Electro Harmonix Next Step Talking Pedal Manual

Electro Harmonix Ikke kategoriseret Next Step Talking Pedal

Læs gratis den danske manual til Electro Harmonix Next Step Talking Pedal (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Electro Harmonix Next Step Talking Pedal, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

TALKING PEDAL

VOWEL WAH WITH FUZZ

Congratulations on your purchase of the Electro-Harmonix TALKING PEDAL

from our ground-breaking NEXT STEP series! The has no TALKING PEDAL

moving parts: it does not use a potentiometer, optics or magnetism to sweep

its dual-bandpass analog filters. The result is a responsive pedal that allows

precise control over the throaty vocal effect of the TALKING PEDAL.

Additionally, a level controllable fuzz circuit is included to add extra growl to

your vowels.

GETTING STARTED

Plug your guitar into the INPUT jack; connect your amp to the OUTPUT jack.

Within seconds the EHX logo in the center of the pedal will light. Your

TALKING PEDAL is ready to go! as long as a plug is inserted Please note:

into the INPUT jack, a drain is placed on the 9V battery inside the TALKING

PEDAL. We recommend unplugging the INPUT jack when the TALKING

PEDAL is not in use to extend battery life.

FUZZ LEVEL Control

The fuzz in the TALKING PEDAL helps to accentuate the vocal effect,

bringing out a more distinct talking quality in the pedal. You do not need to

maximize the FUZZ LEVEL in order to hear a more talkative effect, a little can

go a long way.

The FUZZ LEVEL dial located on the INPUT side of the TALKING PEDAL is a

blend control for the fuzz circuit. As the numbers increase on the dial, the

volume of the fuzz effect increases. The maximum setting of 10 should yield

a bit of volume boost as compared to your bypass volume.

CALIBRATION

To ensure the TALKING PEDAL responds to its full sweep range, it may be

necessary to calibrate the sweep of the TALKING PEDAL when it is used on a

different surface since its last use. It is particularly important to calibrate if

the TALKING PEDAL is used on a slanted surface. We also recommend

calibrating the TALKING PEDAL during your first use of the pedal.

CALIBRATION PROCEDURE

1. Place the pedal on the surface where it will be used.

2. Ensure the TALKING PEDAL is sitting flat on the surface then press

and release the CALIBRATE button once; the EHX logo begins to

blink indicating the Toe position has been saved.

3. While the EHX logo continues to blink, rock the pedal all the way

back to the extreme Heel position and hold it there.

4. Press and release the CALIBRATE button once more.

5. The EHX logo will stop blinking to indicate that the Heel position has

been saved.

If you accidentally press the CALIBRATE button and the EHX logo blinks, do

not press CALIBRATE again. After approximately 7 seconds, the TALKING

PEDAL will stop blinking and ignore the button press.

ENTERING/EXITING BYPASS

Toggle between and effect mode by tipping the TALKING buffered bypass

PEDAL forward, in the toe direction, past the flat position of the TALKING

PEDAL. You do not need to tip the TALKING PEDAL all the way forward;

25% of the total forward travel will do it. The TALKING PEDAL needs to

return to its flat position before you can toggle between bypass and effect

mode again.

When the TALKING PEDAL is in effect mode, the EHX logo in the center of

the pedal will light up. In bypass mode, the logo does not light.

POWER

Plugging into the INPUT jack activates power from the internal 9 Volt

battery. The input cable should be removed when the unit is not in use to

avoid running down the battery. If an AC Adapter is used, the TALKING

PEDAL will be powered up as long as the AC Adapter is correctly plugged in.

The TALKING PEDAL’s power jack is located on the same side as the

OUTPUT jack. A 9 Volt AC Adapter capable of delivering at least 25mA of

current at 9VDC is required to power the TALKING PEDAL. The inner ring of

the 9 Volt AC Adapter must be negative, the outer ring positive. The optional

Produkt Specifikationer

Mærke:	Electro Harmonix
Kategori:	Ikke kategoriseret
Model:	Next Step Talking Pedal

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Next Step Talking Pedal stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Electro Harmonix Manualer

Electro Harmonix Holy Grail Neo Manual

5 August 2025

Electro Harmonix Pico Rerun Manual

5 August 2025

Electro Harmonix Oceans 11 Reverb Manual

5 August 2025

Electro Harmonix Envelope Filter Manual

5 August 2025

Electro Harmonix 9DC-100 Manual

30 Juli 2025

Electro Harmonix C9 Manual

30 Juli 2025

Electro Harmonix EU12AC-1000 Manual

30 Juli 2025

Electro Harmonix Nano Deluxe Memory Man Manual

30 Juli 2025

Electro Harmonix 40DC-100 Manual

30 Juli 2025

Electro Harmonix Big Muff Pi w. Tone Wicker Manual

30 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Aqua-Vu Micro Stealth 4.3 Manual

20 August 2025

OnTruss EventBoard C90I BASIC Manual

20 August 2025

Tefal Quickchef HB672B Manual

20 August 2025

Gravity XW GLOVE Manual

20 August 2025

Roland V-4CF Manual

20 August 2025

Tefal Uno M FF133D Manual

20 August 2025

LD Systems MAUI 5 GO 100 BC W Manual

20 August 2025

Moulinex Bake Partner QA523B Manual

19 August 2025

Uniprodo UNICLEAN 142B Manual

19 August 2025

Tefal Body Partner LL9503 Manual

19 August 2025