Electro Harmonix Germanium OD Manual


Læs gratis den danske manual til Electro Harmonix Germanium OD (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Electro Harmonix Germanium OD, eller vil du spørge andre brugere om produktet?

Side 1/3
GERMANIUM OD
Vintage Overdrive
The Electro-Harmonix GERMANIUM OD is a classic 1960’s overdrive based around a hand
selected germanium transistor. To get the best results from it please set aside some time to
practice in a quiet room…just you, your amp, and the Germaium OD. The interaction of each
control will reward you with many different flavors of exceptional vintage overdrive.
-CONTROLS-
GAIN CONTROL
Adjusts the amount of input signal that is fed to the GERMANIUM OD. The
more the knob is rotated the harder the Germanium transistor and drive components are hit.
BIAS CONTROL
Adjusts the current gain that is sent to the Germanium transistor. It works
together with the voltage control to attain the over all tone. The bias control works specically with
the Germanium transistor.
VOLTS CONTROL
Allows the user to control the amount of voltage that is applied to the
GERMANIUM OD. When the knob is set at full, 9volts is applied. When set at minimum 3 volts of
current is applied By limiting the volts applied to the pedal a number of interesting saturations can be
set up for variations in tone.
STATUS LED
When the LED is lit; the GERMANIUM OD effect is active. When the LED is off,
the Germanium OD is in True Bypass Mode. The footswitch engages/disengages the eect.
INPUT Jack
Connect your instrument to the input jack. The input impedance presented at the input
jack is high.
OUTPUT Jack
Connect this jack to your amplier. This is the GERMANIUM OD output. This
jack is connected directly to the Input Jack.
Footswitch
--
True Bypass on and off.
9V Power Jack The
GERMANIUM OD
can run o of a 9V battery or you can
connect a 9VDC battery eliminator capable of delivering at least 100mA to the 9V
power jack. The optional 9V power supply from Electro-Harmonix is 9.6DC-200BI
(same as used by Boss™ & Ibanez™) 9.6 Volts DC 200mA. The battery eliminator
must have a barrel connector with center negative. The battery may be left in or
taken out when using an eliminator.
-OPERATING INSTRUCTIONS and HINTS-
The BIAS KNOB: Experiment with this control. You will notice dierences in reaction
as the current to the Germanium transistor varies.
The VOLTS KNOB should normally be set to 9 volts but as you back off between 3 o’ clock and 9
‘o’ clock you are lowering the number of volts applied to the germanium transistor. Totally dierent
reactions in the sound can be obtained.
The GAIN KNOB is the master output volume for the GERMANIUM OD.
- POWER -
Plugging into the INPUT jack activates power from the internal 9-volt battery. The input cable should
be removed when the unit is not in use to avoid running down the battery. If a battery eliminator is
used, the Germanium OD will be powered as long as a wall-wart is plugged into the wall.
To change the 9-volt battery, you must remove the 4 screws on the bottom of the Germanium OD.
Once the screws are removed, you can take o
the bottom plate and change the battery. Please
do not touch the circuit board while the bottom plate is off or you risk damaging a
component
.


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: Germanium OD

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Germanium OD stil et spørgsmål nedenfor, og andre brugere vil svare dig