Electro Harmonix Next Step Crying Bass Manual

Electro Harmonix Ikke kategoriseret Next Step Crying Bass

Læs gratis den danske manual til Electro Harmonix Next Step Crying Bass (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Electro Harmonix Next Step Crying Bass, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

CRYING BASS

WAH/FUZZ PEDAL FOR BASS

Congratulations on your purchase of the Electro-Harmonix a wah Crying Bass:

pedal, with fuzz, designed specifically for bass! The sweeps the wah Crying Bass

filter without using any moving parts: it does not use a potentiometer, optics or

magnetism. The result is a responsive pedal that allows precise control over a

brilliantly fluid wah. The Crying Bass also includes a fuzz circuit to add extra

harmonics to your bass sound, giving the wah filter more frequencies to chew on, as

well as a fixed low pass filter (LPF) for extra low end.

GETTING STARTED

Plug your guitar into the INPUT jack; connect your amp to the OUTPUT jack. Within

seconds the EHX logo in the center of the pedal will light. Your Crying Bass is ready

to go! Please note: as long as a plug is inserted into the INPUT jack, a drain is placed

on the 9V battery inside the Crying Bass. It is recommended that you disconnect the

INPUT jack when the Crying Bass is not in use to extend battery life.

FUZZ Control

The fuzz in the Crying Bass helps to accentuate the wah effect, adding distortion and

harmonics to your bass notes. The FUZZ dial located on the INPUT side of the Crying

Bass is a blend control for the fuzz circuit. As the numbers increase on the dial, the

volume of the fuzz effect increases while the dry volume decreases. The maximum

setting of 10 should yield a volume boost as compared to your bypass volume.

LPF VOL Control

The Crying Bass includes a 2nd-Order Low Pass Filter (LPF) fixed at 194 Hz for adding

more bottom end to the wah effect. Dial-in just the right amount of LPF by using the

LPF VOL control located near the INPUT jack. The volume of the LPF increases as the

numbers increase on the dial. The LPF is muted when set to 0. The maximum setting

of 10 should yield a low end boost as compared to your bypass volume.

CALIBRATION

To ensure the Crying Bass responds to its full sweep range, it may be necessary to

calibrate the sweep of the Crying Bass when it is used on a different surface since its

last use. It is particularly important to calibrate if the Crying Bass is used on a slanted

surface. We recommend calibrating the Crying Bass after unwrapping it from its

packaging, during your first use of the pedal.

CALIBRATION PROCEDURE

1. Place the pedal on the surface where it will be used.

2. Ensure the Crying Bass is sitting flat on the surface then press and release

the CALIBRATE button once; the EHX logo begins to blink indicating the toe

position has been saved.

3. While the EHX logo continues to blink, rock the pedal all the way back to the

extreme heel position and hold it there.

4. Press and release the CALIBRATE button once more.

5. The EHX logo will stop blinking to indicate that the heel position has been

saved.

If you accidentally press the CALIBRATE button and the EHX logo blinks, do not press

CALIBRATE again. After approximately 7 seconds, the Crying Bass will stop blinking

and ignore the button press.

ENTERING/EXITING BYPASS

Toggle between and effect mode by tipping the Crying Bass buffered bypass

forward, in the toe direction, past the flat position of the Crying Bass. You do not

need to tip the Crying Bass all the way forward; 25% of the total forward travel will

do it. The Crying Bass needs to return to its flat position before you can toggle

between bypass and effect mode again.

When the Crying Bass is in effect mode, the EHX logo in the center of the pedal will

light up. In bypass mode, the logo does not light.

POWER

Plugging into the INPUT jack activates power from the internal 9 Volt battery. The

input cable should be removed when the unit is not in use to avoid running down the

battery. If an AC Adapter is used, the Crying Bass will be powered up as long as the

AC Adapter is correctly plugged in.

The Crying Bass’s power jack is located on the same side as the OUTPUT jack. A 9

Volt AC Adapter capable of delivering at least 50 mA of current is required to power

the Crying Bass. The inner ring of the 9 Volt AC Adapter must be negative, the outer

ring positive. The optional 9V power supply from Electro-Harmonix is 9.6DC-200BI

(same as used by Boss® & Ibanez®) 9.6 Volts DC/200mA. The unit’s battery may be

left in or taken out when the AC Adapter is in use. The actual current draw of the

Crying Bass is 18 mA.

Produkt Specifikationer

Mærke:	Electro Harmonix
Kategori:	Ikke kategoriseret
Model:	Next Step Crying Bass

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Next Step Crying Bass stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Electro Harmonix Manualer

Electro Harmonix Holy Grail Neo Manual

5 August 2025

Electro Harmonix Pico Rerun Manual

5 August 2025

Electro Harmonix Oceans 11 Reverb Manual

5 August 2025

Electro Harmonix Envelope Filter Manual

5 August 2025

Electro Harmonix 9DC-100 Manual

30 Juli 2025

Electro Harmonix C9 Manual

30 Juli 2025

Electro Harmonix EU12AC-1000 Manual

30 Juli 2025

Electro Harmonix Nano Deluxe Memory Man Manual

30 Juli 2025

Electro Harmonix 40DC-100 Manual

30 Juli 2025

Electro Harmonix Big Muff Pi w. Tone Wicker Manual

30 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Aqua-Vu Micro Stealth 4.3 Manual

20 August 2025

OnTruss EventBoard C90I BASIC Manual

20 August 2025

Tefal Quickchef HB672B Manual

20 August 2025

Gravity XW GLOVE Manual

20 August 2025

Roland V-4CF Manual

20 August 2025

Tefal Uno M FF133D Manual

20 August 2025

LD Systems MAUI 5 GO 100 BC W Manual

20 August 2025

Moulinex Bake Partner QA523B Manual

19 August 2025

Uniprodo UNICLEAN 142B Manual

19 August 2025

Tefal Body Partner LL9503 Manual

19 August 2025