency of the filter selected by the CRY/TALK
toggle switch.
TONE Knob Use to blend between a darker fuzz and brighter fuzz sound.
DRIVE Knob Adjust to set the amount of fuzz.
BOTTOM Knob BOTTOM is a low frequency boost control that is slightly
above unity gain when set fully clockwise. Set fully counterclockwise to remove
the BOTTOM circuit from the signal path. TIP: When used with a bass guitar or
other low frequency sources, the BOTTOM adjustment can help retain the
bottom end typically lost with most wah pedals.
2
CRY/TALK Toggle Switch The UP position selects the CRY setting. CRY
simulates the type of filter found in a typical wah pedal circuit. The DOWN
position selects the TALK setting. This setting as its name implies produces — —
throaty/vocal vowel sounds.
PRE/FUZZ OFF/POST Toggle Switch The PRE position places the fuzz
before the filter. Use this position for a vintage Hendrix vibe. FUZZ OFF removes
the fuzz from the signal path. The POST position places the fuzz after the filter
and yields a more modern sound.
BIAS Knob This knob controls the amount of bias voltage supplied to one of
the transistors in the fuzz circuit. Turn the BIAS knob fully clockwise to supply a
nominal voltage and create a normal fuzz sound. Turn the bias control down
(counterclockwise) to decrease the bias voltage to get the “dying battery” sound.
This type of sound is characterized by a decrease in sustain and by notes that
get choked off you play with less force as .
Footswitch & Status LED The Footswitch toggles between effect and
buffered bypass. The status LED lights when in effect mode.
INPUT Jack – This ¼” jack is the audio input for the Cock Fight.
OUTPUT Jack – This ¼” jack is the audio output for the Cock Fight.
EXP Jack The expression/CV input controls the frequency knob. The position
of the FREQ knob sets the maximum sweep range of the expression/CV input.
Expression input jack accepts a TRS expression pedal connector or a Tip-Sleeve
0-5V control voltage input. The expression pedal should ideally use a 10k
potentiometer with linear taper. It must have the wiper connected to TIP and
toe-down connected to RING. Some manufacturers do not conform to pedals
this convention and require a special cable/adaptor to swap RING and TIP.
Suggested Expression Pedals: EHX Expression Pedal, M-Audio® -P, MoogEX ® EP-
2 & EP-3, Roland® -5 or BossEV ® -500L. FV
- CHANGING THE BATTERY -
To change your 9-volt battery, you must remove the 4 screws on the bottom of
the Cock Fight. Once the screws are removed, take off the bottom plate and
change the battery. Please do not We recommend alkaline batteries9V .
touch the circuit board while the bottom plate is off or you risk damaging a
component.
FUZZ ON/OFF Switch On the PCB there is a small DIP switch that changes
FUZZ OFF to FUZZ THROUGH mode. In FUZZ THROUGH mode the filter section
is bypassed and removed from the signal path. In this mode the knobs FREQ,
BOTTOM and switch CRY/TALK have no effect on the sound.


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: Cock Fight

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Cock Fight stil et spørgsmål nedenfor, og andre brugere vil svare dig