Electro Harmonix HOLIEST GRAIL Manual

Electro Harmonix Ikke kategoriseret HOLIEST GRAIL

Læs gratis den danske manual til Electro Harmonix HOLIEST GRAIL (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Electro Harmonix HOLIEST GRAIL, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

HOLIEST GRAIL

- DESCRIPTION -

The Holiest Grail is built around a high quality stereo reverb algorithm coupled with a

painstakingly developed simulation of spring reverb as found in guitar amps and dedicated

reverb tanks. The decay time, damping and diffusion parameters of the reverb can be

freely tweaked to design an infinite array of natural and unnatural sounding spaces. A

versatile pre-delay can be applied to the reverb, and a feedback control has been added to

the pre-delay to provide even greater sound-sculpting capabilities for spatial simulation

and/or experimentation.

As an aid to both live performance and recording, the box is able to store 8 user presets

and can be remotely controlled via MIDI. A standard expression footpedal can be used to

control the amount of signal sent to the reverb, a performance tool that can help

personalize the sound.

- CONTROLS/INDICATORS -

INPUT

--------------------------------------------------------------------------------------------

INPUT GAIN Slider –

A control for setting optimal analog signal level into the A/D

Converter. The green LED lights when there is sufficient level. The red LED will light when

clipping occurs.

The position of the INPUT GAIN Slider is not saved with the user

presets.

WARNING: Use only the 9VDC/500mA AC adapter the Holiest Grail comes

supplied with. Do not use any other AC adapters. Using other AC adapters, even

those made by Electro-Harmonix, could cause harm to the unit, the adapter or you.

The Holiest Grail does not use batteries.

Signal LED

– Green LED above INPUT GAIN Slider. The Signal LED varies in brightness

depending on the strength of the input signal. The louder the signal the brighter this LED

will be.

Clip LED

– Red LED above INPUT GAIN Slider. The Clip LED lights when the signal clips

the A/D Converter. Ideally you want the largest possible signal entering the A/D Converter

without clipping. One way to achieve the ideal signal level is to raise the INPUT GAIN Slider

until the CLIP LED starts to blink and then lower the INPUT GAIN Slider slowly until the

CLIP LED stops lighting.

REVERB Design

------------------------------------------------------------------------------------------------------------

Pre-delay Controls

TIME Slider –

Controls the length of time between striking a note on your

instrument and the start of the reverb. For maximum usability, the slider has

two ranges of usage: between 0% and 50%, the predelay time can be adjusted

from 0 to 100 ms with an accuracy of approximately 1.5 ms. From 50% to

100%, the time ranges from 100ms to 440ms in 5 ms increments.

FEEDBACK Slider –

Controls the amount of feedback that is re-circulated in the

pre-delay before the reverb. At its maximum setting an infinite loop will be

created. At the lowest level the pre-delay simply delays the sound of the reverb

without any special effects. When the FEEDBACK Slider is set somewhere in the

middle, your original note will enter the Reverb a number of times.

Reverb Controls

DECAY Slider –

Controls the length of the reverb time. This affects the

apparent size of space. At maximum setting an infinite reverb may occur,

depending on the other settings.

DAMPING Slider

– Affects the frequency response of the reverb over time. A

setting of 0% has more damping and thus the reverb is muted. As the slider is

pushed up, the reverb sounds more bright and ‘open’. Higher settings (less

damping) also yield a longer reverb time.

DIFFUSION Slider

– Works in conjunction with the other parameters to

provide a density control to make subtle variations in the quality of the reverb

Produkt Specifikationer

Mærke:	Electro Harmonix
Kategori:	Ikke kategoriseret
Model:	HOLIEST GRAIL

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix HOLIEST GRAIL stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Electro Harmonix Manualer

Electro Harmonix Holy Grail Neo Manual

5 August 2025

Electro Harmonix Pico Rerun Manual

5 August 2025

Electro Harmonix Oceans 11 Reverb Manual

5 August 2025

Electro Harmonix Envelope Filter Manual

5 August 2025

Electro Harmonix 9DC-100 Manual

30 Juli 2025

Electro Harmonix C9 Manual

30 Juli 2025

Electro Harmonix EU12AC-1000 Manual

30 Juli 2025

Electro Harmonix Nano Deluxe Memory Man Manual

30 Juli 2025

Electro Harmonix 40DC-100 Manual

30 Juli 2025

Electro Harmonix Big Muff Pi w. Tone Wicker Manual

30 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Aqua-Vu Micro Stealth 4.3 Manual

20 August 2025

OnTruss EventBoard C90I BASIC Manual

20 August 2025

Tefal Quickchef HB672B Manual

20 August 2025

Gravity XW GLOVE Manual

20 August 2025

Roland V-4CF Manual

20 August 2025

Tefal Uno M FF133D Manual

20 August 2025

LD Systems MAUI 5 GO 100 BC W Manual

20 August 2025

Moulinex Bake Partner QA523B Manual

19 August 2025

Uniprodo UNICLEAN 142B Manual

19 August 2025

Tefal Body Partner LL9503 Manual

19 August 2025